Characterization of Vapor Compression Refrigeration Cycles through the Second Law of Thermodynamics

Author(s):  
Vinicius Akyo Matsuda ◽  
Luben Cabezas Gómez ◽  
Álvaro Gardenghi
2020 ◽  
pp. 58-58
Author(s):  
Fatih Selimefendigil ◽  
HakanF. Oztop

Exergy analysis of a vapor-compression refrigeration system with TiO2 nanoadditives in the compressor oil was performed. Two-step method was used for the preparation of nano-oil for various solid particle volume fractions between 0% and 1%. Irreversibilities were determined by using second law of thermodynamics. Reduction in total irreversibility is achieved with nanoparticle inclusion and it was significant for higher particle volume fraction.


Entropy ◽  
2020 ◽  
Vol 22 (6) ◽  
pp. 616 ◽  
Author(s):  
Carlos Eduardo Keutenedjian Mady ◽  
Clara Reis Pinto ◽  
Marina Torelli Reis Martins Pereira

This article proposes the utilization of the concepts of destroyed exergy and exergy efficiency for equipment and process performance indicators that are related to the current energy planning scenario in Brazil, more specifically with energy-efficiency labelling. Several indicators associated with these concepts are discussed, including one national program that is based on labeling the energy efficiency of several residential, commercial and industrial appliances. The grades are indicated in the equipment using values from A to G. This labeling system is useful for discriminating similar technologies used for the same function; nevertheless produced by different enterprises. For this complementary analysis, two types of refrigeration methods were compared, absorption and vapor compression; however, these energy indexes alone are not sufficient parameters to select among these two technologies, because their performance indexes definition are different. To address this, our research considers the second law of thermodynamics through exergy analysis as a proper sub-index to obtain a systematic comparison between these various indicators. It is significant to highlight that seldom research studies addressed to this problem so explicitly, in an actual governmental working solution, aiming at discussing to the society the advantage of the usage of the “quality of the energy” as a complementary index to governmental and personal choices. Results indicate that it is possible to use the destroyed exergy and exergy efficiency to help select the technology that better utilizes natural resources, considering the energy matrix of the country. Appliances for water heating and air conditioning were compared from energy and exergy viewpoint, where the last gave additional information about the quality of energy conversion process, giving a completely different trend from the energy analysis alone, without the necessity to think about the energy matrix. Later this issue is addressed from both points of view. Future studies may suggest an exergy based index. The energy efficiency suggests that electrical shower (values higher than 95%) are better than gas water heaters (83% ) in using natural resources, whereas the exergy efficiency shares similar magnitudes (about 3%). A related pattern is shown for the theoretical air conditioning systems. The vapor compression systems have an energy index higher than 3, and absorption systems lower than 1. For these circumstances, the exergy efficiency shows figures nearby 30%.


Volume 1 ◽  
2004 ◽  
Author(s):  
J. S. Tiedeman ◽  
S. A. Sherif

This paper presents results of an optimization study for a two-stage vapor compression refrigeration cycle based on the refrigerating efficiency and exergy index. Traditional two-stage refrigeration cycle studies have focused on the first law performance, while those studies dealing with the second law have primarily been limited to performance analysis as opposed to performance optimization. Results of this study indicate that the use of the common approximation of the geometric mean to find the optimum interstage pressure leads to nearly optimum results for the refrigerating efficiency, with maximum error in the neighborhood of 5%. However, the error associated with using this approximation to find the optimum exergy index is too large, approaching 15%. Second law optimization revealed that the optimum data curves themselves have maxima for each set of conditions tested. There are a series of conditions that lead to the conclusion that, for a given system, there is an optimum set of conditions that lead to the lowest amount of exergy destruction for that system. Polynomial equations have been fitted to the resultant optimum data for the refrigerating efficiency and exergy index. These equations allow for the reproduction of optimum points based on high- and low-pressure compressor efficiencies and condenser and evaporator pressures.


2021 ◽  
Vol 11 (9) ◽  
pp. 539
Author(s):  
Lorena Atarés ◽  
M. Jose Canet ◽  
Macarena Trujillo ◽  
José Vte. Benlloch-Dualde ◽  
Javier Paricio Royo ◽  
...  

Pregraduate students often have low success expectations toward their thermodynamics courses, which are often considered too abstract and remarkably difficult to understand. For this reason, they may not even try to reach any level of comprehension while settling for reproducing mathematical calculations and memorizing definitions to pass the exams. Traditional lectures on thermodynamics, focusing on mathematical deductions while neglecting the qualitative characterization of the concepts behind the equations, do not help in this respect. Aiming at a change in the teaching practice and focused on the second law of thermodynamics, the main goals of this work are to characterize the way of reasoning of the expert; to present a review on the most important learning difficulties encountered by students and categorize them into three groups: the disregard of qualitative understanding, the inherent conceptual difficulties, and those related to the students’ previous knowledge; and to propose some suitable teaching practices to assist instructors in this difficult but rewarding task.


2017 ◽  
Author(s):  
Bai Xueliang ◽  
Zhou Shaoxiang

In real life applications the latest findings of energy savings are playing important role for optimizing and improving the systems. Vapor compression refrigeration systems are some of the most implemented refrigeration systems and most of the energy consumption in this area depends on this system. The power consumption of VCR systems cannot be obtained or compared only with the COP. In order to alleviate the above challenges, a temperature-entropy diagram of actual compression refrigeration cycle is designed to show the differences between the actual and theoretical refrigeration cycles in this research. Second law of thermodynamics was utilized to analyze the entropic and exergy balance of irreversible factors during the refrigeration process. Then specific consumption analysis model of VCR is proposed and specific consumption of specific refrigeration capacity is studied. The proposed method can obtain the actual specific consumption and distribution of the additional specific consumption. Numerical results have shown that the exergy efficiency of the VCR is lower than the COP due to high entropy generation (irreversible losses) because of electricity consumed by the system. An alternative method is introduced for the evaluation of the energy saving potential in VCR system.


2015 ◽  
Vol 2015 ◽  
pp. 1-8 ◽  
Author(s):  
Naveen Solanki ◽  
Akhilesh Arora ◽  
S. C. Kaushik

Effect of condenser fouling is evaluated on the performance of a vapour compression system with refrigerants HFO1234yf and HFO1234ze as an alternative to HFC134a. The condenser coolant temperature has been varied between 35 and 40°C to evaluate the effect of fouling at different condenser temperatures. A simulation model is developed in EES for computing the results. The results have been computed by varying condenser conductance. The same has been validated with literature available before calculating the results. It is observed that the condenser fouling has larger effect on compressor power (Wcp%) as it increases up to 9.12 for R1234yf and 7.41 for R1234ze, whereas for R134a its value increases up to 7.38. The cooling capacity (Qevap%) decreases up to 13.25 for R1234yf and 8.62 for R1234ze, whereas for R134a its value decreases up to 8.76. The maximum percentage of decrease in value of COP is up to 19.29 for R1234yf and 14.47 for R1234ze, whereas for R134a its value decreases up to 14.49. The second-law efficiency is also observed to decrease with decrease in the condenser conductance. The performance of HFO1234ze is found to be better under fouled conditions in comparison to R134a and R1234yf.


Sign in / Sign up

Export Citation Format

Share Document