AbstractLaser surface modification of brass (Cu-38Zn-1.5Pb) using AISiFe and NiCrSiB alloy was achieved by using a 2kW continuous wave Nd-YAG laser with the aim of improving the cavitation erosion resistance and corrosion resistance. The alloying powder was preplaced on the brass substrate by thermal spraying to a thickness of 350µm, followed by laser beam scanning to effect melting, mixing and alloying. A modified surface was achieved by overlapping of adjacent tracks. The cavitation erosion resistance and the anodic polarization characteristics of the laser surface modified specimens in 3.5% NaCI solution at 23°C were studied by means of a 20kHz ultrasonic vibrator at a peak to peak amplitude of 60µm and a potentiostat respectively. The cavitation erosion resistance of the specimens modified with AlSiFe and NiCrSiB was improved by a factor of 3 and 7 respectively, compared with that of the brass substrate. Potentiodynamic test, however, indicated that the corrosion resistance of specimens modified with AlSiFe deteriorated, as reflected by a shift of the polarization curve towards higher current densities. On the other hand, the corrosion resistance of specimens modified with NiCrSiB was significantly improved, as evidenced by the presence of a passive region (from −175 mV to −112 mV) and a reduction in the anodic current density by at least an order of magnitude compared with the substrate at the same anodic potential. The hardness profile and the compositional profile were measured using a Vickers hardness tester and EDX respectively. The microstructure and the surface morphology of the specimens were investigated with the aid of SEM and optical microscopy.
Assessment of End-of-Life Behavior of the Surface Modification to Improve Cavitation-Erosion Resistance in the Mercury Target at the Spallation Neutron Source
