Location and capacity determination of charging station based on electric vehicle charging behavior analysis

Author(s):  
Weitao Cao ◽  
Youhong Wan ◽  
Lu Wang ◽  
Yue Wu
2021 ◽  
Vol 13 (11) ◽  
pp. 6163
Author(s):  
Yongyi Huang ◽  
Atsushi Yona ◽  
Hiroshi Takahashi ◽  
Ashraf Mohamed Hemeida ◽  
Paras Mandal ◽  
...  

Electric vehicle charging station have become an urgent need in many communities around the world, due to the increase of using electric vehicles over conventional vehicles. In addition, establishment of charging stations, and the grid impact of household photovoltaic power generation would reduce the feed-in tariff. These two factors are considered to propose setting up charging stations at convenience stores, which would enable the electric energy to be shared between locations. Charging stations could collect excess photovoltaic energy from homes and market it to electric vehicles. This article examines vehicle travel time, basic household energy demand, and the electricity consumption status of Okinawa city as a whole to model the operation of an electric vehicle charging station for a year. The entire program is optimized using MATLAB mixed integer linear programming (MILP) toolbox. The findings demonstrate that a profit could be achieved under the principle of ensuring the charging station’s stable service. Household photovoltaic power generation and electric vehicles are highly dependent on energy sharing between regions. The convenience store charging station service strategy suggested gives a solution to the future issues.


2021 ◽  
Vol 12 (3) ◽  
pp. 107
Author(s):  
Tao Chen ◽  
Peng Fu ◽  
Xiaojiao Chen ◽  
Sheng Dou ◽  
Liansheng Huang ◽  
...  

This paper presents a systematic structure and a control strategy for the electric vehicle charging station. The system uses a three-phase three-level neutral point clamped (NPC) rectifier to drive multiple three-phase three-level NPC converters to provide electric energy for electric vehicles. This topology can realize the single-phase AC mode, three-phase AC mode, and DC mode by adding some switches to meet different charging requirements. In the case of multiple electric vehicles charging simultaneously, a system optimization control algorithm is adopted to minimize DC-bus current fluctuation by analyzing and reconstructing the DC-bus current in various charging modes. This algorithm uses the genetic algorithm (ga) as the core of computing and reduces the number of change parameter variables within a limited range. The DC-bus current fluctuation is still minimal. The charging station system structure and the proposed system-level optimization control algorithm can improve the DC-side current stability through model calculation and simulation verification.


Author(s):  
Venkatesh Boddapati ◽  
S Arul Daniel

Mobility has been changing precipitously in recent years. With the increasing number of electric vehicles (EV), travel-sharing continues to grow, and ultimately, autonomous vehicles (AV) move into municipal fleets. These changes require a new, distributed, digitalised energy system, maintenance, and growing electrification in transportation. This paper proposes the designing of an Electric Vehicle Charging Station (EVCS) by using hybrid energy sources such as solar PV, wind, and diesel generator. The proposed system is mathematically modelled and designed using the Hybrid Optimization Model for Multiple Energy Resources (HOMER). The system is analysed and assessed in both autonomous mode and grid-connected mode of operation. The optimum sizing, energy yields of the system in each case is elaborated, and the best configuration is found for design. The variations in Levelized Cost Of the Energy (LCOE), Net Present Cost (NPC), initial cost, and operating cost of the various configuration are presented. From the results, it is observed that the grid-connected EVCS is more economical than the autonomous EVCS. Further, a sensitivity analysis of the EVCS is also performed.


Sign in / Sign up

Export Citation Format

Share Document