Connections between Eocene Lakes Uinta and Gosiute with emphasis on the infilling stage of Lake Uinta in Piceance Basin

2019 ◽  
Vol 56 (2) ◽  
pp. 143-183 ◽  
Author(s):  
Ronald C. Johnson ◽  
Justin E. Birdwell ◽  
Michael E. Brownfield ◽  
Tracey J. Mercier ◽  
Paula L. Hansley

Late in its history, Eocene saline Lake Gosiute in the Greater Green River Basin, Wyoming and Colorado was progressively filled from north to south with coarse volcaniclastic sediments. During the infilling, Lake Gosiute began to drain southward across the Axial arch into saline Lake Uinta in the Piceance and Uinta Basins, Colorado and Utah (about 49 Ma) causing Lake Gosiute to freshen. Once Lake Gosiute was filled entirely (about 48 Ma), volcaniclastic sediments spilled over into Lake Uinta. The first coarse volcanic sediments entered the north part of Lake Uinta near the present-day mouth of Yellow Creek 15 miles south of the Axial arch during deposition of the Mahogany oil shale zone. There is evidence that a south-flowing river entered Lake Uinta from the Axial arch starting early in the history of the lake and prior to substantial outflow from Lake Gosiute began. A petrographic study of sandstones from this period is consistent with an Axial arch source. It is likely that the outflow channel occupied this preexisting drainage. Determining when outflow from Lake Gosiute began to move through this preexisting channel is difficult as mainly mud-sized sediments would have entered Lake Uinta from Lake Gosiute prior to infilling. In addition, reliable dates for most of the strata deposited in Lake Uinta are lacking. A partial section of Lake Uinta strata is preserved at Deep Channel Creek about 10 mi south of the Axial arch. Here, the R-6 oil shale zone, below the Mahogany zone, has graded into fluvial strata—the only place in the basin where this zone is not lacustrine. In addition, the underlying L-5 zone is atypically sandy. We propose that Lake Gosiute began to drain into Lake Uinta starting at about the beginning of deposition of the L-5 oil shale zone increasing the input of sediments into the northern part of Lake Uinta. Mud-sized sediments could have come from Lake Gosiute, but the coarser sediments likely came from the Axial arch. Volcaniclastic sediments produced a rapidly prograding deltaic complex that ultimately filled in much if not all of the eastern part of Lake Uinta. The first volcanic sediments to reach the deep depocenter were mainly finegrained turbidites but ultimately the depocenter was largely filled by slumps off the over-steepened delta front. A petrographic study of the volcaniclastic sandstones indicates that the Absaroka volcanic field in northwest Wyoming is the likely source of the volcanic fraction.

Author(s):  
Mohammad Mehdi Taghizadeh

Being on the steep slope of Shiraz city and getting the main drainages, Maharlu Lake is always home to extensive levels of urban pollution. Prolonged droughts and drying of surface sediments of the lake happen usually in warm seasons of the year, and with the continuation of the droughts particles spread out from the surface into the surroundings of the lake. Arsenic and its compound are well known for its toxicity and carcinogenicity. Industrial and farming waste in upstream of the lake are the main sources of arsenic and may disperse in Maharlu Lake.   In this study, by meshing the lake’s surface and by sampling 15 points 3 kilometers away there determined the Arsenic amount. Then, the toxicity indexes and Mueller index together with its risks were studied before zoning of the lake through GIS and verification. The results showed that the average concentration of arsenic was 3.5 mg/ kg of surface sediment. The concentration has gone in most parts of the lake below normal as shown by Mueller index so that its contamination and lower-than-usual toxicity is deemed anthropogenic. Interpolations by GPI, LPI, and IDW methods demonstrated the north part of the lake more concentrated, likely due to the north lake farming and being the entrance of River Soltanabad. The verification of data has recognized the IDW method as the most accurate as regards interpolation.   According to the importance of heavy metals in the dust, samples should be taken from winds coming from the lakeside as dust hotspot to control the metals concentration.


Sign in / Sign up

Export Citation Format

Share Document