Detection and measurement of landslide deformation prior to their failure by satellite radar interferometry.

Author(s):  
Alessandro Simoni ◽  
Benedikt Bayer ◽  
Pierpaolo Ciuffi ◽  
Silvia Franceschini ◽  
Matteo Berti

<p>Landslides are widespread landscape features in the Northern Apennine mountain chain and their activity frequently cause damages to settlements and infrastructures. In such context, slow-moving landslides are very common and typically affect fine-grained weathered rocks. Long periods of sustained slow-movements (cms/year) can be interrupted by rapid acceleration and catastrophic failures (ms/day) that are caused by intense rainfall events. Space-borne synthetic aperture radar interferometry (InSAR) proved effective to detect actively deforming phenomena and monitor their evolution in the periods before and after failures. We present InSAR results derived from the Sentinel 1 satellite constellation for landslide cases that underwent reactivation during 2019. In all cases, the catastrophic failures were unexpected and no ground-based monitoring data are available. We processed pre- and post-failure interferograms of SAR images acquired by Sentinel 1 A/B with time spans ranging from 6 to 24 days, removing those having low coherence by manual inspection. The conventional 2-pass technique allowed us to obtain measurements of surface displacement despite the fact that sparse to none infrastructures nor bare rock outcrops are present on the landslide bodies. Our interferograms show that surface displacements are visible well in advance of the actual failure. They display nearly continuous downslope motion with seasonal velocity changes. Time series between 2015 and 2019 shows that surface displacements can be appreciated throughout most part of the year with snow cover and summer peak of vegetation being the most notable exceptions. Distinct accelerations can be detected in space and time during the weeks and months preceding the reactivation.</p><p>We compare time-dependent deformations to precipitation patterns to explore their relationship and to document the transition from stable to unstable deformation. Our work suggests that InSAR interferometry can be successfully used to measure pre-failure displacements and detect slow-moving landslides that are more prone to reactivation in case of rainfall events.</p>

2020 ◽  
Author(s):  
Karolina Owczarz ◽  
Anna Kopeć ◽  
Dariusz Głąbicki

<p>The level of intensity of induced seismic phenomena occurring in areas of mining activity is very diverse. Induced shocks may be directly related to the exploitation carried out or to mining and tectonic factors. In the case of impact on the surface, two types of mining tremors are distinguished: energetically weak shocks, not causing surface deformation, and shocks exceeding a certain energy level, which cause terrain deformations. Surface displacements are the most common form of the effects of underground mining operations, including induced seismicity. Geological research uses Sentinel-1 imagery to determine the geometry of surface displacements that were caused by induced shocks by satellite radar interferometry. In this research four induced shocks with magnitude M>4.0 was used, which occurred in the Legnica-Glogow Copper District in the Rudna mine. This area is one of the most seismically active places in Poland due to the underground exploitation of copper ore. For calculations, the differential satellite radar interferometry (DInSAR) method was used. The DInSAR technique allowed the determination of surface displacement towards the Line of Sight (LOS) between two images acquired at different times (before and after induced shock) with millimeter accuracy. In the presented research calculations were carried out separately for observations acquired in descending and ascending orbits. The Sentinel-1 satellites are a constellation of two radar satellites that observe the surface of lands and oceans at a time interval of 6 days. Therefore, 6 days, 12 days, 18 days and 24 days were assumed as the time intervals between the images. Vertical displacements were calculated based on the generated LOS displacement maps. In addition, charts of subsidence in the N-S and W-E directions were prepared, 3D models of subsidence were made, and deformation geometry was analyzed for individual shocks. As a result of the research, the spatial extent of deformation in the horizontal surface was determined: N-S and W-E, which in both directions was over 2 km. However, surface displacements caused by induced shocks reached values up to 10 cm.</p>


1996 ◽  
Vol 42 (140) ◽  
pp. 10-22 ◽  
Author(s):  
Ian Joughin ◽  
Dale Winebrenner ◽  
Mark Fahnestock ◽  
Ron Kwok ◽  
William Krabill

AbstractDetailed digital elevation models (DEMs) do not exist for much of the Greenland and Antartic ice sheets. Radar altimetry is at present the primary, in many cases the only, source of topographic data over the ice sheets, but the horizontal resolution of such data is coarse. Satellite-radar interferometry uses the phase difference between pairs of synthetic aperture radar (SAR) images to measure both ice-sheet topography and surface displacement. We have applied this technique using ERS-1 SAR data to make detailed (i.e. 80 m horizontal resolution) maps of surface topography in a 100 km by 300 km strip in West Greenland, extending northward from just above Jakobshavns Isbræ. Comparison with а 76 km long line of airborne laser-altimeter data shows that We have achieved a relative accuracy of 2.5 m along the profile. These observations provide a detailed view of dynamically Supported topography near the margin of an ice sheet. In the final section We compare our estimate of topography with phase contours due to motion, and confirm our earlier analysis concerning vertical ice-sheet motion and complexity in ERS-1 SAR interferograms.


2019 ◽  
Vol 124 (7) ◽  
pp. 7504-7518 ◽  
Author(s):  
Xie Hu ◽  
Roland Bürgmann ◽  
Zhong Lu ◽  
Alexander L. Handwerger ◽  
Teng Wang ◽  
...  

1996 ◽  
Vol 42 (140) ◽  
pp. 10-22 ◽  
Author(s):  
Ian Joughin ◽  
Dale Winebrenner ◽  
Mark Fahnestock ◽  
Ron Kwok ◽  
William Krabill

Abstract Detailed digital elevation models (DEMs) do not exist for much of the Greenland and Antartic ice sheets. Radar altimetry is at present the primary, in many cases the only, source of topographic data over the ice sheets, but the horizontal resolution of such data is coarse. Satellite-radar interferometry uses the phase difference between pairs of synthetic aperture radar (SAR) images to measure both ice-sheet topography and surface displacement. We have applied this technique using ERS-1 SAR data to make detailed (i.e. 80 m horizontal resolution) maps of surface topography in a 100 km by 300 km strip in West Greenland, extending northward from just above Jakobshavns Isbræ. Comparison with а 76 km long line of airborne laser-altimeter data shows that We have achieved a relative accuracy of 2.5 m along the profile. These observations provide a detailed view of dynamically Supported topography near the margin of an ice sheet. In the final section We compare our estimate of topography with phase contours due to motion, and confirm our earlier analysis concerning vertical ice-sheet motion and complexity in ERS-1 SAR interferograms.


2014 ◽  
Vol 637 ◽  
pp. 163-177 ◽  
Author(s):  
Benedetta Antonielli ◽  
Oriol Monserrat ◽  
Marco Bonini ◽  
Gaia Righini ◽  
Federico Sani ◽  
...  

Science ◽  
1993 ◽  
Vol 262 (5139) ◽  
pp. 1525-1530 ◽  
Author(s):  
R. M. Goldstein ◽  
H. Engelhardt ◽  
B. Kamb ◽  
R. M. Frolich

Geology ◽  
2011 ◽  
Vol 39 (6) ◽  
pp. 551-554 ◽  
Author(s):  
Pablo J. González ◽  
José Fernández

Sign in / Sign up

Export Citation Format

Share Document