scholarly journals Combustion characteristics of eastern white pine bark and Douglas fir planer shavings. Technical Progress Report No. 5, September 16, 1977--September 15, 1978

1978 ◽  
Author(s):  
D.C. Junge

1982 ◽  
Vol 12 (4) ◽  
pp. 848-852 ◽  
Author(s):  
D. H. Lambert ◽  
T. C. Weidensaul

Blue spruce (Piceapungens Engelm.), Douglas-fir (Pseudotsugamenziesii (Mirb.) Franco, Noble fir (Abiesprocera Rehd.), and eastern white pine (Pinusstrobus L.) seedlings grown in the greenhouse in peat–vermiculite medium were fertilized with nutrient solutions containing 0.00–0.64 ppm Cu. Maximum growth generally occurred at levels higher than the conventional fertilizer rates of 0.02–0.06 ppm, particularly for Douglas-fir, with subsequent shoot or needle concentrations of 3 or more ppm. Optimum growth of Douglas-fir in a peat–vermiculite medium treated with a single initial drench of 0–100 ppm Cu/L mix occurred over a broad range of foliar Cu concentrations greater than 4 ppm. Supplemental Cu for container-grown conifers thus appears necessary in some cases, but not harmful in others.



HortScience ◽  
1997 ◽  
Vol 32 (3) ◽  
pp. 494A-494
Author(s):  
John F. Ahrens ◽  
Larry J. Kuhns ◽  
Tracey L. Harpster ◽  
Todd L. Mervosh

In 1995, Monsanto Chemical Co. announced that they would replace Roundup herbicide with Roundup Pro for use in the ornamentals and turf markets. Both products contain 4 lb a.i./gal glyphosate, but Roundup Pro contains a more-active surfactant. Though Roundup was labeled as a nonselective herbicide, dormant conifers were found to have varying degrees of resistance to it. Directed sprays that hit the lower two-thirds of many dormant conifers became common practice in the industry. Because the surfactant in Roundup Pro increases the activity of the glyphosate, a series of trials were initiated in 1996 in Connecticut, Pennsylvania, and Vermont in which four glyphosate formulations were applied to a variety of dormant conifers. Roundup, Roundup Pro, Glyfos, and Accord (with and without surfactant) were applied either over-the-top or as directed sprays to the lower 18 inches of the plants at rates between 0.5 and 3 lb a.i./acre. Plants treated included globe arborvitae; upright yew; Canadian hemlock; Colorado, Norway and white spruce; Douglas fir; eastern white pine; and balsam, Canaan, and Fraser fir. In a preliminary study, injury to the spruces in the form of dwarfed and chlorotic new growth was primarily associated with fresh pruning wounds. Accord plus surfactant and Roundup Pro injured more spruces than Roundup, but injury was slight. No injury was observed in upright yew with any formulation at rates up to 0.75 lb a.i./acre. Injury to arborvitae was greatest with Accord plus surfactant, intermediate with Roundup Pro, and least with Roundup. Results are inconclusive at this time, but the results of additional studies available early in the next growing season.will be presented.



2019 ◽  
Vol 46 (10) ◽  
pp. 952-962
Author(s):  
Manoah Philippe Gutknecht ◽  
Colin MacDougall

An experimental investigation of the withdrawal resistance of self-tapping screws (STS) inserted parallel-to-grain in Douglas fir and eastern white pine, dry (7% – 6% MC) and wet (28% MC), is conducted. Withdrawal tests with 10 mm screws showed that at an embedment length of 240 mm in dry Douglas fir, 280 mm in wet Douglas fir, and 320 mm in dry eastern white pine, the screws consistently failed by yielding in tension. Withdrawal tests of 12 mm screws and a constant embedment length of 280 mm showed that a longer embedment length is needed compared to the 10 mm screws to ensure tensile screw failure consistently occurs. For both the 10 mm and 12 mm screws, the withdrawal resistance was lower for the wet wood as compared to dry. The CSA O86 equation for lag screws significantly under-predicts the withdrawal resistance of STSs inserted parallel-to-grain.



Sign in / Sign up

Export Citation Format

Share Document