Optimal design of mass timber panels as dynamic insulation: simulations of steady and transient heat exchange

Mass timber panels could be designed as heat exchangers for use in building envelopes. Fresh air, drawn through geometrically optimized channels in the panel, is pre-tempered with building heat that would otherwise be lost to the exterior via conduction. Recent experiments have shown that timber heat exchanging panels can approach U ~0.1 W/m2K – but there are potential limitations. The sizing correlations which predict panel geometry and steady heat exchange must be numerically calibrated for building-scale contexts, the heat-exchange efficiency must be verified virtually, and practical thresholds for transient response time must be determined. This study uses numerical simulations to investigate these factors for one design ‘case’ of timber panels, and establishes a methodology for studies of further cases.

The Design of Mass Timber Panels as Heat-Exchangers (Dynamic Insulation)

Mass timber products, together with careful forestry management, could help decarbonize the construction industry. These products must be long-lasting, to safely store atmospheric carbon for decades or centuries, and multi-functional, to displace materials and equipment that are emissions-intensive. This paper shows how to optimize mass timber panels as heat-exchangers, suggesting how to eliminate insulation while simplifying HVAC systems. Test panels measured the heat-exchange in steady and transient conditions, when the ventilation was driven by a fan or by thermal buoyancy. The total heat transfer was predicted accurately by theory in all cases. Further investigation is needed to understand the possible heat-recovery effects at the exterior surface.

Shape Memory Polymer Foam with Programmable Apertures

In this work, a novel type of polyester urethane urea (PEUU) foam is introduced. The foam was produced by reactive foaming using a mixture of poly(1,10–decamethylene adipate) diol and poly(1,4–butylene adipate) diol, 4,4′-diphenylmethane diisocyanate, 1,4–butanediol, diethanolamine and water as blowing agent. As determined by differential scanning calorimetry, the melting of the ester-based phases occurred at temperatures in between 25 °C and 61 °C, while the crystallization transition spread from 48 °C to 20 °C. The mechanical properties of the foam were simulated with the hyperplastic models Neo-Hookean and Ogden, whereby the latter showed a better agreement with the experimental data as evidenced by a Pearson correlation coefficient R² above 0.99. Once thermomechanically treated, the foam exhibited a maximum actuation of 13.7% in heating-cooling cycles under a constant external load. In turn, thermal cycling under load-free conditions resulted in an actuation of more than 10%. Good thermal insulation properties were demonstrated by thermal conductivities of 0.039 W·(m·K)−1 in the pristine state and 0.052 W·(m·K)−1 in a state after compression by 50%, respectively. Finally, three demonstrators were developed, which closed an aperture or opened it again simply by changing the temperature. The self-sufficient material behavior is particularly promising in the construction industry, where programmable air slots offer the prospect of a dynamic insulation system for an adaptive building envelope.

Buildings as a Global Carbon Sink? The Design of Mass Timber Panels as Heat-exchangers (Dynamic Insulation)

Mass timber products, together with careful forestry management, could help decarbonize the construction industry. These products must be long-lasting, to safely store atmospheric carbon for decades or centuries, and multi-functional, to displace materials and equipment that are emissions-intensive. This paper shows how to optimize mass timber panels as heat-exchangers, suggesting how to eliminate insulation while simplifying HVAC systems. Test panels measured the heat-exchange in steady and transient conditions, when the ventilation was driven by a fan or by thermal buoyancy. The total heatexchange was predicted accurately by theory in all cases. Further investigation is needed to understand the possible heat-recovery effects at the exterior surface.