scholarly journals EXPERIMENTAL STUDY ON THE MOTION OF TURBIDITY CLOUDS PRODUCED IN A STAGNANT WATER

2000 ◽  
Vol 44 ◽  
pp. 1245-1250
Author(s):  
Juichiro AKIYAMA ◽  
Masaru URA ◽  
Xinya YING ◽  
Hajime IDENO ◽  
Yayoi NAKANISHI
2017 ◽  
Vol 143 (9) ◽  
pp. 04017082 ◽  
Author(s):  
Mohamad Moghadaripour ◽  
Amir Hossein Azimi ◽  
Siamak Elyasi

In this research, an experimental study of the impact of stagnant water on solar modules is investigated. Two different experiments using two identical photovoltaic (PV) modules S1 and S2 were used for the study. In the first experiment, the PV module S1 was covered with stagnant water and the second PV module was unshielded with water. In the second experiment, the PV modules were swapped with S2 covered with stagnant water and S1 unshielded with water. The experiments were carried out under normal operating temperature of PV cells at the Department of Electrical Engineering, University of Nigeria, Nsukka on latitude 6:52 degrees north, longitude 7:23 degrees. Results obtained from the first experiment show that the efficiency and power output of S1 PV module decreased by 9.3% and 8.0% respectively when compared with that of S2 PV module. In the case of output voltage and current, it was found that shielding of PV module S1 with stagnant water caused an increase in the output voltage by 1.93% and a decrease in the output current by 10.26%. In the second experiment, the efficiency and Output power of PV module S2 decreased by 9.21% and 8.18% respectively when compared with the unshielded PV module S1. In the case of voltage and current, it was found that shielding of PV module S2 with stagnant water caused an increase in the Output voltage by 1.63% and decrease in the output current by 10.91%.


Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  

1974 ◽  
Vol 126 (2) ◽  
pp. 243-248
Author(s):  
A WAKABAYASHI ◽  
T KUBO ◽  
K CHARNEY ◽  
Y NAKAMURA ◽  
J CONNOLLY

1963 ◽  
Vol 45 (3) ◽  
pp. 374-383 ◽  
Author(s):  
Donald C. McIlrath ◽  
George A. Hallenbeck ◽  
Hubert A. Allen ◽  
Charles V. Mann ◽  
Edward J. Baldes ◽  
...  
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document