Curie Temperature, Microstructure and Magnetic Properties Analysis of Fe-6.5wtSi Alloy Spray Formed as Function of Process Parameters

2010 ◽  
Vol 660-661 ◽  
pp. 267-272
Author(s):  
J.C.R. Muniz ◽  
M.C.A. Silva ◽  
Claudemiro Bolfarini ◽  
M.D.C. Sobral

Fe-6.5%Si alloy spray formed has the Curie temperature variation measured as a function of the parameters process. In this work the magnetic transition temperature was obtained by Differential Scanning Calorimeter although it can be also gotten by Vibration Samples Magnetometer. The process parameters controlled were gas pressure (P), tube diameter (T) and fly height (H) and the properties analyzed were coercive force, maximum permeability, power loss and Curie temperature. The chemical composition was determined using the Curie temperature. The microstructure of deposits was observed in different conditions of light microscopy, bright field, polarized light and dark field, and the grain size was measured according to ASTM 112-95. The process parameters combination P5T6H360 has produced the minimum power loss of 2.26 W/kg and maximum permeability of 9,000. The Curie temperature measured was 683°C, which indicates a Si content of 6.5wt%.

2021 ◽  
Author(s):  
Andrei Kosterov ◽  
Leonid Surovitskii ◽  
Valerii Maksimochkin ◽  
Svetlana Yanson ◽  
Aleksey Smirnov

<p>Ti-rich titanomagnetite is a primary magnetic mineral in submarine basalts, as well as in some terrestrial volcanic rocks. On geological timescale, it undergoes a slow oxidation forming titanomaghemites. This natural process may be modeled to some extent by a prolonged annealing at moderately elevated temperatures. We test this by treating at 355°C for 4, 40, 110, and 375 hours a sample of submarine basalt containing titanomagnetite of approximate TM46 composition with Curie temperature of 205°C. To characterize the oxidation products emerged during annealing, we have carried out magnetic measurements between at cryogenic temperatures between 1.8 K and 300 K and at high temperatures up to 700°C.</p><p>Temperature dependences of magnetic susceptibility measured in an argon atmosphere reveal that annealing for 4 hours already leads to the formation of new magnetic phases (Phases 1 and 2 thereafter) with Curie temperatures of 420°C and 590°C, respectively. At the same time, a phase close to the initial titanomagnetite still remains in a noticeable amount, although its Curie point also shifts towards higher temperatures. Upon further annealing, the initial titanomagnetite completely disappears, the Curie temperature of Phase 1 increases, reaching 500°C after 375 hours, and the Curie temperature of Phase 2 remains practically unchanged. Phase 1 appears unstable to heating to 700°C in argon atmosphere. In samples annealed for up to 110 hours, Phase 1 disappears on cooling, and a phase with the same Curie temperature as the initial titanomagnetite reemerges. In the sample annealed for 375 hours, traces of Phase 1 are still visible in the cooling branch of the susceptibility vs. temperature curve, and the Curie temperature of the reemerged initial-like phase is 250°C. The newly formed Phase 2 remains stable when heated to 700°C in argon.</p><p>Effect of prolonged annealings is clearly seen in low-temperature magnetic properties. In the fresh sample, about one quarter of magnetization acquired at 1.8 K is demagnetized by 5 K. This feature holds for the annealed samples as well. The titanomagnetite phase in the fresh sample manifests itself in a magnetic transition at 58 K. Below this temperature, the FC and ZFC curves sharply diverge, as previously observed for titanomagnetites of intermediate composition. For the annealed samples, the shape of ZFC and FC curves and the ratio between them remain generally similar to those observed for the fresh sample, but there are also several differences. The magnetic transition temperature shifts to ~45 K, while the curves’ shape above the transition changes from concave-up to concave-down. RT-SIRM cycle to 1.8 K in zero field for the fresh sample has a characteristic convex shape and is almost reversible. Magnetization at 1.8 K is about 20% higher than the initial value at 300 K, and magnetization loss after the cycle is only 2-3%. The shape of RT-SIRM cycles changes progressively with increasing annealing time, the degree of irreversibility increasing to ~30% for the sample annealed for 375 hours. </p><p>This study is supported by Russian Foundation of the Basic Research, grants 19-05-00471 and 20-05-00573.</p>


SPIN ◽  
2021 ◽  
Vol 11 (02) ◽  
pp. 2150017
Author(s):  
Halima Hamada ◽  
Keltouma Boudia ◽  
Friha Khelfaoui ◽  
Kadda Amara ◽  
Toufik Nouri ◽  
...  

The structural, electronic, elastic and magnetic properties of CoCrScIn were investigated using first principle calculations with applying the full-potential linearized augmented plane waves (FP-LAPW) method, based totally on the density functional theory (DFT). After evaluating the results, the calculated structural parameters reveal that CoCrScIn compound is stable in its ferrimagnetic configuration of the type-III structure. The mechanical properties show its brittle and stiffer behavior. The formation energy value showed that CoCrScIn can be experimentally synthesized. Additionally, the obtained band structures and density of states (DOS) reflect the half-metallic behavior of CoCrScIn, with an indirect bandgap of 0.43[Formula: see text]eV. The total magnetic moment of 3[Formula: see text][Formula: see text] and half-metallic ferrimagnetic state are maintained in the range 5.73–6,79 Å. The magnetic moment especially issues from the Cr-[Formula: see text] and Co-[Formula: see text] spin-polarizations. Furthermore, the calculations of Curie temperature reveal that CoCrScIn has high magnetic transition temperature of 836.7[Formula: see text]K.


1999 ◽  
Vol 42 (7) ◽  
pp. 758-762
Author(s):  
Kebin Li ◽  
Shouguo Wang ◽  
Rongsheng Cheng ◽  
Xijun Li ◽  
Denglu Hou ◽  
...  

Author(s):  
Kannan M. Krishnan

Propagation of light is described as the simple harmonic motion of transverse waves. Combining waves that propagate on orthogonal planes give rise to linear, elliptical, or spherical polarization, depending on their amplitudes and phase differences. Classical experiments of Huygens and Young demonstrated the principle of optical interference and diffraction. Generalization of Fraunhofer diffraction to scattering by a three-dimensional arrangement of atoms in crystals forms the basis of diffraction methods. Fresnel diffraction finds application in the design of zone plates for X-ray microscopy. Optical microscopy, with resolution given by the Rayleigh criterion to be approximately half the wavelength, works best when tailored to the optimal characteristics of the human eye (λ = 550 nm). Lenses suffer from spherical and chromatic aberrations, and astigmatism. Optical microscopes operate in bright-field, oblique, and dark-field imaging conditions, produce interference contrast, and can image with polarized light. Variants include confocal scanning optical microscopy (CSOM). Metallography, widely used to characterize microstructures, requires polished or chemically etched surfaces to provide optimal contrast. Finally, the polarization state of light reflected from the surface of a specimen is utilized in ellipsometry to obtain details of the optical properties and thickness of thin film materials.


2014 ◽  
Vol 126 (39) ◽  
pp. 10545-10548 ◽  
Author(s):  
Cédric Tassel ◽  
Yoshihiro Goto ◽  
Yoshinori Kuno ◽  
James Hester ◽  
Mark Green ◽  
...  

2015 ◽  
Vol 233-234 ◽  
pp. 204-207 ◽  
Author(s):  
S.A. Nikitin ◽  
I.A. Ovchenkova ◽  
Georgiy A. Tskhadadze ◽  
Konstantin P. Skokov

The direct measurements of the magnetocaloric effect (MCE) and the magnetization for R2Fe17 (R = Y, Tb, Dy) compounds are reported. The maximal values of the MCE for different R2Fe17 compounds are almost the same at the Curie temperature and are equal to 0.8 – 0.85 K at ΛH = 13.5 kOe. The field dependencies of the magnetization and MCE and the dependence of MCE via magnetization deviates from the classical regularities and describes by the thermodynamic theory attracting the higher terms. Obviously the occurrence of the mixed exchange interactions in these compounds leads to the requirement of consideration both thermal and local fluctuations of the exchange integrals near the magnetic transition temperature.


2013 ◽  
Vol 378 ◽  
pp. 225-229 ◽  
Author(s):  
Yeong Seung Jeong ◽  
M.S. Anwar ◽  
Faheem Ahmed ◽  
Seung Rok Lee ◽  
Bon Heun Koo

We report the magnetic transition and large magnetic entropy change in Sr doped lanthanum manganites. Polycrystalline La1-xSrxMnO3(0.20x0.35) samples were prepared using the conventional solid-state reaction method. The results of X-ray diffraction indicates perovskite phase without any impurity. The magnetic study has revealed that the Curie temperature is influenced by Sr-concentration. The doping of Sr at La site affects the Mn-O bond length and Mn-O-Mn bond angle due to the difference in their ionic radii, consequently, the Curie temperature changed. A large magnetic entropy change has been observed for La0.8Sr0.2MnO3sample, the value of the maximum entropy change (SMmax) increases from 1.42 to 2.74 J/kgK as magnetic field increases from 1 to 2.5 T. This investigation suggests that La1-xSrxMnO3can be used as a potential magnetic refrigeration material.


2020 ◽  
Vol 978 ◽  
pp. 353-359 ◽  
Author(s):  
Palash Swarnakar ◽  
L.D. Besra ◽  
Sriparna Chatterjee ◽  
Somdatta Mukherjee ◽  
Amritendu Roy

Multiferroics, with two or more coexisting ferroic orders (ferroelectric, ferro (antiferro)-magnetic) in a single phase, display promising photovoltaic characteristics which can be utilised in solar energy harvesting. However, the efficacy is seriously challenged due to their wide band gap, far from the ideal value of ~1.52 eV for photovoltaic applications, resulting in overall unimpressive performance. In the present work, an approach towards imparting multiferroism in an otherwise non-ferroic system was adopted through strain engineering. Bulk SrMnO3 (SMO) is antiferromagnetic-paraelectric. However, our previous first-principles studies predicted high-pressure phase transformation from bulk non-polar phase to a tetragonal polar phase. In light of the above, SMO was synthesised hydrothermally at 200°C for 96 h using water-soluble nitrate salts of strontium and manganese. FESEM study reveals the formation of hexagonal bipyramid shaped SMO crystals with elongated 1-D features. Powder x-ray diffraction studies and subsequent Rietveld refinement confirm the presence of hexagonal (P63/mmc) as well as tetragonal (P4mm) phases. Energy dispersive x-ray analysis (EDAX) confirms Sr/Mn ≈ 1, the stoichiometric ratio. UV-VIS spectroscopy was utilised to estimate the optical bandgap of the as-grown sample which was found to be in the range of 1.4-1.5 eV. Temperature-dependent magnetisation plot indicates the magnetic transition temperature, ~275K.


2016 ◽  
Vol 3 (5) ◽  
pp. 1500597 ◽  
Author(s):  
Eun-Mi Choi ◽  
Josée E. Kleibeuker ◽  
Thomas Fix ◽  
Jie Xiong ◽  
Christy J. Kinane ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document