Effects of Temperature and Pressure Changes on the Second Harmonic Inversion Results

2014 ◽  
Vol 41 (12) ◽  
pp. 1215004 ◽  
Author(s):  
贾良权 Jia Liangquan ◽  
刘文清 Liu Wenqing ◽  
刘建国 Liu Jianguo ◽  
阚瑞峰 Kan Ruifeng ◽  
姚路 Yao Lu ◽  
...  
1991 ◽  
Vol 56 (3) ◽  
pp. 663-672 ◽  
Author(s):  
Curtis B. Anderson ◽  
Rade Marković

The influence of temperature and carbon monoxide pressure on the course of oxidative carbonylation reaction of 1,5-cyclooctadiene in the presence of the palladium(II) salts as a catalyst, was investigated.


Fluids ◽  
2019 ◽  
Vol 4 (2) ◽  
pp. 66
Author(s):  
Sónia Costa ◽  
Paulo Teixeira ◽  
José Covas ◽  
Loic Hilliou

Piezoelectric sensors have made their way into polymer processing and rheometry applications, in particular when small pressure changes with very fast dynamics are to be measured. However, no validation of their use for steady shear rheometry is available in the literature. Here, a rheological slit die was designed and constructed to allow for the direct comparison of pressure data measured with conventional and piezoelectric transducers. The calibration of piezoelectric sensors is presented together with a methodology to correct the data from the inherent signal drift, which is shown to be temperature and pressure independent. Flow curves are measured for polymers showing different levels of viscoelasticity. Piezoelectric slit rheometry is validated and its advantage for the rheology of thermodegradable materials with viscosity below 100 Pa·s is highlighted.


2019 ◽  
Vol 14 (11) ◽  
pp. P11016-P11016
Author(s):  
K.J. Brunner ◽  
J. Knauer ◽  
J. Meineke ◽  
M. Stern ◽  
M. Hirsch ◽  
...  

1960 ◽  
Vol 38 (11) ◽  
pp. 2196-2202 ◽  
Author(s):  
N. A. Warner ◽  
T. R. Ingraham

The gas pressures over samples of anhydrous ferric sulphate and anhydrous aluminum sulphate have been measured in a static system, using a mercury manometer in which the exposed surface was covered with a flexible Pyrex bellows. The calculated ΔH for the decomposition of Fe2(SO4)3 was +135.4 kcal/mole. It was not possible to calculate the ΔH for the Al2(SO4)3 decomposition, because a discrete aluminum oxide with singular thermodynamic properties was not obtained.In the Fe2(SO4)3 system, the fraction of SO3 in the gas phase was found to be almost constant over the range of temperature and pressure changes used in the study.At any given temperature, the decomposition pressure over a ferric sulphate sample is greater than that over an aluminum sulphate sample, thus indicating that preferential decomposition of ferric sulphate should be thermodynamically feasible in mixtures of ferric sulphate and aluminum sulphate.


2000 ◽  
Vol 357-358 ◽  
pp. 89-95 ◽  
Author(s):  
Mary Stinecipher Campbell ◽  
Danielle Garcia ◽  
Deanne Idar

2004 ◽  
Vol 70 (2) ◽  
pp. 1231-1233 ◽  
Author(s):  
Jens Kallmeyer ◽  
Antje Boetius

ABSTRACT Rates of sulfate reduction (SR) and anaerobic oxidation of methane (AOM) in hydrothermal deep-sea sediments from Guaymas Basin were measured at temperatures of 5 to 200°C and pressures of 1 × 105, 2.2 × 107, and 4.5 × 107 Pa. A maximum SR of several micromoles per cubic centimeter per day was found at between 60 and 95°C and 2.2 × 107 and 4.5 × 107 Pa. Maximal AOM was observed at 35 to 90°C but generally accounted for less than 5% of SR.


Sign in / Sign up

Export Citation Format

Share Document