Abstract
To evaluate the valves used in the nuclear power plants are working properly under the required conditions, the performance and capacity test should be performed. In the test system, the accumulator was employed to control the large amount of high pressure and high temperature steam generated in the boiler precisely. In the accumulating process, the steam is often condensed. In order to prevent condensation, it is needed to install heaters and preheat the accumulator. However, if the size of the accumulator becomes large, the installation of the heater may not be easy. Therefore, when the test is conducted, the system was preheated by the latent heat generated from the phase change. Insufficient thermal insulation may cause temperature differences and it can cause mechanical problems in the accumulator structure. If insulation is sufficient, the temperature difference is indicated by the height. As the cooled condensate moves downwards, the condensate is discharged by the drain valve control and the temperature difference of the structure can be disappeared. The results of this paper can be applied to the conceptualization of equipment that uses latent heat and for the design of high-precision steam experimental devices or the design of high-capacity steam utilization systems.
Numerical investigation of a vertical triplex‐tube latent heat storage/exchanger to achieve flexible operation of nuclear power plants
