Hydroformylation of 1-Dodecene with Water-Soluble Rhodium Catalysts with Bidentate Ligands in Multiphase Systems

ChemCatChem ◽  
2013 ◽  
Vol 5 (7) ◽  
pp. 1854-1862 ◽  
Author(s):  
Tobias Hamerla ◽  
Anke Rost ◽  
Yasemin Kasaka ◽  
Reinhard Schomäcker
Keyword(s):  
Water Soluble ◽  
Rhodium Catalysts ◽  
Bidentate Ligands ◽  
Multiphase Systems

scholarly journals Secondary organic aerosol formation from isoprene photooxidation during cloud condensation–evaporation cycles

2016 ◽  
Vol 16 (3) ◽  
pp. 1747-1760 ◽  
Author(s):  
L. Brégonzio-Rozier ◽  
C. Giorio ◽  
F. Siekmann ◽  
E. Pangui ◽  
S. B. Morales ◽  
...  
Keyword(s):  
Aqueous Phase ◽  
Mass Concentration ◽  
Secondary Organic Aerosol ◽  
Organic Aerosol ◽  
Water Soluble ◽  
Aerosol Formation ◽  
Multiphase Systems ◽  
Dry Conditions ◽  
Water Cloud ◽  
The Impact

Abstract. The impact of cloud events on isoprene secondary organic aerosol (SOA) formation has been studied from an isoprene ∕ NOx ∕ light system in an atmospheric simulation chamber. It was shown that the presence of a liquid water cloud leads to a faster and higher SOA formation than under dry conditions. When a cloud is generated early in the photooxidation reaction, before any SOA formation has occurred, a fast SOA formation is observed with mass yields ranging from 0.002 to 0.004. These yields are 2 and 4 times higher than those observed under dry conditions. When the cloud is generated at a later photooxidation stage, after isoprene SOA is stabilized at its maximum mass concentration, a rapid increase (by a factor of 2 or higher) of the SOA mass concentration is observed. The SOA chemical composition is influenced by cloud generation: the additional SOA formed during cloud events is composed of both organics and nitrate containing species. This SOA formation can be linked to the dissolution of water soluble volatile organic compounds (VOCs) in the aqueous phase and to further aqueous phase reactions. Cloud-induced SOA formation is experimentally demonstrated in this study, thus highlighting the importance of aqueous multiphase systems in atmospheric SOA formation estimations.

Homogeneous and biphasic oligomerization of terminal alkynes by some water soluble rhodium catalysts

1993 ◽  
Vol 85 (2) ◽  
pp. 153-162 ◽  
Author(s):  
Wael Baidossi ◽  
Nurith Goren ◽  
Jochanan Blum ◽  
Herbert Schumann ◽  
Holger Hemling
Keyword(s):  
Water Soluble ◽  
Rhodium Catalysts ◽  
Terminal Alkynes

Hydrogenation of acrylonitrile–butadiene copolymer latex using water-soluble rhodium catalysts

2013 ◽  
Vol 3 (10) ◽  
pp. 2689 ◽  
Author(s):  
Yin Liu ◽  
Hanmiroo Kim ◽  
Qinmin Pan ◽  
Garry L. Rempel
Keyword(s):  
Water Soluble ◽  
Rhodium Catalysts

scholarly journals Secondary Organic Aerosol formation from isoprene photooxidation during cloud condensation–evaporation cycles

2015 ◽  
Vol 15 (14) ◽  
pp. 20561-20596 ◽  
Author(s):  
L. Brégonzio-Rozier ◽  
C. Giorio ◽  
F. Siekmann ◽  
E. Pangui ◽  
S. B. Morales ◽  
...  
Keyword(s):  
Aqueous Phase ◽  
Mass Concentration ◽  
Secondary Organic Aerosol ◽  
Organic Aerosol ◽  
Water Soluble ◽  
Aerosol Formation ◽  
Multiphase Systems ◽  
Dry Conditions ◽  
Water Cloud ◽  
The Impact

Abstract. The impact of cloud events on isoprene secondary organic aerosol (SOA) formation has been studied from an isoprene/NOx/light system in an atmospheric simulation chamber. It was shown that the presence of a liquid water cloud leads to a faster and higher SOA formation than under dry conditions. When a cloud is generated early in the photooxidation reaction, before any SOA formation has occurred, a fast SOA formation is observed with mass yields ranging from 0.002 to 0.004. These yields are two and four times higher than those observed under dry conditions. When the cloud is generated at a later photooxidation stage, after isoprene SOA is stabilized at its maximum mass concentration, a rapid increase (by a factor of two or higher) of the SOA mass concentration is observed. The SOA chemical composition is influenced by cloud generation: the additional SOA formed during cloud events is composed of both organics and nitrate containing species. This SOA formation can be linked to water soluble volatile organic compounds (VOCs) dissolution in the aqueous phase and to further aqueous phase reactions. Cloud-induced SOA formation is experimentally demonstrated in this study, thus highlighting the importance of aqueous multiphase systems in atmospheric SOA formation estimations.

Hydroformylation of olefins with water-soluble rhodium catalysts in the presence of?-cyclodextrin

1991 ◽  
Vol 9 (1-2) ◽  
pp. 55-58 ◽  
Author(s):  
John R. Anderson ◽  
Eva M. Campi ◽  
W. Roy Jackson
Keyword(s):  
Water Soluble ◽  
Rhodium Catalysts

A Resorcinol-Formaldehyde Resin as an Embedding Material for Electron Microscopy of Membranes

1969 ◽  
Vol 27 ◽  
pp. 328-329 ◽  
Author(s):  
J. G. Robertson ◽  
D. F. Parsons
Keyword(s):  
Electron Microscopy ◽  
Osmium Tetroxide ◽  
Neutral Lipids ◽  
Lipid Extraction ◽  
Water Soluble ◽  
Formaldehyde Resin ◽  
Electron Microscope Autoradiography ◽  
Resorcinol Formaldehyde ◽  
Major Disadvantage ◽  
Cell Organization

The extraction of lipids from tissues during fixation and embedding for electron microscopy is widely recognized as a source of possible artifact, especially at the membrane level of cell organization. Lipid extraction is also a major disadvantage in electron microscope autoradiography of radioactive lipids, as in studies of the uptake of radioactive fatty acids by intestinal slices. Retention of lipids by fixation with osmium tetroxide is generally limited to glycolipids, phospholipids and highly unsaturated neutral lipids. Saturated neutral lipids and sterols tend to be easily extracted by organic dehydrating reagents prior to embedding. Retention of the more saturated lipids in embedded tissue might be achieved by developing new cross-linking reagents, by the use of highly water soluble embedding materials or by working at very low temperatures.

Ferritin Labeled Antibody Staining of Thin Sections

1969 ◽  
Vol 27 ◽  
pp. 420-421
Author(s):  
J. D. McLean ◽  
S. J. Singer
Keyword(s):  
Biological Material ◽  
Water Soluble ◽  
Thin Sections ◽  
Antibody Staining ◽  
Thin Sectioning ◽  
Ultrathin Sections

The successful application of ferritin labeled antibodies (F-A) to ultrathin sections of biological material has been hampered by two main difficulties. Firstly the normally used procedures for the preparation of material for thin sectioning often result in a loss of antigenicity. Secondly the polymers employed for embedding may non-specifically absorb the F-A. Our earlier use of cross-linked polyampholytes as embedding media partially overcame these problems. However the water-soluble monomers used for this method still extract many lipids from the material.

The Effect of Benzene on Bluegill Olfactory Lamellae

1985 ◽  
Vol 43 ◽  
pp. 574-575
Author(s):  
D.R. Mattie ◽  
J.W. Fisher
Keyword(s):  
Surface Morphology ◽  
Soluble Fraction ◽  
Lepomis Macrochirus ◽  
Sublethal Concentration ◽  
Water Soluble ◽  
Major Constituent ◽  
Jet Fuels ◽  
Aquatic Biota ◽  
Normal Surface ◽  
Cacodylate Buffer

Jet fuels such as JP-4 can be introduced into the environment and come in contact with aquatic biota in several ways. Studies in this laboratory have demonstrated JP-4 toxicity to fish. Benzene is the major constituent of the water soluble fraction of JP-4. The normal surface morphology of bluegill olfactory lamellae was examined in conjunction with electrophysiology experiments. There was no information regarding the ultrastructural and physiological responses of the olfactory epithelium of bluegills to acute benzene exposure.The purpose of this investigation was to determine the effects of benzene on the surface morphology of the nasal rosettes of the bluegill sunfish (Lepomis macrochirus). Bluegills were exposed to a sublethal concentration of 7.7±0.2ppm (+S.E.M.) benzene for five, ten or fourteen days. Nasal rosettes were fixed in 2.5% glutaraldehyde and 2.0% paraformaldehyde in 0.1M cacodylate buffer (pH 7.4) containing 1.25mM calcium chloride. Specimens were processed for scanning electron microscopy.

Sign in / Sign up

Export Citation Format

Share Document