Impact of subgrade and backfill stiffness on values and distribution of bending moments in integral box bridge

The article presents parametric analysis regarding the impact of subgrade and backfill stiffness on values and distribution of bending moments in the structural elements of a small integral box bridge made of cast in situ reinforced concrete. The analyzed parameters are the modulus of subgrade reaction under and behind the bridge structure (kv kh). At the beginning, the author presents the integral box bridge and selected parts of the bridge design. In particular, the author focuses on the method of modeling of the subgrade stiffness parameters under and behind the bridge structure, as well as their impact on the values and distribution of bending moments in the bridge structural elements. The bridge was designed by the author and built on the M9 motorway between the towns of Waterford and Kilcullen in Ireland. In conclusions, the author shares his knowledge and experience relating to the design of small integral bridges and culverts and puts forward recommendations as to further research on these type of structures in Poland.

Appraisal of Bearing Capacity and Modulus of Subgrade Reaction of Refilled Soils

Soil is remoulded, replaced, or improved in place to meet the required engineering properties. Relative compaction is the measure of the resulting engineering improvement. But design engineers need the allowable bearing capacity while the modulus of subgrade reaction is the primary input of modern foundation design software. The current research appraised a correlation between Relative Compaction ( ), Moisture Content ( ), and allowable bearing capacity ( ) and another correlation between , RC, MC, and modulus of subgrade reaction ( ). The test samples were extracted from each trial of the standard proctor test using purpose-built extraction tubes. Allowable bearing capacity has been determined by performing unconfined compression tests on the extracted tubes. The relationships have been established employing statistical analysis. It was noticed that soil samples at the lower moisture content (6-9%) show brittle failure before reaching the allowable strain. The soil samples having a moisture content of 10-14% exhibited shear failure, nearly simultaneous to the allowable strain. The soil samples having higher moisture content undergone a strain of 15% without showing the shear failure. A simple equation has also been appraised to determined Ks involving the three-input variable, i.e., , , and . Moderate correlations have been found to exist between the studied parameters, owing to some other variables' influence. Recommendations for future studies have been drawn to quantify the effect of identified parameters. Doi: 10.28991/cej-2020-03091606 Full Text: PDF

Experimental Study on the Modulus of Subgrade Reaction for Sandy Soil Improved by Grouting Materials

Many methods have been used for soil improvement at site, one of these methods is grouting. Cement grouted soils consist of particulate soil media and cementation agents. Such soils have been widely used to improve the shear strength and stiffness of weak soils and for preventing of water seepage through soils. The modulus of subgrade reaction may give a good indication about the soil bearing capacity and stiffness. This geotechnical parameter can be measured by using the plate load test. In this study, an experimental work is done to assess the improvement in the stiffness of sandy soils by injection two different cementing agents (cement and colloidal silica). The work includes plate loading tests with two different plate diameters (B= 150 and B= 250 mm). The effects of plate size, depth of the grouted zone (0-B and B-2B) as well as the effect of grouting material type on the performance of the grouted soil are investigated. The results show that the colloidal silica grout is more effective in increasing the modulus of sub grade reaction (ks) than the cement grout. Also, the use of plate with 150 mm diameter gives higher value of (ks) than that of 250 mm diameter. Furthermore, grout injection at depth (from 0 to B) gives a higher value of (ks) than that for deeper grouted zone.