Phenomenological quantum confinement models for excitons and phonons applied to photoluminescence and Raman spectra of silicon nanocrystals

2011 ◽  
Vol 248 (11) ◽  
pp. 2724-2727 ◽  
Author(s):  
M. Dossot ◽  
P. Miska ◽  
H. Rinnert ◽  
M. Vergnat ◽  
B. Humbert
Author(s):  
H.S. Mavi ◽  
S. Rath ◽  
Arun Shukla

Laser-induced etching of silicon is used to generate silicon nanocrystals. The pore structure depends on the substrate type and etching laser wavelength. Porous silicon (PS) samples prepared by Nd:YAG laser (1.16 eV) etching of n-type substrate showed a fairly uniform and highly interconnected network of nearly circular pores separated by thin columnar boundaries, while no circular pits were produced by argon- ion laser (2.41 eV) etching under similar conditions. The size and size distribution of the nanocrystals are investigated by Raman and photoluminescence spectroscopies and analyzed within the framework of quantum confinement models.


1999 ◽  
Vol 588 ◽  
Author(s):  
S. Manotas ◽  
F. Agulló-Rueda ◽  
J. D. Moreno ◽  
R. J. Martín-Palma ◽  
R. Guerrero-Lemus ◽  
...  

AbstractWe have measured micro-photoluminescence (PL) and micro-Raman spectra on the cross section of porous silicon multilayers to sample different layer depths. We find noticeable differences in the spectra of layers with different porosity, as expected from the quantum confinement of electrons and phonons in silicon nanocrystals with different average sizes. The PL emission band gets stronger, blue shifts, and narrows at the high porosity layers. The average size can be estimated from the shift. The Raman phonon band at 520 cm−1 weakens and broadens asymmetrically towards the low energy side. The line shape can be related quantitatively with the average size by the phonon confinement model. To get a good agreement with the model we add a band at around 480 cm−1, which has been attributed to amorphous silicon. We also have to leave as free parameters the bulk silicon phonon frequency and its line width, which depend on temperature and stress. We reduced laser power to eliminate heating effects. Then we use the change of frequency with depth to monitor the stress. At the interface with the substrate we find a compressive stress in excess of 10 kbar, which agrees with the reported lattice mismatch. Finally, average sizes are larger than those estimated from PL.


2002 ◽  
Vol 80 (25) ◽  
pp. 4834-4836 ◽  
Author(s):  
G. Ledoux ◽  
J. Gong ◽  
F. Huisken ◽  
O. Guillois ◽  
C. Reynaud

2002 ◽  
Vol 738 ◽  
Author(s):  
M. H. Wu ◽  
R. Mu ◽  
A. Ueda ◽  
D. O. Henderson ◽  
B. Vlahovic

ABSTRACTPulsed laser ablation has been used to produce silicon nanocrystals. Variation of the laser fluence, backing gas type and pressure result in nanocrystals with controllable size distributions. Properties of nanocrystals produced with this method also depend on the distance of the nanocrystal from the center of the laser plume. Correlated atomic force microscopy and in-situ micro-Raman measurements confirm that particle size decreases as distance from the plume center increases. Silicon peaks in the micro raman spectra taken at increasing distance from plume center show considerable differences in both center energy and width. Confocal micro raman spectra from thicker (> 10 micron) samples show little variation with depth, in contrast with porous silicon samples.


2000 ◽  
Vol 87 (11) ◽  
pp. 8165-8173 ◽  
Author(s):  
Vincenzo Vinciguerra ◽  
Giorgia Franzò ◽  
Francesco Priolo ◽  
Fabio Iacona ◽  
Corrado Spinella

2009 ◽  
Vol 41 (4) ◽  
pp. 668-670 ◽  
Author(s):  
Julien Derr ◽  
Kerry Dunn ◽  
Daria Riabinina ◽  
François Martin ◽  
Mohamed Chaker ◽  
...  

2021 ◽  
Vol 55 (1) ◽  
pp. 61-65
Author(s):  
M. B. Gongalsky ◽  
U. A. Tsurikova ◽  
K. A. Gonchar ◽  
G. Z. Gvindgiliiia ◽  
L. A. Osminkina

Sign in / Sign up

Export Citation Format

Share Document