scholarly journals Supplementary material to "A tracer release experiment to investigate uncertainties in drone-based emission quantification for methane point sources"

2021 ◽  
Author(s):  
Randulph Morales ◽  
Jonas Ravelid ◽  
Katarina Vinkovic ◽  
Piotr Korbeń ◽  
Béla Tuzson ◽  
...  
Keyword(s):  
Point Sources ◽  
Release Experiment ◽  
Supplementary Material

Supplementary material to "NH<sub>3</sub> emissions from large point sources derived from CrIS and IASI satellite observations"

2019 ◽  
Author(s):  
Enrico Dammers ◽  
Chris A. McLinden ◽  
Debora Griffin ◽  
Mark W. Shephard ◽  
Shelley Van Der Graaf ◽  
...  
Keyword(s):  
Point Sources ◽  
Satellite Observations ◽  
Supplementary Material

scholarly journals A tracer release experiment to investigate uncertainties in drone-based emission quantification for methane point sources

2021 ◽  
Author(s):  
Randulph Morales ◽  
Jonas Ravelid ◽  
Katarina Vinkovic ◽  
Piotr Korbeń ◽  
Béla Tuzson ◽  
...  
Keyword(s):  
Spatial Scales ◽  
Fast Response ◽  
Point Sources ◽  
Atmospheric Methane ◽  
Release Experiment ◽  
Wind Speeds ◽  
Laser Absorption ◽  
Emission Fluxes ◽  
Emission Estimate ◽  
Average Residual

Abstract. Mapping trace gas emission plumes using in-situ measurements from unmanned aerial vehicles (UAV) is an emerging and attractive possibility to quantify emissions from localized sources. Here, we present the results of an extensive tracer-release experiment in Dübendorf, Switzerland, which was conducted to develop an optimal quantification method and to determine the related uncertainties under various environmental and sampling conditions. Atmospheric methane mole fractions were simultaneously measured using a miniaturized fast-response Quantum Cascade Laser Absorption Spectrometer (QCLAS) and an Active AirCore system mounted on a commercial drone. Emission fluxes were estimated using a mass-balance method by flying the drone-based system through a vertical cross-section downwind of the point-source perpendicular to the main wind direction at multiple altitudes. A refined kriging framework, called cluster-based kriging, was developed to spatially map individual methane measurement points into the whole measurement plane, while taking into account the different spatial scales between background and enhanced methane values in the plume. We found that the new kriging framework resulted in better quantification compared to ordinary kriging. The average bias of the estimated emissions was −1 % and the average residual of individual errors was 54 %. Direct comparison of QCLAS and AirCore measurements shows that AirCore measurements are smoothened by 20 s and temporally shifted and stretched by 7 s and 0.06 seconds for every second of QCLAS measurement, respectively. Applying these corrections to the AirCore measurements and successively calculating an emission estimate shows an enhancement of the accuracy by 3 % as compared to its uncorrected counterpart. Optimal plume sampling, including the downwind measurement distance, depends on wind- and turbulence conditions and it is furthermore limited by numerous parameters such as the maximum flight time, and the measurement accuracy. Under favorable measurement conditions, emissions could be quantified with an uncertainty of 30 %. Uncertainties increase when wind speeds are below 2.3 m s−1 and directional variability is above 33°, and when the downwind distance is above 75 m. In addition, the flux estimates were also compared to estimates from the well-established OTM-33A method involving stationary measurements. A good agreement was found, both approaches being close to the true-release and uncertainties of both methods usually capturing the true-release.

Resistance Monitor and Control for Vacuum Evaporation of Metals and Carbon

1976 ◽  
Vol 34 ◽  
pp. 572-573
Author(s):  
Russell L. Steere ◽  
Eric F. Erbe ◽  
J. Michael Moseley
Keyword(s):  
Electronic Device ◽  
Point Sources ◽  
High Contrast ◽  
Variable Resistor ◽  
Quality Of Results ◽  
Low Contrast ◽  
Evaporation Source ◽  
And Control ◽  
At Will

We have designed and built an electronic device which compares the resistance of a defined area of vacuum evaporated material with a variable resistor. When the two resistances are matched, the device automatically disconnects the primary side of the substrate transformer and stops further evaporation.This approach to controlled evaporation in conjunction with the modified guns and evaporation source permits reliably reproducible multiple Pt shadow films from a single Pt wrapped carbon point source. The reproducibility from consecutive C point sources is also reliable. Furthermore, the device we have developed permits us to select a predetermined resistance so that low contrast high-resolution shadows, heavy high contrast shadows, or any grade in between can be selected at will. The reproducibility and quality of results are demonstrated in Figures 1-4 which represent evaporations at various settings of the variable resistor.

Designing Workbook for Teaching Writing Descriptive Text Based on Scientific Approach

2019 ◽  
Vol 1 (2) ◽  
pp. 59
Author(s):  
Indah Pratiwi ◽  
Yanti Sri Rezeki
Keyword(s):  
Teaching Writing ◽  
English Teacher ◽  
Design Development ◽  
Seventh Grade ◽  
Internal Evaluation ◽  
Writing Ability ◽  
Good Book ◽  
Scientific Approach ◽  
Supplementary Material ◽  
Analysis Design

This research aims to design workbook based on the scientific approach for teaching writing descriptive text. This research was conducted on the seventh-grade students of SMPN 24 Pontianak. The method of this research is ADDIE (Analysis, Design, Development, Implementation, and Evaluation) with the exclusion of Implementation and Evaluation phases. This material was designed as supplementary material to support the course book used especially in teaching writing of descriptive text. The respondents in this research were the seventh-grade students and an English teacher at SMPN 24 Pontianak. In this research, the researchers found that workbook based on scientific approach fulfilled the criteria of the good book to teach writing descriptive text. The researchers conducted an internal evaluation to see the usability and the feasibility of the workbook. The result of the evaluation is 89%. It showed that the workbook is feasible to be used by students as the supplementary material to support the main course book and help the students improve their writing ability in descriptive text.

Catalytic Fluorination of Boron Compounds at a Bismuth Redox Platform

2019 ◽  
Author(s):  
Oriol Planas ◽  
Feng Wang ◽  
Markus Leutzsch ◽  
Josep Cornella
Keyword(s):  
Transition Metal ◽  
Main Group ◽  
Group Element ◽  
Oxidation States ◽  
Boron Compounds ◽  
Main Text ◽  
Main Group Element ◽  
Rational Ligand Design ◽  
Supplementary Material

The ability of bismuth to maneuver between different oxidation states in a catalytic redox cycle, mimicking the canonical organometallic steps associated to a transition metal, is an elusive and unprecedented approach in the field of homogeneous catalysis. Herein we present a catalytic protocol based on bismuth, a benign and sustainable main-group element, capable of performing every organometallic step in the context of oxidative fluorination of boron compounds; a territory reserved to transition metals. A rational ligand design featuring hypervalent coordination together with a mechanistic understanding of the fundamental steps, permitted a catalytic fluorination protocol based on a Bi(III)/Bi(V) redox couple, which represents a unique example where a main-group element is capable of outperforming its transition metal counterparts.<br>A main text and supplementary material have been attached as pdf files containing all the methodology, techniques and characterization of the compounds reported.<br>

EVALUATION OF MOUNTAIN AREA AS NON-POINT SOURCE OF NITROGEN FOR SETO INLAND SEA: THE NORTHERN SHIKOKU REGION, JAPAN

2017 ◽  
Author(s):  
Shohei Morisawa ◽  
Shohei Morisawa ◽  
Yukio Komai ◽  
Yukio Komai ◽  
Takao Kunimatsu ◽  
...  
Keyword(s):  
Average Concentration ◽  
Point Sources ◽  
Seto Inland Sea ◽  
Mountain Streams ◽  
Unit Load ◽  
Mountain Areas ◽  
Mountain Area ◽  
The Seto Inland Sea ◽  
Unit Load Method ◽  
Important Position

The northern Shikoku region is located in the Western part of Japan and faces towards the Seto Inland Sea. The forest area, which is one of the non-point sources in the Seto Inland Sea watershed, occupies 75% of the land use in the watershed of the northern Shikoku region. The amount of loadings of nutrients and COD in the Seto Inland Sea has been estimated by the unit load method but actually the data has not been investigated. It is however, necessary to know the real concentration of nitrogen in mountain streams to evaluate the role which is the mountain area plays as non-point sources. Therefore, more water samples of mountain streams in the watershed need to be taken and the concentrations of nitrogen analyzed. The mountain streams in the northern Shikoku area were investigated from April, 2015 to November, 2015. The number of sampling sites was 283, in addition to the past data by Kunimatsu et al. The average concentration of nitrate nitrogen in Ehime, Kagawa, and Tokushima was 0.61mg/L, 0.78mg/L and 0.34mg/L, respectively. The environmental standard range for nitrogen in the Seto Inland Sea is from between less than 0.2mg/L and less than 1mg/L. Therefore, the average concentration of nitrogen in these regions was over category II, and those of mountain streams in Kagawa Prefecture exceeded category III. About 20% of mountain streams were more than 1mg/L. It has become clear that mountain areas occupy an important position as non-point sources for the Seto Inland Sea.

Sign in / Sign up

Export Citation Format

Share Document