Pliers and nippers - General technical requirements

2021 ◽  
2018 ◽  
Vol 1 (2) ◽  
pp. 37-42
Author(s):  
O Тymoshenko ◽  
O Borys ◽  
T Skorobahatko

The issue of the necessity of developing state standards in the sphere of illuminating and orienting and lighting fire equipment in Ukraine as for classification and general requirements in general and general technical requirements and methods of fire-rescuer lantern tests, in particular, are considered. The main provisions of these standards, which are developed in the Ukrainian Civil Protection Research Institute (UkrCPRI) and on the recommendation of the Standardization Technical Committee of Ukraine TC 25 "Fire safety and fire protection equipment" are outlined and have been earlier introduced to the Program of works for the national standardization for the year of 2018. The application of the basic provisions of these standards will contribute to the introduction of the leading world scientific and technological achievements in Ukraine in the development and production of illuminating and orienting and lighting fire equipment in general, and in particular testing of purchased foreign lanterns for compliance with standardized technical requirements, which will allow more objectively evaluate and compare their technical specifications. In this case, the results of the testing of some test methods and test equipment are presented, according to ANSI/NEMA FL1-2009 Flashlight Basic Performance Standard, when conducting research in UkrCPRI of the best world models of lanterns equipped with modern LED sources of light, power sources, electronics, etc., in particular two fire-rescuer lanterns: Peli 3765 LED (USA) and Vantage®180 (USA), a group fire lantern VULCAN® LED ATEX LANTERN (USA), which are currently supplied domestic fire trucks ООО «VК «Pozhmashyna» and experimental model of  personnel fire lantern developed in UkrCPRI. The specified test methods apply to the following basic lighting technology characteristics of the lantern, such as: light flux, peak power of light and duration of operation of the lantern, useful range of light beam.


2017 ◽  
Vol 2017 (3) ◽  
pp. 35-41
Author(s):  
Grzegorz Olszyna ◽  
Tomasz Rokita ◽  
Marian Wójcik

The article concerns the the problem of research and evaluation of the results of these tests components and mechanical assemblies used ropeway imported into Polish. The requirements regarding research and evaluation and general technical requirements in relation to the selected assemblies ropeway. As an example, we presented research carried out at the Department of Rope Transport University of Science and Technology in Cracow and also carried out repair and regeneration assemblies ropeway by Mostostal Zabrze Realizations Industrial S. A. Department of Silesia in Katowice Factory in Czechowice (formerly Department Assembly - Production "Czechowice").


2012 ◽  
Vol 10 (2) ◽  
pp. 215-222 ◽  
Author(s):  
Nebojsa Davidovic ◽  
Zoran Bonic ◽  
Verka Prolovic

In this paper the possibility of using waste glass in road construction is discussed. Samples of clay material with the addition of waste glass were subjected to a series of laboratory geotechnical tests performed at the Laboratory of Geotechnics at the Faculty of Civil Engineering and Architecture in Nis. The obtained results were compared with criteria defined in the document ?General technical requirements for road construction?. On this basis, the conclusions on the suitability of this mixture for the intended purpose are given.


Sign in / Sign up

Export Citation Format

Share Document