scholarly journals Development of HVRT and LVRT Control Strategy for PMSG-Based Wind Turbine Generators

Energies ◽  
2020 ◽  
Vol 13 (20) ◽  
pp. 5442
Author(s):  
Liang Yuan ◽  
Ke Meng ◽  
Jingjie Huang ◽  
Zhao Yang Dong ◽  
Wang Zhang ◽  
...  

Various challenges are acknowledged in practical cases with high wind power penetration. Fault ride-through (FRT) capability has become the most dominant grid integration requirements for the wind energy conversion system worldwide. The high voltage ride-through (HVRT) and low voltage ride-through (LVRT) performance play a vital role in the grid-friendly integration into the system. In this paper, a coordinated HVRT and LVRT control strategy is proposed to enhance the FRT capability of the permanent magnet synchronous generator (PMSG)-based wind turbine generators (WTG). A dual-mode chopper protection is developed to avoid DC-link overvoltage, and a deadband protection is proposed to prevent oscillations under edge voltage conditions. The proposed strategy can ride through different levels of voltage sags or swells and provide auxiliary dynamic reactive power support simultaneously. The performance of the proposed control scheme is validated through various comparison case tests in PSCAD/EMTDC.

Micromachines ◽  
2021 ◽  
Vol 13 (1) ◽  
pp. 39
Author(s):  
Chao-Tsung Ma ◽  
Zong-Hann Shi

As the penetration of renewable energy power generation, such as wind power generation, increases low-voltage ride-through (LVRT), control is necessary during grid faults to support wind turbine generators (WTGs) in compensating reactive current to restore nominal grid voltages, and maintain a desired system stability. In contrast to the commonly used centralized LVRT controller, this study proposes a distributed control scheme using a LVRT compensator (LVRTC) capable of simultaneously performing reactive current compensation for doubly-fed induction generator (DFIG)-, or permanent magnet synchronous generator (PMSG)-based WTGs. The proposed LVRTC using silicon carbide (SiC)-based inverters can achieve better system efficiency, and increase system reliability. The proposed LVRTC adopts a digital control scheme and dq-axis current decoupling algorithm to realize simultaneous active/reactive power control features. Theoretical analysis, derivation of mathematical models, and design of the control scheme are initially conducted, and simulation is then performed in a computer software environment to validate the feasibility of the system. Finally, a 2 kVA small-scale hardware system with TI’s digital signal processor (DSP) as the control core is implemented for experimental verification. Results from simulation and implementation are in close agreement, and validate the feasibility and effectiveness of the proposed control scheme.


2021 ◽  
Author(s):  
Miad Mohaghegh Montazeri

Using power electronic converters with reduced capacity in doubly-fed induction generator (DFIG) based wind turbines make them vulnerable to over-current during grid disturbances. This thesis aims to analyze the behaviour of doubly-fed induction generators based wind farm for various timing schemes of crowbar deactivation and resumption of rotor side converter (RSC) in the case of grid fault. Also, usage of a static synchronous compensator (STATCOM) for the purpose of stabilizing the grid voltage after a three-phase fault is studied in this these. Moreover, finding minimum capacity of STATCOM which ensures low-voltage ride through (LVRT) of wind farm is studied. Finally, coordination of reactive power from wind turbine generators and STATCOM in steady-state condition is performed. All the results in this thesis show that STATCOM improves low voltage ride through (LVRT) capability of wind farm and assists for an uninterrupted operation of wind turbine generators during grid faults.


2021 ◽  
Author(s):  
Miad Mohaghegh Montazeri

Using power electronic converters with reduced capacity in doubly-fed induction generator (DFIG) based wind turbines make them vulnerable to over-current during grid disturbances. This thesis aims to analyze the behaviour of doubly-fed induction generators based wind farm for various timing schemes of crowbar deactivation and resumption of rotor side converter (RSC) in the case of grid fault. Also, usage of a static synchronous compensator (STATCOM) for the purpose of stabilizing the grid voltage after a three-phase fault is studied in this these. Moreover, finding minimum capacity of STATCOM which ensures low-voltage ride through (LVRT) of wind farm is studied. Finally, coordination of reactive power from wind turbine generators and STATCOM in steady-state condition is performed. All the results in this thesis show that STATCOM improves low voltage ride through (LVRT) capability of wind farm and assists for an uninterrupted operation of wind turbine generators during grid faults.


2013 ◽  
Vol 724-725 ◽  
pp. 485-490 ◽  
Author(s):  
Ling Zhou ◽  
Xiao Fang Song ◽  
Hai Bo Xu ◽  
Kang Chang ◽  
Ji Chen Li ◽  
...  

This paper analyses the mechanism of large scale cascading trip-off failures of wind turbine generators in China, focuses on the reasons of trip-off caused by overvoltage. It analyses the model of Doubly Fed Induction Generation (DFIG) and builds a model of a wind farm that is composed of Doubly Fed Induction generators in DIgSILENT. The wind farm A with capacity of 175MW and wind farm B with capacity of 175MW is accessed to the nine bus system. The simulation reproduces the processes of the cascading trip-off of wind turbine generators caused by undervoltage and overvoltage. The trip-off caused by undervoltage is due to the lack of Low Voltage Ride Through (LVRT). And that the capacitive reactive power compensation device is not timely removed leads to a large surplus of reactive power, then the voltage rises, so the wind turbine generators trip off because of overvoltage. By setting the contrast scenario, the result shows that if capacitive reactive power compensation device is promptly removed after the loss of a large amount of active power, the wind turbine generators will not trip off because of overvoltage.


2021 ◽  
pp. 0309524X2110606
Author(s):  
Mohamed Metwally Mahmoud ◽  
Mohamed M Aly ◽  
Hossam S Salama ◽  
Abdel-Moamen M Abdel-Rahim

In recent years, wind energy conversion systems (WECSs) have been growing rapidly. Due to various advantages, a permanent magnet synchronous generator (PMSG) is an appealing solution among different types of wind generators. As wind power penetration level in the grid increases, wind power impacts the grid and vice versa. The most essential concerns in the system are voltage sag and swell, and grid code compliance, particularly for low voltage ride-through (LVRT) and high voltage ride-through (HVRT) capability, is a pressing necessity. This paper presents a parallel capacitor (PC) control strategy to enhance the LVRT and HVRT capability of PMSG. Furthermore, this study presents a method for the sizing of a PC system for the reduction of the overvoltage of the DC-link during voltage sags and swell. Fast Fourier transform analysis is used to determine the total harmonic distortion (THD) for the injected current into the grid. The obtained results illustrate the effectiveness of the proposed system in keeping the DC-link voltage below the limit, power quality improvement, and increasing the LVRT and HVRT capability. Models of wind turbine, PMSG, and PC control system are built using MATLAB/SIMULINK software.


Solar Energy ◽  
2003 ◽  
Author(s):  
G. R. Bhagwatikar ◽  
W. Z. Gandhare

It is well known that the wind power has definitely certain impact on the grid power. Issues associated with the integration of wind power into the utility grid are interface issues, operational issues and planning issues. Interface issues include harmonics, reactive power consumption, voltage regulation and frequency control. Operational issues are intermittent power generation, operating reserve requirements, unit commitment and economic despatch. And planning issues are concerned with intermittent wind resources compared to conventional power resources. An important question, when connecting the wind turbine generators to the utility grid, is how much the power / voltage quality will be influenced, since the power production by wind turbines is intermittent, quantity wise as well as quality wise. This paper is focused on the on comparison between the constant speed wind turbines and variable speed wind turbines, reactive power consumption and harmonics generated by both wind turbines. Total harmonic distortion is calculated by the application of C++ software and a comparison is done between the generators with respect to the harmonics. It is observed that constant speed wind turbine generates low order harmonics and variable speed turbine generates high order harmonics. On the basis of results, some solutions are suggested to improve the wind power quality and to reduce reactive power consumption. It seems that variable speed wind turbines with electronic interface are better with respect to the utility grid point of view.


Sign in / Sign up

Export Citation Format

Share Document