scholarly journals Isothermal oxidation behavior of electrospark deposited NiCrAlY coatings on a Ni-based single-crystal superalloy

2019 ◽  
Vol 53 (3) ◽  
pp. 389-394
Author(s):  
C. Guo ◽  
T. Liang ◽  
F. Lu ◽  
Z. Liang ◽  
S. Zhao ◽  
...  
2020 ◽  
Author(s):  
Zihan Zhao ◽  
Kai Guan ◽  
Renjie Cui ◽  
Jianchao Qin ◽  
Zhaohui Huang

Abstract The effect of Y addition on the oxidation behavior of a Ni-based directionally solidified single crystal superalloy was investigated. Isothermal oxidation test for the samples with different-level Y addition was conducted at 1100℃ in air. The Y content of the samples was demarcated by the actual pickup amount resulted from ICP-AES test. It was found that the addition of Y increased the oxide resistance by an adhesive double-layer oxide scale which was composed of Al2O3 and spinel Ni(Cr,Al)2O4. With 70ppm Y addition, the oxidation weight gain was decreased from 12.6g/m2 for the alloy without Y addition to 5.3g/m2, and the oxidation rate was significantly decreased. Besides, the internal nitride also disappeared after Y doping because of the increasing oxidation scale adherence and the decreasing of oxidation products. In this study, 660ppm Y addition alloy showed the best oxidation resistance.


Rare Metals ◽  
2016 ◽  
Vol 36 (8) ◽  
pp. 617-621 ◽  
Author(s):  
Xue-Feng Zhou ◽  
Guang Chen ◽  
Ya-Ya Feng ◽  
Zhi-Xiang Qi ◽  
Min-Zhi Wang ◽  
...  

2021 ◽  
pp. 109737
Author(s):  
Hai-Qing Pei ◽  
Meng Li ◽  
Ping Wang ◽  
Xiao-Hu Yao ◽  
Zhi-Xun Wen ◽  
...  

Author(s):  
Megan Walker ◽  
Xiao Huang

In this study, single crystal superalloy René N5 was exposed in air at 1150 °C for up to 16 hours to evaluate the alloy’s short-term oxidation behaviour and the potential for developing a no-bond coat TBC system. The results showed that after 1 hour of exposure, a three layered oxide developed on the surface, consisting of spinel, Ta-containing oxide and alumina just above the substrate. After 4 hours of exposure, oxide spallation occurred; this became more pronounced after 16 hours. The oxide spallation took place between the top spinel layer and alumina layer, where Ta-rich oxide was more abundant. All samples tested for 0.5, 1, 2, 4 and 16 hours developed alumina near the substrate while the occurrence of NiO, spinel and Ta-oxides varied, depending upon the exposure time.


2014 ◽  
Vol 915-916 ◽  
pp. 562-566 ◽  
Author(s):  
Z.X. Shi ◽  
Shi Zhong Liu ◽  
M. Han ◽  
J.R. Li

The specimens of single crystal superalloy DD6 with 0.10% Hf and 0.47% Hf were prepared in the directionally solidified furnace. The effect of Hf content on the isothermal oxidation resistance of the second generation single crystal superalloy DD6 was studied at 1000°Cin ambient atmosphere. Morphology of oxides was examined by SEM, and their composition was analyzed by XRD and EDS. The experimental results show that the oxidation resistance of DD6 alloy with 0.47% Hf is better than that of the alloy with 0.10% Hf. The alloy with different Hf content all obeys parabolic rate law during oxidation for 100h at 1000°C. The increase of Hf content can promote the Al2O3 formation and decreases the proportion of NiO. The oxide grain size and the thickness of the oxide layer all reduce with increasing of Hf content. The oxide scale of the alloy with different Hf content is made up of an outer NiO layer with a small amount of Co3O4, inner Al2O3 and Cr2O3 layer with a small amount of TaO2.


Author(s):  
Jieying Bai ◽  
Jianhao Wu ◽  
Shuhua Xu ◽  
Yanling Pei ◽  
Lu Qin ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document