Pressure, temperature, water content, and oxygen fugacity dependence of the Mg grain-boundary diffusion coefficient in forsterite

2018 ◽  
Vol 103 (9) ◽  
pp. 1354-1361 ◽  
Author(s):  
Hongzhan Fei ◽  
Sanae Koizumi ◽  
Naoya Sakamoto ◽  
Minako Hashiguchi ◽  
Hisayoshi Yurimoto ◽  
...  
2018 ◽  
Vol 44 (15) ◽  
pp. 19044-19048 ◽  
Author(s):  
Yoshihiro Tamura ◽  
Eugenio Zapata-Solvas ◽  
Bibi Malmal Moshtaghioun ◽  
Diego Gómez-García ◽  
Arturo Domínguez-Rodríguez

1993 ◽  
Vol 313 ◽  
Author(s):  
John G. Holl-Pellerin ◽  
S.G.H. Anderson ◽  
P.S. Ho ◽  
K.R. Coffey ◽  
J.K. Howard ◽  
...  

ABSTRACTX-ray photoelectron spectroscopy (XPS) has been used to investigate grain boundary diffusion of Cu and Cr through 1000 Å thick Co films in the temperature range of 325°C to 400°C. Grain boundary diffusivities were determined by modeling the accumulation of Cu or Cr on Co surfaces as a function of time at fixed annealing temperature. The grain boundary diffusivity of Cu through Co is characterized by a diffusion coefficient, D0gb, of 2 × 104 cm2/sec and an activation energy, Ea,gb, of 2.4 eV. Similarly, Cr grain boundary diffusion through Co thin films occurs with a diffusion coefficient, Do,gb, of 6 × 10-2cm2/sec and an activation energy, Ea,gb of 1.8 eV. The Co film microstructure has been investigated before and after annealing by x-ray diffraction and transmission electron Microscopy. Extensive grain growth and texturing of the film occurred during annealing for Co deposited on a Cu underlayer. In contrast, the microstructure of Co deposited on a Cr underlayer remained relatively unchanged upon annealing. Magnetometer Measurements have shown that increased in-plane coercivity Hc, reduced remanence squareness S, and reduced coercive squareness S* result from grain boundary diffusion of Cu and Cr into the Co films.


2005 ◽  
Vol 237-240 ◽  
pp. 163-168 ◽  
Author(s):  
M.A.N. Nogueira ◽  
Antônio Claret Soares Sabioni ◽  
Wilmar Barbosa Ferraz

This work deals with the study of zinc self-diffusion in ZnO polycrystal of high density and of high purity. The diffusion experiments were performed using the 65Zn radioactive isotope as zinc tracer. A thin film of the tracer was deposited on the polished surface of the samples, and then the diffusion annealings were performed from 1006 to 1377oC, in oxygen atmosphere. After the diffusion treatment, the 65Zn diffusion profiles were established by means of the Residual Activity Method. From the zinc diffusion profiles were deduced the volume diffusion coefficient and the product dDgb for the grain-boundary diffusion, where d is the grain-boundary width and Dgb is the grain-boundary diffusion coefficient. The results obtained for the volume diffusion coefficient show good agreement with the most recent results obtained in ZnO single crystals using stable tracer and depth profiling by secondary ion mass spectrometry, while for the grain-boundary diffusion there is no data published by other authors for comparison with our results. The zinc grain-boundary diffusion coefficients are ca. 4 orders of magnitude greater than the volume diffusion coefficients, in the same experimental conditions, which means that grain-boundary is a fast path for zinc diffusion in polycrystalline ZnO.


2005 ◽  
Vol 237-240 ◽  
pp. 266-270 ◽  
Author(s):  
Chan Gyu Lee ◽  
Jung Han Lee ◽  
Byeong Seon Lee ◽  
Yong Ill Lee ◽  
Toshitada Shimozaki ◽  
...  

The impurity diffusion coefficients of Cu in Fe have been determined in the temperature range of 1073 - 1163 K by means of Laser Induced Breakdown Spectrometry (LIBS). The volume diffusion coefficients for Cu impurity diffusion in a-iron found in this work are in good agreement with the previously published result. The grain boundary diffusion coefficient gb D s d was also calculated using the volume diffusivity and processing the tails of the measured profiles. The values of the activation energy for volume and grain boundary diffusion were approximately 280 and 161 kJmol-1, respectively. This indicates the possibility of a monovacancy diffusion mechanism in case of volume diffusion. The results for the diffusion coefficients are Dv= 2.2 ×10-2exp(-280 kJmol-1/RT) m2s-1 and gb D s d = 2.6 ×10-11exp(-161 kJmol-1/RT) m3s-1.


Sign in / Sign up

Export Citation Format

Share Document