Intracortical Electrodes

2020 ◽  
pp. 67-94
Author(s):  
Meijian Wang ◽  
Liang Guo
2015 ◽  
Author(s):  
Peter Henderson

Recent developments in neural interfaces show that it is possible to have fine control of a robotic prosthetic by interfacing with the motor cortex of the human brain. Development of long term systems for this purpose is a challenging task with many different possibilities. Intracortical implants have shown the most promise in providing enough signal selectivity and throughput for complex control systems with many degrees of freedom. Intracortical systems generally fall into two categories: MEMS devices and bundle of wire systems. While both show promise, MEMS systems have been greatly popularized due to their reproducibility. In particular, the Michigan probe and Utah microarray are often used as a base for construction of more complex intracortical systems. However, these systems still carry many downsides. Their long-term viability is questionable, with mixed results. The effects of damage from implantation are still inconclusive and immune responses remain a problem for long-term use. While there is some promising research in the use of bioactive molecules and biocompatible materials to prevent immune responses, more controlled study is needed before intracortical systems become widespread.


Author(s):  
Taylor Ware ◽  
Dustin Simon ◽  
Clive Liu ◽  
Tabassum Musa ◽  
Srikanth Vasudevan ◽  
...  

2015 ◽  
Vol 16 ◽  
pp. S38-S39
Author(s):  
L. Garcia-Larrea ◽  
S. Mazza ◽  
C. Perchet ◽  
L. Claude ◽  
M. Magnin ◽  
...  

2014 ◽  
Vol 7 (1) ◽  
pp. 1-6 ◽  
Author(s):  
Jitte Groothuis ◽  
Nick F. Ramsey ◽  
Geert M.J. Ramakers ◽  
Geoffrey van der Plasse

2019 ◽  
Vol 16 (4) ◽  
pp. 046005 ◽  
Author(s):  
Jessica D Falcone ◽  
Harbaljit S Sohal ◽  
Themis R Kyriakides ◽  
Ravi V Bellamkonda

2021 ◽  
Vol 15 ◽  
Author(s):  
Ramya L. Saldanha ◽  
Morgan E. Urdaneta ◽  
Kevin J. Otto

Intracortical microelectrodes are neuroprosthetic devices used in brain-machine interfaces to both record and stimulate neural activity in the brain. These technologies have been improved by advances in microfabrication, which have led to the creation of subcellular and high-density microelectrodes. The greater number of independent stimulation channels in these devices allows for improved neuromodulation selectivity, compared to single-site microelectrodes. Elements of electrode design such as electrode-site placement can influence the long-term performance of neuroprostheses. Previous studies have shown that electrode-sites placed on the edge of a planar microelectrode have greater chronic recording functionality than sites placed in the center. However, the effect of electrode-site placement on long-term intracortical microstimulation (ICMS) is still unknown. Here, we show that, in rats chronically implanted with custom-made planar silicon microelectrodes, electrode-sites on the tip of the device outperformed those on both the edge and center in terms of the effect per charge delivered, though there is still a slight advantage to using edge sites over center sites for ICMS. Longitudinal analysis of ICMS detection thresholds over a 16-week period revealed that while all sites followed a similar trend over time, the tip and edge sites consistently elicited the behavioral response with less charge compared to center sites. Furthermore, we quantified channel activity over time and found that edge sites remained more active than center sites over time, though the rate of decay of active sites for center and edge sites was comparable. Our results demonstrate that electrode-site placement plays an important role in the long-term stability of intracortical microstimulation and could be a potential factor to consider in the design of future intracortical electrodes.


Author(s):  
Jessica D. Falcone ◽  
Sheridan L. Carroll ◽  
Tarun Saxena ◽  
Dev Mandavia ◽  
Alexus Clark ◽  
...  

Micromachines ◽  
2018 ◽  
Vol 9 (10) ◽  
pp. 500 ◽  
Author(s):  
Allison Stiller ◽  
Joshua Usoro ◽  
Christopher Frewin ◽  
Vindhya Danda ◽  
Melanie Ecker ◽  
...  

Current intracortical probe technology is limited in clinical implementation due to the short functional lifetime of implanted devices. Devices often fail several months to years post-implantation, likely due to the chronic immune response characterized by glial scarring and neuronal dieback. It has been demonstrated that this neuroinflammatory response is influenced by the mechanical mismatch between stiff devices and the soft brain tissue, spurring interest in the use of softer polymer materials for probe encapsulation. Here, we demonstrate stable recordings and electrochemical properties obtained from fully encapsulated shape memory polymer (SMP) intracortical electrodes implanted in the rat motor cortex for 13 weeks. SMPs are a class of material that exhibit modulus changes when exposed to specific conditions. The formulation used in these devices softens by an order of magnitude after implantation compared to its dry, room-temperature modulus of ~2 GPa.


Sign in / Sign up

Export Citation Format

Share Document