Optimization of Argon Gas Metal Arc Welding Process Parameters with Regard to Tensile Strength for AISI 310 Stainless Steel Using Taguchi Technique

Gas metal arc welding (GMAW) is the leading process in the development of arc welding process for higher productivity and quality. In this study, the effect of process parameters of argon gas welding on the strength of T type welded joint of AISI 310 stainless steel is analyzed. The Taguchi technique is used to develop the experimental matrix and tensile strength of the welded joint is measured using experimental method and finite element method. Optimization of input parameter is performed for the maximum tensile strength of welded joint using ANOVA. The results showed that welding speed is the most significant factor affecting the tensile strength followed by voltage in argon gas metal arc welding (AGMAW) process. Argon gas welding process performance with regard to the tensile strength is optimized at voltage: 18.5 V, wire feed speed: 63 m/min and welding speed: 0.36 m/min.

A Review on Evaluation of MIG Welding Process Parameter by using MOORAS Method

This review paper focus on Parametric optimization in Metal inert gas welding by using MOORAS method. MIG is arc welding process. Parameters optimization can be done by Multi-objective optimization on basis of ratio analysis and analytical Heriachy process. Ranking of alternatives determine by attributes weight or related importance given between attributes and on the values of the selected attributes,MOORA method is very fast and robust. It needs minimum Mathematical calculations and calculations time. Review paper endeavor process to illustrate problem by MOORAS method.

Performance of weld bead profile during A-TIG welding on nitrogen alloyed stainless steel

Austenitic stainless steel (ASS) is widely fabricated by tungsten inert gas (TIG) welding for aesthetic look and superior mechanical properties while compared to other arc welding process. Hitherto, the limitation of this process is low depth of penetration and less productivity. To overcome this problem activated tungsten inert gas (A-TIG) welding process is employed as an alternative. In this investigation the welding performance of conventional TIG welding is compared with A-TIG process using TiO2 and SiO2 flux with respect to weld bead geometry. The experimental investigation on A-TIG welding of ASS-201 grade shows TiO2 flux helps in achieve higher penetration as compared to SiO2 flux. While welding with SiO2 the hardness in HAZ and weld region higher than that of TIG welding process.

Influence of the formulation of a flux-cored wire on the microstructure and hardness of welded metal

For this paper, the microstructure and hardness of the weld metal were investigated by conducting experiments with the flux cored arc welding process in underwater and air conditions. A rutile/oxidizing tubular wire was used, manufactured by the Robotics, Welding and Simulation Laboratory at Minas Gerais Federal University, especially for underwater wet welding. Underwater welds had a lower volumetric fraction of acicular ferrite in the weld metal compared to air welds. In the thermally affected zone, for both welds, there was a predominant formation of martensite. However, the grain size and width of the thermally affected zone of underwater welds are smaller. The hardness values shown correspond to the microstructure formed in the weld metal. On the other hand, in the region of the thermally affected zone, the hardness values were higher underwater welds, due to the smaller martensite grains presented.