Effects of drying and rewetting on soluble phosphorus and nitrogen in forest floors: An experiment with undisturbed columns

2017 ◽  
Vol 181 (2) ◽  
pp. 177-184 ◽  
Author(s):  
Annkathrin Hömberg ◽  
Egbert Matzner
1997 ◽  
Vol 35 (2-3) ◽  
pp. 131-138 ◽  
Author(s):  
Pirjo-Riitta Rantala ◽  
Hannu Wirola

The aim of the study was to determine if solid, slightly soluble compounds can be used as nutrient source in activated sludge treatment plants instead of liquid phosphoric acid. Four different solid materials were tested in lab-scale solubility tests to find compounds which are least soluble. Two materials were chosen for further studies: apatite and raw phosphate. The use of apatite and raw phosphate as nutrient source was studied in lab-scale activated sludge reactors along with a control reactor where phosphorus was added in liquid form. The phosphorus dosage, measured as elementary phosphorus, was the same for all three reactors. The reactors were fed with pre-clarified chemi-thermomechanical pulp mill (CTMP) wastewater. There were no significant differences in the reductions of organic matter between the three reactors. The mean effluent concentration of total phosphorus was 3 mg P/l in the control reactor and less than 1 mg P/1 in the other two reactors. The soluble phosphorus concentration was more than 2 mg P/l in the control reactor and less than 0.5 mg P/l in the other two. Apatite was an even better nutrient source than raw phosphate. Further lab-scale tests were conducted using two different grain sizes of apatite. No significant differences were found between the studied grain sizes (<0.074 mm and 0.074 mm-0.125 mm). Apatite was then used in full-scale at a CTMP-mill two different times. The experiments showed that the mean concentrations of phosphorus can be reduced radically by using apatite as a nutrient source instead of liquid phosphorus. Solid phosphorus compounds are a viable alternative to reduce the phosphorus load from forest industry wastewater treatment plants.


2021 ◽  
Vol 13 (13) ◽  
pp. 7301
Author(s):  
Marcin K. Widomski ◽  
Anna Musz-Pomorska ◽  
Wojciech Franus

This paper presents research considering hydraulic as well as swelling and shrinkage characteristics of potential recycled fine particle materials for compacted clay liner for sustainable landfills. Five locally available clay soils mixed with 10% (by mass) of NaP1 recycled zeolite were tested. The performed analysis was based on determined plasticity, cation exchange capacity, coefficient of saturated hydraulic conductivity after compaction, several shrinkage and swelling characteristics as well as, finally, saturated hydraulic conductivity after three cycles of drying and rewetting of tested specimens and the reference samples. The obtained results showed that addition of zeolite to clay soils allowed reduction in their saturated hydraulic conductivity to meet the required threshold (≤1 × 10−9 m/s) of sealing capabilities for compacted clay liner. On the other hand, an increase in plasticity, swelling, and in several cases in shrinkage, of the clay–zeolite mixture was observed. Finally, none of the tested mixtures was able to sustain its sealing capabilities after three cycles of drying and rewetting. Thus, the studied clayey soils mixed with sustainable recycled zeolite were assessed as promising materials for compacted liner construction. However, the liner should be operated carefully to avoid extensive dissication and cracking.


Sign in / Sign up

Export Citation Format

Share Document