Abstract
Biogenic gas resources have gathered importance recently due to its widespread availability, occurrence at geologically predictable circumstances, and existence at shallow depths. It is estimated that biogenic gas forms more than 20% of the global discovered reserves. However, the exploration and development of these unconventional resources come with numerous drilling and reservoir challenges. This paper showcases a novel approach used in the United Arab Emirates to overcome these challenges using managed pressure and underbalanced drilling.
To tackle both reservoir and drilling challenges, a hybrid solution combining Underbalanced (UBD) and Managed Pressure Drilling (MPD) was applied. UBD was used to characterize the reservoir in terms of pressure and productivity index to ultimately enhance productivity by eliminating formation damage. MPD was used next to continue drilling through the problematic zone which had high instability due to the presence of highly sensitive salt, in addition to the presence of high pressure and loss zones. The fit for purpose hybrid application design allowed the operator to immediately switch between UBD and MPD conditions, as the well required with the same equipment.
Three of the four targeted formations were in the 8 ½″ hole section, UBD was selected to drill the first reservoir formation which allowed pore pressure verification and avoided using excessive mud weight that was the culprit of many challenges like slow ROP, drilling fluid losses, bit balling, and fracking the formations. UBD has proved that mud weight can be reduced by 20%-30% comparing to conventional drilling. The second formation was a salt formation that has caused previously hole collapse and losses-kicks problems as heavy mud used to drill this salty formation. MPD used successfully drill this section by constant bottom hole pressure and lower mud weight as it was found from analyzing offset wells reports that hole collapse occurred at connections and pump off events. Constant Bottom Hole Pressure (CBHP) also eliminated tight spots and excessive reaming resulting in optimized drilling. The third formation used MPD as well to minimize overbalance pressure over previous sections while the fourth formation was drilled by UBD as it had a separate 6″ hole section as it formed an independent reservoir.
The combined MPD and UBD approach eliminated most the NPT encountered in offset wells, enhanced Rate of Penetration (ROP) by 200% to 300% and slashed the well drilling time by 27 days.
Produkcja w rolnictwie w kontekście ochrony środowiska
