scholarly journals Selection and Characterization of Geological Sites able to Host a Pilot-Scale CO2Storage in the Paris Basin (GéoCarbone-PICOREF)

Author(s):  
É. Brosse ◽  
G. Badinier ◽  
F. Blanchard ◽  
E. Caspard ◽  
P.Y. Collin ◽  
...  
Keyword(s):  
2015 ◽  
Vol 85 (6) ◽  
pp. 660-682 ◽  
Author(s):  
Cédric Carpentier ◽  
Serge Ferry ◽  
Christophe Lécuyer ◽  
André Strasser ◽  
Yves Géraud ◽  
...  

Abstract:  Porous micritic facies, either primary chalks or resulting from secondary destructive micritization, can constitute important hydrocarbon or water reservoirs. Characterization of reservoir properties and the understanding of factors which controlled the distribution of porosity are of primary interest to evaluate the prospective reserves. Middle and late Oxfordian limestones of the eastern Paris Basin show several horizons with porosities higher than 20%. The porosity is mainly microporous and located either within secondary micritized grains or in the micritic matrix. Using SEM, cathodoluminescence, as well as confocal microscopy, stable oxygen and carbon isotope ratios, and petrophysical measurements, a scenario for the evolution of the micropores is proposed. Lime mudstones to packstones constitute the majority of the high-porosity facies (HPFs). Inner lagoonal deposits are more micritized and thus more porous than grainstones, and facies rich in leiolitic oncoids and echinoid clasts are less impacted by micritization. Micritization was responsible for an increase of the intragranular porosity in most grain types. During both eogenesis and shallow burial, mineralogical stabilization dissolved aragonitic particles and allowed precipitation of calcite rhombs. This process was probably enhanced below surfaces of subaerial exposure. During burial, Ostwald ripening allowed the growth of larger micrite crystals at the expense of smaller ones during early Berriasian and late Aptian recharges of deep aquifers when the northern margin of the basin was exposed. Overgrowths on micrite crystals were more important in intervals strongly affected by chemical compaction, which favored oversaturation of waters with respect to calcite. In low-porosity horizons (LPFs), the dense micritic texture of oncoids and the monocrystalline architecture of echinoid clasts prevented an intense micritization, while the strong chemical compaction enhanced poronecrosis. Telogenetic fracturing created new fluid pathways that favored inputs of meteoric fluid in porous micrite and allowed the continuation of Ostwald ripening during Cenozoic times. As a whole, mesogenetic inputs of waters undersaturated with respect to calcite in deep aquifers during exposure of basin margins are a more efficient process than early subaerial exposure for enhancing aggrading neomorphism and appearance of microporous micrites. Initial mineralogical heterogeneities also impact the intensity of chemical compaction and thus the stratigraphical distribution of microporous limestones.


1985 ◽  
Vol 65 ◽  
Author(s):  
Christopher J. Macey

ABSTRACTSlagging difficulties encountered in large, pulverized coal-fired utility boilers can be alleviated by using recently developed chemical conditioners designed to inhibit the agglomeration of molten fly ash particles. Slagging results from the impaction and accretion on the boiler interior surfaces of molten ash particles in the flue gas resulting from the combustion of coal. Electron Spectroscopy for chemical Analysis (ESCA) and ion sputtering depth profiling were utilized to examine the mechanism whereby a fuel conditioner containing copper oxychloride effectively reduced slag deposition rates during a pilot-scale, pulverized coal combustion experiment.


2017 ◽  
Vol 7 (2) ◽  
pp. 243-251 ◽  
Author(s):  
Moritz Gold ◽  
Daniel Isaac Waya Ddiba ◽  
Alsane Seck ◽  
Patrick Sekigongo ◽  
Alassane Diene ◽  
...  

Revenues from faecal sludge (FS) treatment end products could offset treatment costs and contribute to financially viable sanitation. In urban sub-Saharan Africa, energy-producing resource recovery has the potential to generate greater revenue than use as soil conditioner. In contrast with wastewater sludge, the technical feasibility of using dried FS as solid fuel in industries has not been investigated. This study evaluated it through characterization of dried FS from drying beds and by assessing the combustion performance in two pilot-scale kilns, in Kampala and Dakar. Results from the fuel characterization demonstrate that dried FS had comparable fuel characteristics as wastewater sludge considering calorific value and ash content. The calorific values and ash contents were 10.9–13.4 MJ/kg dry matter (DM) and 47.0–58.7%, respectively. Results from pilot-scale experiments suggest that dried FS can be effective in providing energy for industries. Temperatures in pilot-scale kilns fueled by FS were 800 °C, sufficient for curing of clay bricks, and 437 °C, sufficient for waste oil regeneration. In Kampala and Dakar, an estimated 20,000 tons of FS DM per year accumulate. Tapping the industrial fuel market and financial benefits could be realized through optimization of onsite sanitation and treatment technologies.


Sign in / Sign up

Export Citation Format

Share Document