EFFECTS OF REDUCTIONS IN NUMBER OF CHANNELS ON RAYLEIGH AND LOVE WAVE DISPERSION IMAGES ACQUIRED USING THE MULTICHANNEL ANALYSIS OF SURFACE WAVES (MASW) METHOD

2018 ◽  
Author(s):  
Siavash Mahvelati ◽  
Joseph Thomas Coe
2020 ◽  
Vol 222 (3) ◽  
pp. 2147-2161
Author(s):  
Bin Luo ◽  
Whitney Trainor-Guitton ◽  
Ebru Bozdağ ◽  
Lisa LaFlame ◽  
Steve Cole ◽  
...  

SUMMARY A 2-D orthogonal distributed acoustic sensing (DAS) array designed for seismic experiments was buried horizontally beneath the Kafadar Commons Geophysical Laboratory on the Colorado School of Mines campus at Golden, Colorado. The DAS system using straight fibre-optic cables is a cost-efficient technology that enables dense seismic array deployment for long-term seismic monitoring, favouring both earthquake-based and ambient-noise-based surface wave analysis for subsurface characterization. In our study, the horizontally orthogonal DAS array records ambient noise data for a period of about two months from November 2018 to January 2019. During this time, the array also detected seismic signals from an ML3.6 earthquake at Glenwood Springs, Colorado, which exhibit opposite signal polarities in the orthogonal DAS section recordings. We derive the transformation matrix for DAS strain measurements in horizontally orthogonal cables to retrieve both Rayleigh and Love wave dispersion information from the single-component DAS signals using the 2-D multichannel analysis of surface waves method. In addition, ambient noise interferometry is applied to long-term DAS noise recordings. Our theoretical derivation demonstrates that Rayleigh and Love wave Green's functions are coupled in the noise cross-correlation functions (NCFs) of DAS receiver pairs. Stacking NCFs over the horizontally orthogonal DAS array can constructively recover the radial Rayleigh wave component but destructively suppress the Love wave component. The multimodal Monte Carlo inversion of the earthquake-based Rayleigh wave and Love wave dispersion measurements and the noise-based Rayleigh wave measurement reveals a 1-D layered structure that agrees qualitatively with geological surveys of the site. Our study demonstrates that although straight fibre-optic cables lack broadside sensitivity, using appropriate DAS array configuration and seismic array methods can extend the seismic acquisition ability of DAS and enable its application to a broad range of scenarios.


2017 ◽  
Vol 5 (3) ◽  
pp. T287-T298 ◽  
Author(s):  
Julian Ivanov ◽  
Richard D. Miller ◽  
Daniel Feigenbaum ◽  
Sarah L. C. Morton ◽  
Shelby L. Peterie ◽  
...  

Shear-wave velocities were estimated at a levee site by inverting Love waves using the multichannel analysis of surface waves (MASW) method augmented with the high-resolution linear Radon transform (HRLRT). The selected site was one of five levee sites in southern Texas chosen for the evaluation of several seismic data-analysis techniques readily available in 2004. The methods included P- and S-wave refraction tomography, Rayleigh- and Love-wave surface-wave analysis using MASW, and P- and S-wave cross-levee tomography. The results from the 2004 analysis revealed that although the P-wave methods provided reasonable and stable results, the S-wave methods produced surprisingly inconsistent shear-wave velocity [Formula: see text] estimates and trends compared with previous studies and borehole investigations. In addition, the Rayleigh-wave MASW method was nearly useless within the levee due to the sparsity of high frequencies in fundamental-mode surface waves and complexities associated with inverting higher modes. This prevented any reliable [Formula: see text] estimates for the levee core. Recent advances in methodology, such as the HRLRT for obtaining higher resolution dispersion-curve images with the MASW method and the use of Love-wave inversion routines specific to Love waves as part of the MASW method, provided the motivation to extend the 2004 original study by using horizontal-component seismic data for characterizing the geologic properties of levees. Contributions from the above-mentioned techniques were instrumental in obtaining [Formula: see text] estimates from within these levees that were very comparable with the measured borehole samples. A Love-wave approach can be a viable alternative to Rayleigh-wave MASW surveys at sites where complications associated with material or levee geometries inhibit reliable [Formula: see text] results from Rayleigh waves.


Geophysics ◽  
2016 ◽  
Vol 81 (5) ◽  
pp. EN67-EN74 ◽  
Author(s):  
Yudi Pan ◽  
Jianghai Xia ◽  
Yixian Xu ◽  
Lingli Gao

Multichannel analysis of Love waves (MALW) analyzes high-frequency Love waves to determine near-surface S-wave velocities, and it is getting increasing attention in the near-surface geophysics and geotechnique community. Based on 2D geometry spread, in which sources and receivers are placed along the same line, current MALW fails to work in a 3D seismic acquisition system. This is because Love-wave particle motion direction is perpendicular to its propagation direction, which makes it difficult to record a Love-wave signal in 3D geometries. We have developed a method to perform MALW with data acquired in 3D geometry. We recorded two orthogonal horizontal components (inline and crossline components) at each receiver point at the same time. By transforming the raw data from rectangular coordinates (inline and crossline components) to radial-transverse coordinates (radial and transverse components), we recovered Love-wave data along the transverse direction at each receiver point. To achieve a Love-wave dispersion curve, the recovered Love-wave data were first transformed into a conventional receiver offset domain, and then transformed into the frequency-velocity ([Formula: see text]-[Formula: see text]) domain. Love-wave dispersion curves were picked along the continuous dispersive energy peaks in the [Formula: see text]-[Formula: see text] domain. The validity of our proposed method was verified by two synthetic tests and a real-world example.


1954 ◽  
Vol 44 (1) ◽  
pp. 1-5
Author(s):  
Jack Foord Evernden

abstract By use of the Love-Wave dispersion data for the earthquake of 29 September 1946 (Lat. 5° S, Long. 154° E), a three-layer model of Pacific Basin structure has been derived. The periods of the Love Waves observed varied continuously from 45 seconds to 7 seconds. The model consists of: (a) 2.5 km. with VS equal to 2.31 km/sec.; (b) 11 km. with VS equal to 3.87 km/sec.; (c) bottom with VS equal to 4.52 km/sec. The differences between this model and that found by Raitt using refraction measurements are discussed.


1963 ◽  
Vol 55 (1) ◽  
pp. 16-20 ◽  
Author(s):  
Ravindra N. Gupta ◽  
Fraser S. Grant

Sign in / Sign up

Export Citation Format

Share Document