scholarly journals Bond strength of self-adhesive resin cement to dentin using different adhesion protocols

2022 ◽  
pp. e35-e39
Author(s):  
L. Junior ◽  
K. Baroudi ◽  
LS. Barroso ◽  
M. Miranda ◽  
R. Vitti ◽  
...  
Keyword(s):  
Bond Strength ◽  
Resin Cement ◽  
Adhesive Resin ◽  
Adhesive Resin Cement

Development of a Cavity Disinfectant Containing Antibacterial Monomer MDPB

2016 ◽  
Vol 95 (13) ◽  
pp. 1487-1493 ◽  
Author(s):  
N. Hirose ◽  
R. Kitagawa ◽  
H. Kitagawa ◽  
H. Maezono ◽  
A. Mine ◽  
...  
Keyword(s):  
Antibacterial Activity ◽  
Bond Strength ◽  
Bacterial Species ◽  
Oral Bacteria ◽  
Resin Cement ◽  
Resin Cements ◽  
Adhesive Resin ◽  
Significant Difference ◽  
Adhesive Resin Cement

An experimental cavity disinfectant (ACC) that is intended to be used for various direct and indirect restorations was prepared by adding an antibacterial monomer 12-methacryloyloxydodecylpyridinum bromide (MDPB) at 5% into 80% ethanol. The antibacterial effectiveness of ACC and its influences on the bonding abilities of resin cements were investigated. To examine the antibacterial activity of unpolymerized MDPB, the minimum inhibitory and bactericidal concentrations (MIC and MBC) were determined for Streptococcus mutans, Lactobacillus casei, Actinomyces naeslundii, Parvimonas micra, Enterococcus faecalis, Fusobacterium nucleatum, and Porphyromonas gingivalis. Antibacterial activities of ACC and the commercial cavity disinfectant containing 2% chlorhexidine and ethanol (CPS) were evaluated by agar disk diffusion tests through 7 bacterial species and by MIC and MBC measurement for S. mutans. The effects of ACC and CPS to kill bacteria in dentinal tubules were compared with an S. mutans–infected dentin model. Shear bond strength tests were used to examine the influences of ACC on the dentin-bonding abilities of a self-adhesive resin cement and a dual-cure resin cement used with a primer. Unpolymerized MDPB showed strong antibacterial activity against 7 oral bacteria. ACC produced inhibition zones against all bacterial species similar to CPS. For ACC and CPS, the MIC value for S. mutans was identical, and the MBC was similar with only a 1-step dilution difference (1:2). Treatment of infected dentin with ACC resulted in significantly greater bactericidal effects than CPS ( P < 0.05, analysis of variance and Tukey’s honest significant difference test). ACC showed no negative influences on the bonding abilities to dentin for both resin cements, while CPS reduced the bond strength of the self-adhesive resin cement ( P < 0.05). This study clarified that the experimental cavity disinfectant containing 5% MDPB is more effective in vitro than the commercially available chlorhexidine solution to eradicate bacteria in dentin, without causing any adverse influences on the bonding abilities of resinous luting cements.

Bond Strength of Self-adhesive Resin Cement to Different Root Perforation Materials

2016 ◽  
Vol 42 (12) ◽  
pp. 1819-1821 ◽  
Author(s):  
Stephanie Lemos Martins Sicuro ◽  
Marilisa Carneiro Leão Gabardo ◽  
Carla Castiglia Gonzaga ◽  
Nathaly Dias Morais ◽  
Flares Baratto-Filho ◽  
...  
Keyword(s):  
Bond Strength ◽  
Resin Cement ◽  
Adhesive Resin ◽  
Adhesive Resin Cement

scholarly journals The Effect of Self-adhesive and Self-etching Resin Cements on the Bond Strength of Nonmetallic Posts in Different Root Thirds

2015 ◽  
Vol 16 (2) ◽  
pp. 147-153 ◽  
Author(s):  
Mateus Rodrigues Tonetto ◽  
Rudys Rodolfo de Jesus Tavarez ◽  
Omar El-Mowafy ◽  
Matheus Coelho Bandeca ◽  
Thiago Soares Porto ◽  
...  
Keyword(s):  
Bond Strength ◽  
Resin Cement ◽  
Resin Cements ◽  
Human Teeth ◽  
Adhesive Resin ◽  
Microtensile Testing ◽  
Special Machine ◽  
Adhesive Resin Cement ◽  
The Difference ◽  
Post Space

ABSTRACT Purpose The purpose of this study was to evaluate the effect of self-adhesive and self-etching resin cements on the bond strength of nonmetallic posts in different root regions. Materials and methods Sixty single-rooted human teeth were decoronated, endodontically treated, post-space prepared, and divided into six groups. Glass-fiber (GF) posts (Exacto, Angelus) and fiber-reinforced composite (FRC) posts (EverStick, StickTeck) were cemented with self-adhesive resin cement (Breeze) (SA) (Pentral Clinical) and self-etching resin cement (Panavia-F) (SE) (Kuraray). Six 1-mm-thick rods were obtained from the cervical (C), middle (M), and apical (A) regions of the roots. The specimens were then subjected to microtensile testing in a special machine (BISCO; Schaumburg, IL, USA) at a crosshead speed of 0.5 mm/min. Microtensile bond strength data were analyzed with two-way ANOVA and Tukey's tests. Results Means (and SD) of the MPa were: GF/SA/C: 14.32 (2.84), GF/SA/M: 10.69 (2.72), GF/SA/A: 6.77 (2.17), GF/SE/C: 11.56 (4.13), GF/SE/M: 6.49 (2.54), GF/SE/A: 3.60 (1.29), FRC/SA/C: 16.89 (2.66), FRC/SA/M: 13.18 (2.19), FRC/SA/A: 8.45 (1.77), FRC/SE/C: 13.69 (3.26), FRC/SE/M: 9.58 (2.23), FRC/SE/A: 5.62 (2.12). The difference among the regions was statistically significant for all groups (p < 0.05). The selfadhesive resin cement showed better results than the selfetching resin cement when compared to each post (p < 0.05). No statistically significant differences in bond strengths of the resin cements when comparable to each post (p > 0.05). Conclusion The bond strength values were significantly affected by the resin cement and the highest values were found for self-adhesive resin cement. How to cite this article da Silva MB, de Jesus Tavarez RR, de Assis FS, Tonetto MR, Porto TS, Bhandi SH, El-Mowafy O, de Toledo Porto Neto S, Bandeca MC. The Effect of Self-adhesive and Self-etching Resin Cements on the Bond Strength of Nonmetallic Posts in Different Root Thirds. J Contemp Dent Pract 2015;16(2):147-153.

Shear bond strength of a self-adhesive resin cement to resin-coated dentin

2013 ◽  
Vol 51 (1) ◽  
pp. 27
Author(s):  
Jee-Youn Hong ◽  
Cheol-Woo Park ◽  
Jeong-Uk Heo ◽  
Min-Ki Bang ◽  
Jae-Jun Ryu
Keyword(s):  
Bond Strength ◽  
Shear Bond Strength ◽  
Resin Cement ◽  
Adhesive Resin ◽  
Adhesive Resin Cement

Tensile bond strength of an adhesive resin cement to different alloys having various surface treatments

2009 ◽  
Vol 101 (2) ◽  
pp. 107-118 ◽  
Author(s):  
Amara Abreu ◽  
Maria A. Loza ◽  
Augusto Elias ◽  
Siuli Mukhopadhyay ◽  
Stephen Looney ◽  
...  
Keyword(s):  
Bond Strength ◽  
Surface Treatments ◽  
Resin Cement ◽  
Tensile Bond Strength ◽  
Adhesive Resin ◽  
Adhesive Resin Cement

scholarly journals Micro-Raman Vibrational Identification of 10-MDP Bond to Zirconia and Shear Bond Strength Analysis

2017 ◽  
Vol 2017 ◽  
pp. 1-7 ◽  
Author(s):  
Diego Martins De-Paula ◽  
Alessandro D. Loguercio ◽  
Alessandra Reis ◽  
Natasha Marques Frota ◽  
Radamés Melo ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Bond Strength ◽  
Resin Cement ◽  
Zirconia Ceramic ◽  
Strength Analysis ◽  
Dihydrogen Phosphate ◽  
Adhesive Resin ◽  
Micro Raman Spectroscopy ◽  
Adhesive Resin Cement ◽  
Microshear Bond Strength

So far, there is no report regarding the micro-Raman vibrational fingerprint of the bonds between 10-methacryloyloxy-decyl dihydrogen phosphate (10-MDP) and zirconia ceramics. Thus, the aim of this study was to identify the Raman vibrational peaks related to the bonds of 10-MDP with zirconia, as well as the influence on microshear bond strength. Micro-Raman spectroscopy was employed to assess the vibrational peak of 10-MDP binding to zirconia. Microshear bond strength of the dual-cure resin cement to zirconia with the presence of 10-MDP in composition of experimental ceramic primer and self-adhesive resin cement was also surveyed. Statistical analysis was performed by one-way ANOVA and Tukey’s test (p<0.05). Peaks at 1545 cm−1 and 1562 cm−1 were found to refer to zirconia binding with 10-MDP. The presence of 10-MDP in both experimental ceramic primer and self-adhesive resin cement improved microshear bond strength to zirconia ceramic. It can be concluded that the nondestructive method of micro-Raman spectroscopy was able to characterize chemical bonds of 10-MDP with zirconia, which improves the bond strengths of resin cement.

Effect of temporary cements on the microtensile bond strength of self-etching and self-adhesive resin cement

2014 ◽  
Vol 72 (8) ◽  
pp. 762-769 ◽  
Author(s):  
Edilausson Moreno Carvalho ◽  
Ceci Nunes Carvalho ◽  
Alessandro Dourado Loguercio ◽  
Darlon Martins Lima ◽  
José Bauer
Keyword(s):  
Bond Strength ◽  
Resin Cement ◽  
Microtensile Bond Strength ◽  
Adhesive Resin ◽  
Adhesive Resin Cement
Sign in / Sign up

Export Citation Format

Share Document