Land Use Affects Soil Moisture Response to Dramatic Short‐term Rainfall Events in a Hillslope Catchment of the Chinese Loess Plateau

2019 ◽  
Vol 111 (3) ◽  
pp. 1506-1515
Author(s):  
Min Tang ◽  
Xining Zhao ◽  
Xiaodong Gao ◽  
Chao Zhang ◽  
Pute Wu
2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Yong-wang Zhang ◽  
Kai-bo Wang ◽  
Jun Wang ◽  
Changhai Liu ◽  
Zhou-ping Shangguan

AbstractChanges in land use type can lead to variations in soil water characteristics. The objective of this study was to identify the responses of soil water holding capacity (SWHC) and soil water availability (SWA) to land use type (grassland, shrubland and forestland). The soil water characteristic curve describes the relationship between gravimetric water content and soil suction. We measured the soil water characteristic parameters representing SWHC and SWA, which we derived from soil water characteristic curves, in the 0–50 cm soil layer at sites representing three land use types in the Ziwuling forest region, located in the central part of the Loess Plateau, China. Our results showed that the SWHC was higher at the woodland site than the grassland and shrubland, and there was no significant difference between the latter two sites, the trend of SWA was similar to the SWHC. From grassland to woodland, the soil physical properties in the 0–50 cm soil layer partially improved, BD was significantly higher at the grassland site than at the shrubland and woodland sites, the clay and silt contents decreased significantly from grassland to shrubland to woodland and sand content showed the opposite pattern, the soil porosity was higher in the shrubland and woodland than that in the grassland, the soil physical properties across the 0–50 cm soil layer improved. Soil texture, porosity and bulk density were the key factors affecting SWHC and SWA. The results of this study provide insight into the effects of vegetation restoration on local hydrological resources and can inform soil water management and land use planning on the Chinese Loess Plateau.


2017 ◽  
Vol 49 (4) ◽  
pp. 1255-1270 ◽  
Author(s):  
Bowei Yu ◽  
Gaohuan Liu ◽  
Qingsheng Liu ◽  
Jiuliang Feng ◽  
Xiaoping Wang ◽  
...  

Abstract Large gullies occur globally and can be classified into four main micro-topographic types: ridges, plane surfaces, pipes and cliffs. Afforestation is an effective method of controlling land degradation worldwide. However, the combined effects of afforestation and micro-topography on the variability of soil moisture remain poorly understood. The primary objectives of this study were to determine whether afforestation affects the spatial pattern of the root-zone (0–100 cm) soil moisture and whether soil moisture dynamics differ among the micro-topographic types in gully areas of the Chinese Loess Plateau. The results showed that in the woodland regions, the spatial mean moisture values decreased by an average of 6.2% and the spatial variability increased, as indicated by the standard deviation (17.1%) and the coefficient of variation (22.2%). In general, different micro-topographic types exerted different influences on soil moisture behavior. The plane surface presented the largest average soil moisture values and the smallest spatial variability. The lowest soil moisture values were observed in the ridge, mainly due to the rapid drainage of these areas. Although pipe woodland region can concentrate surface runoff during and after rainfall, the larger trees growing in these areas can lead to increased soil moisture evapotranspiration.


2018 ◽  
Vol 32 (12) ◽  
pp. 1738-1754 ◽  
Author(s):  
Zhao Jin ◽  
Li Guo ◽  
Henry Lin ◽  
Yunqiang Wang ◽  
Yunlong Yu ◽  
...  

2020 ◽  
Vol 12 (18) ◽  
pp. 3040
Author(s):  
Lina Yuan ◽  
Long Li ◽  
Ting Zhang ◽  
Longqian Chen ◽  
Jianlin Zhao ◽  
...  

Timely and effective estimation and monitoring of soil moisture (SM) provides not only an understanding of regional SM status for agricultural management or potential drought but also a basis for characterizing water and energy exchange. The apparent thermal inertia (ATI) and Temperature Vegetation Dryness Index (TVDI) are two widely used indices to reflect SM from remote sensing data. While the ATI-based model is routinely used to estimate the SM of bare soil and sparsely vegetated areas, the TVDI-based model is more suitable for areas with dense vegetation coverage. In this study, we present an iteration procedure that allows us to identify optimal Normalized Difference Vegetation Index (NDVI) thresholds for subregions and estimate their relative soil moisture (RSM) using three models (the ATI-based model, the TVDI-based model, and the ATI/TVDI joint model) from 1 January to 31 December 2017, in the Chinese Loess Plateau. The initial NDVI (NDVI0) was first introduced to obtain TVDI value and two other thresholds of NDVIATI and NDVITVDI were designed for dividing the whole area into three subregions (the ATI subregion, the TVDI subregion, and the ATI/TVDI subregion). The NDVI values corresponding to maximum R-values (correlation coefficient) between estimated RSM and in situ RSM measurements were chosen as optimal NDVI thresholds after performing as high as 48,620 iterations with 10 rounds of 10-fold cross-calibration and validation for each period. An RSM map of the whole study area was produced by merging the RSM of each of the three subregions. The spatiotemporal and comparative analysis further indicated that the ATI/TVDI joint model has higher applicability (accounting for 36/38 periods) and accuracy than the ATI-based and TVDI-based models. The highest average R-value between the estimated RSM and in situ RSM measurements was 0.73 ± 0.011 (RMSE—root mean square error, 3.43 ± 0.071% and MAE—mean absolute error, 0.05 ± 0.025) on the 137th day of 2017 (DOY—day of the year, 137). Although there is potential for improved mapping of RSM for the entire Chinese Loess Plateau, the iteration procedure of identifying optimal thresholds determination offers a promising method for achieving finer-resolution and robust RSM estimation in large heterogeneous areas.


Sign in / Sign up

Export Citation Format

Share Document