ESTIMATION OF TEMPORAL VARIATIONS AND ANNUAL FLUX OF MICROPLASTICS IN RIVERS UNDER LOW- AND HIGH-FLOW CONDITIONS

Author(s):  
Koki KUDO ◽  
Tomoya KATAOKA ◽  
Yasuo NIHEI ◽  
Fumiya KITAURA
2021 ◽  
Author(s):  
Florian Caillon ◽  
Katharina Besemer ◽  
Peter Peduzzi ◽  
Jakob Schelker

AbstractFlood events are now recognized as potentially important occasions for the transfer of soil microbes to stream ecosystems. Yet, little is known about these “dynamic pulses of microbial life” for stream bacterial community composition (BCC) and diversity. In this study, we explored the potential alteration of stream BCC by soil inoculation during high flow events in six pre-alpine first order streams and the larger Oberer Seebach. During 1 year, we compared variations of BCC in soil water, stream water and in benthic biofilms at different flow conditions (low to intermediate flows versus high flow). Bacterial diversity was lowest in biofilms, followed by soils and highest in headwater streams and the Oberer Seebach. In headwater streams, bacterial diversity was significantly higher during high flow, as compared to low flow (Shannon diversity: 7.6 versus 7.9 at low versus high flow, respectively, p < 0.001). Approximately 70% of the bacterial operational taxonomic units (OTUs) from streams and stream biofilms were the same as in soil water, while in the latter one third of the OTUs were specific to high flow conditions. These soil high-flow OTUs were also found in streams and biofilms at other times of the year. These results demonstrate the relevance of floods in generating short and reoccurring inoculation events for flowing waters. Moreover, they show that soil microbial inoculation during high flow enhances microbial diversity and shapes fluvial BCC even during low flow. Hence, soil microbial inoculation during floods could act as a previously overlooked driver of microbial diversity in headwater streams.


Author(s):  
Steven A. Kidwell

I. THE NEED. A. In high pressure feedwater heaters, a tube leak quickly claims several neighboring tubes as collateral victims. B. Prompt detection of the initial leak would save the neighboring tubes from damage and preclude a potential turbine water induction incident. II. EXAMPLE. A. A Midwest generating station replaced 12 old high pressure heaters. The new heaters contained 304N SS tubes. In one of the new heaters, an unknown localized contaminant caused a single tube leak within the first year. This single leak went undetected until several surrounding tubes were lost due to impingement from the initial leak. And even the conservatively sized normal and emergency drains were overwhelmed, causing the heater to trip on high level. III. CAPABILITY OF SMART LEVEL CONTROLS. A. There are three known possibilities that would cause high drain-flow conditions in a feedwater heater. 1. High Unit Load. 2. The upstream feedwater heater is out of service. 3. A tube leak. B. Traditional Local level controls can sense high flow conditions, but cannot tell why. Most systems will alarm the opening of the emergency drain valve, but by that time, the collateral tube damage is usually severe. “Smart” Level Controls have the capability to distinguish between these conditions, thus allowing it to give early notification of a tube leak, before collateral damage becomes severe.


Author(s):  
Nobuaki Kimura ◽  
Akira Tai ◽  
Akihiro Hashimoto

Purpose Extreme weather events introduced by climate change have been frequent across the world for the past decade. For example, Takeda City, a mountainous area in the south-western Japan, experienced a severe river flood event caused by the factors of high flow, presence of bridges and driftwood accumulation in July 2012. This study aims to focus on this event (hereafter, Takeda flood) because the unique factors of driftwood and bridges were involved. In the Takeda flood, high flow, driftwood and bridge were the potential key factors that caused the flood. The authors studied to reveal the physical processes of the Takeda flood. Design/methodology/approach The authors conducted a fundamental laboratory experiment with a miniature bridge, open channel flow and idealized driftwood accumulation. They also performed a numerical simulation by using a smoothed particle hydrodynamics (SPH) method, which can treat fluid as particle elements. This model was chosen because the SPH method is capable of treating a complex flow such as a spray of water around a bridge. Findings The numerical simulation successfully reproduced the bridge- and driftwood-induced floods of the laboratory experiment. Then, the contribution of the studied key factors to the flood mechanism based on the fluid forces generated by high flow, bridge and driftwood (i.e. pressure distributions) was quantitatively assessed. The results showed that the driftwood accumulation and high flow conditions are potentially important factors that can cause a severe flood like the Takeda flood. Originality/value Simulated results with high flow conditions may be helpful to consider the countermeasure for future floods under climate change even though the test was simple and fundamental.


2006 ◽  
Vol 20 (4) ◽  
Author(s):  
Emily Wilson ◽  
Randy Stewart ◽  
Jan Patterson ◽  
Lisa Auckland ◽  
Jeff Bray ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document