DIELECTRIC MIXING MODELS OF MOIST SOILS FOR MICROWAVE SATELLITE OBSERVATION OF SOIL MOISTURE: A THEORETICAL ANALYSIS

Author(s):  
Kumiko TSUJIMOTO
Measurement ◽  
2010 ◽  
Vol 43 (3) ◽  
pp. 344-352 ◽  
Author(s):  
F. Adamo ◽  
F. Attivissimo ◽  
L. Fabbiano ◽  
N. Giaquinto ◽  
M. Spadavecchia

1997 ◽  
Vol 1 (1) ◽  
pp. 159-174 ◽  
Author(s):  
K. Blyth

Abstract. The launch of the European Remote sensing Satellite (ERS-1) in July 1991 represented an important turning point in the development of Earth observation as it was the first of a series of satellites which would carry high resolution active microwave (radar) sensors which could operate through the thickest cloudeover and provide continuity of data for at least a decade. This was of particular relevance to hydrological applications, such as soil moisture monitoring, which generally require frequent satellite observations to monitor changes in state. ERS-1 and its successor ERS-2 carry the active microwave instrument (AMI) which operates in 3 modes (synthetic aperture radar, wind scatterometer and wave seatterometer) together with the radar altimeter which may all be useful for the observation of soil moisture. This paper assesses the utility of these sensors through a comprehensive review of work in this field. Two approaches to soil moisture retrieval are identified: 1) inversion modelling, where the physical effects of vegetation and soil roughness on radar backscatter are quantified through the use of multi-frequency and/or multi-polarization sensors and 2) change detection where these effects are normalized through frequent satellite observation, the residual effects being attributed to short-term changes in soil moisture. Both approaches will be better supported by the future European Envisat-l satellite which will provide both multi-polarization SAR and low resolution products which should facilitate more frequent temporal observation.


Geophysics ◽  
2012 ◽  
Vol 77 (3) ◽  
pp. H33-H44 ◽  
Author(s):  
Anh Phuong Tran ◽  
Mohammad Reza Mahmoudzadeh Ardekani ◽  
Sébastien Lambot

We coupled dielectric mixing models with a full-wave ground-penetrating-radar (GPR) model to estimate the soil water content by inversion. Two mixing models were taken into account in this study, namely, a power law model and the Wang and Schmugge model. With this combination, we could account for the frequency dependence of the dielectric permittivity and apparent conductivity in the inverse algorithm and directly estimate the soil water content without using an empirical petrophysical formula or a priori knowledge on soil porosity. The approach was validated by a series of experiments with sandy soil in controlled laboratory conditions. The results showed that the performance of our approach is better than the common approach, which assumes a linear dependence of apparent conductivity on frequency and uses Topp’s equation to transform permittivity to water content. GPR data were perfectly reproduced in the time and frequency domains, leading to very accurate water-content estimates with an average absolute error of less than [Formula: see text]. However, the accuracy was reduced as the water content increased. Sensitivity analysis indicated that the Green’s function was most sensitive to the water content and sand-layer thickness but much less so with DC conductivity. The results also revealed that as the frequency increased, although the permittivity was nearly constant, the apparent electrical conductivity and the attenuation increased remarkably, especially for wet sands due to dielectric losses. The successful validation of the proposed approach opens a promising avenue of development to use dielectric mixing models for soil-moisture mapping from GPR measurements.


Sign in / Sign up

Export Citation Format

Share Document