scholarly journals Effect of grain size changes on corrosion behavior of copper produced by accumulative roll bonding process

2013 ◽  
Vol 16 (6) ◽  
pp. 1379-1386 ◽  
Author(s):  
A. Nikfahm ◽  
I. Danaee ◽  
A. Ashrafi ◽  
M.R. Toroghinejad
Keyword(s):  
Grain Size ◽  
Corrosion Behavior ◽  
Accumulative Roll Bonding ◽  
Bonding Process ◽  
Accumulative Roll Bonding Process ◽  
Roll Bonding

Fabrication of Ultrafine Grained Copper Alloy by 3-Layers Accumulative Roll-Bonding Process

2010 ◽  
Vol 443 ◽  
pp. 158-163
Author(s):  
Cha Yong Lim ◽  
Hyoung Wook Kim ◽  
Seong Hee Lee
Keyword(s):  
Grain Size ◽  
Accumulative Roll Bonding ◽  
Copper Alloy ◽  
Electron Back Scatter Diffraction ◽  
Bonding Process ◽  
Accumulative Roll Bonding Process ◽  
Roll Bonding ◽  
Ultrafine Grains ◽  
Transmission Electron ◽  
Average Grain Size

The 3-layers accumulative roll bonding process (ARB) has been attempted to increase the strength of copper alloy (Cu-0.02wt.%P) by refining grain size. The 3-layers accumulative roll bonding was conducted up to 7 cycles at room temperature without lubrication. Microstructural evolution of the copper alloy with the number of the 3-layers ARB cycles was investigated by optical microscopy (OM), transmission electron microscopy (TEM), and electron back scatter diffraction (EBSD). The average grain size has been refined from 20 μm before ARB to 170 nm after 7 cycles of 3-layers ARB. More than 70% of ultrafine grains formed by 3-layers ARB were composed of high angle grain boundaries. The average misorientation angle of ultrafine grains was 30.7 degrees in the center of the specimen. Tensile strength after 7 cycles of 3-layers ARB was 605 MPa, which is about 3.2 times higher than the initial value.

Sign in / Sign up

Export Citation Format

Share Document