Effect of Variable Geometry on Springback of High Strength Steel Materials

Springback is the phenomenon in which the material strip unbends itself after forming process. It is caused by the geometrical, mechanical properties or other process parameters. This paper focused on finite element simulation investigation on effects of geometrical parameters on the springback amount of the High Strength Steel (HSS). Two geometrical parameters, punch radius (Rp) and die opening (Wo) were selected and their effect on springback studied. Finite element simulation of U-bending test was performed using Simufact.formingTM with material database (MatILDa) and the level of the springback was measured. The result of the simulation shows that different values of punch radius (Rp) and die opening (Wo) are significant to the springback effect. 3 variable values of (Rp) and (Wo) selected in this studied are (2mm, 4mm, 6mm) and (30mm, 36mm, 48mm) respectively. The findings of the simulation could be used to accurately and reliably predict springback behavior of the tested material. The value of the springback increases, as the value of the die opening (Wo) increases. Meanwhile, the increasing value of the punch radius (Rp) will lead to decreasing springback value. From this finding, a proper prevention method can be taken to eliminate springback, achieve improvement in the forming process as well as reduce processing time and cost.