Research Advances of NOx Emissions Control Technologies of Stoker Boilers

2012 ◽  
Vol 562-564 ◽  
pp. 1087-1090
Author(s):  
Jia You Liu ◽  
Feng Zhong Sun

Nitrogen oxides (NOx) are one of the pollutants generating from coal combustion in stoker boilers, and they are very harmful to human health and environment. It is necessary to study NOx emissions control technology for stoker boilers. By explaining the formation mechanism and control methods of thermal NOx, fuel NOx and prompt NOx, NOx emissions control technologies applied in stoker boilers are introduced and research advances are given, some advice for NOx emissions control in stoker boilers is put forward.

2014 ◽  
Vol 1073-1076 ◽  
pp. 894-897
Author(s):  
Jia You Liu ◽  
Feng Zhong Sun

Industrial boilers are important thermal power equipments. Soot, SOx and NOx, etc. generated from Industrial boilers are main sources of PM2.5. Based on the analysis of sources of PM2.5 emissions from industrial boilers, PM2.5 control technologies for industrial boilers such as dedusting technology, desulfurization technology and denitration technology are introduced and analyzed. According to the characteristics of current PM2.5 control technology and industrial boilers, technical route of PM2.5 emissions control for industrial boilers is recommended.


2017 ◽  
Vol 7 (9) ◽  
pp. 1803-1825 ◽  
Author(s):  
Ganesh Chandra Dhal ◽  
Devendra Mohan ◽  
R. Prasad

Soot particulates and nitrogen oxides (NOX) from diesel engine exhaust have been causing serious problems to human health and the global environment.


2012 ◽  
Vol 12 (23) ◽  
pp. 11519-11531 ◽  
Author(s):  
C. R. Lonsdale ◽  
R. G. Stevens ◽  
C. A. Brock ◽  
P. A. Makar ◽  
E. M. Knipping ◽  
...  

Abstract. Nucleation in coal-fired power-plant plumes can greatly contribute to particle number concentrations near source regions. The changing emissions rates of SO2 and NOx due to pollution-control technologies over recent decades may have had a significant effect on aerosol formation and growth in the plumes with ultimate implications for climate and human health. We use the System for Atmospheric Modeling (SAM) large-eddy simulation model with the TwO-Moment Aerosol Sectional (TOMAS) microphysics algorithm to model the nucleation in plumes of coal-fired plants. We test a range of cases with varying emissions to simulate the implementation of emissions-control technologies between 1997 and 2010. We start by simulating the W. A. Parish power plant (near Houston, TX) during this time period, when NOx emissions were reduced by ~90% and SO2 emissions decreased by ~30%. Increases in plume OH (due to the reduced NOx) produced enhanced SO2 oxidation and an order-of-magnitude increase in particle nucleation in the plume despite the reduction in SO2 emissions. These results suggest that NOx emissions could strongly regulate particle nucleation and growth in power-plant plumes. Next, we test a range of cases with varying emissions to simulate the implementation of SO2 and NOx emissions-control technologies. Particle formation generally increases with SO2 emission, while NOx shows two different regimes: increasing particle formation with increasing NOx under low-NOx emissions and decreasing particle formation with increasing NOx under high-NOx emissions. Next, we compare model results with airborne measurements made in the W. A. Parish power-plant plume in 2000 and 2006, confirming the importance of NOx emissions on new particle formation and highlighting the substantial effect of background aerosol loadings on this process (the more polluted background of the 2006 case caused more than an order-of-magnitude reduction in particle formation in the plume compared to the cleaner test day in 2000). Finally, we calculate particle-formation statistics of 330 coal-fired power plants in the US in 1997 and 2010, and the model results show a median decrease of 19% in particle formation rates from 1997 to 2010 (whereas the W. A. Parish case study showed an increase). Thus, the US power plants, on average, show a different result than was found for the W. A. Parish plant specifically, and it shows that the strong NOx controls (90% reduction) implemented at the W. A. Parish plant (with relatively weak SO2 emissions reductions, 30%) are not representative of most power plants in the US during the past 15 yr. These results suggest that there may be important climate implications of power-plant controls due to changes in plume chemistry and microphysics, but the magnitude and sign of the aerosol changes depend greatly on the relative reductions in NOx and SO2 emissions in each plant. More extensive plume measurements for a range of emissions of SO2 and NOx and in varying background aerosol conditions are needed, however, to better quantify these effects.


2021 ◽  
Vol 28 (1) ◽  
pp. 129-143
Author(s):  
Qiong Wu ◽  
Jing Zhou

Abstract In this paper, we use the OLS regression method to analyse the influencing mechanism of the NFCC on farmers’ adoption of green prevention and control technology and further verify the mediating effect of information acquisition. The results show that the NFCC has a direct effect on the adoption of green prevention and control technology, and information acquisition has a mediating effect. The first stage of cognitive closure has a more significant effect on farmers’ adoption of green prevention and control technology, information acquisition ability has a significant positive impact on farmers’ adoption of green prevention and control technology, and information acquisition has an incomplete mediating effect on the impact of cognitive closure on the adoption of green prevention and control technologies. This paper further studies and verifies the action path of two dimensions of the NFCC on farmers’ adoption of green prevention and control technology. The results have certain theoretical significance for expanding the knowledge of farmers’ green prevention and control technology behaviour and further enriching the research on farmers’ cognition.


2013 ◽  
Vol 864-867 ◽  
pp. 1346-1351 ◽  
Author(s):  
Wei Guo Pan ◽  
Chao Lin Shi ◽  
Fu Xiao Li ◽  
Han Cheng Luo ◽  
Rui Tang Guo ◽  
...  

A major source of PM2.5is the combustion of coal-fired power plant, so its very necessary to monitor and control the emission of PM2.5form power plant. This paper summarizes the main emission control technologies of PM2.5for coal-fired plant. As the traditional electrostatic precipitators has low removal efficiency of submicron particles, so we improved the supply conditions of the precipitator, and pre-charged to improve the particle properties. Through this article, we know that using electric coagulation technology to control the particles form plant is practicable, and it has a good prospect for development.


2012 ◽  
Vol 424-425 ◽  
pp. 852-856
Author(s):  
Jian Min Sun ◽  
Chun Dong Zhang

In building, the energy consumption of heating, ventilation and air conditioning (HVAC) is the largest, which accounts for forty to sixty percent of the total building consumption. So it is a key research to reduce the energy consumption of the HVAC system for saving building energy. This article describes a variety of energy conservation equipment of HVAC, and describes in detail the principles of each type of equipment. This article also analyzes the growing advanced control technologies for the HVAC system. In conclusion, HVAC equipment is developing in the direction of clean energy and energy efficient; intelligent control technology is more applicable to the varying parameters of complex system such as air conditioning, is more energy conservation and will become the leading direction of research and application


Sign in / Sign up

Export Citation Format

Share Document