Onset of Shear Layer Instability in Shock Diffraction Processes

Author(s):  
H. Kleine ◽  
I. Klioutchnikov ◽  
H. Olivier
2003 ◽  
Vol 10 (3) ◽  
pp. 281-288 ◽  
Author(s):  
F. Moisy ◽  
T. Pasutto ◽  
M. Rabaud

Abstract. The instability patterns in the flow between counter-rotating disks (radius to height ratio R/h from 3.8 to 20.9) are investigated experimentally by means of visualization and Particle Image Velocimetry. We restrict ourselves to the situation where the boundary layers remain stable, focusing on the shear layer instability that occurs only in the counter-rotating regime. The associated pattern is a combination of a circular chain of vortices, as observed by Lopez et al. (2002) at low aspect ratio, surrounded by a set of spiral arms, first described by Gauthier et al. (2002) in the case of high aspect ratio. Stability curve and critical modes are measured for the whole range of aspect ratios. From the measurement of a local Reynolds number based on the shear layer thickness, evidence is given that a free shear layer instability, with only weak curvature effect, is responsible for the observed patterns. Accordingly, the number of vortices is shown to scale as the shear layer radius, which results from the competition between the centrifugal effects of each disk.


2011 ◽  
Vol 133 (8) ◽  
Author(s):  
Michael Bishop ◽  
Serhiy Yarusevych

The effect of wall streamlining on flow development over a circular cylinder was investigated experimentally in an adaptive-wall wind tunnel. Experiments were carried out for a Reynolds number of 57,000 and three blockage ratios of 5%, 8%, and 17%. Three test section wall configurations were investigated, namely, geometrically straight walls (GSW), aerodynamically straight walls (ASW), and streamlined walls (SLW). The results show that solid blockage effects are evident in cylinder surface pressure distributions for the GSW and ASW configurations, manifested by an increased peak suction and base suction. Upon streamlining the walls, pressure distributions for each blockage ratio investigated closely match distributions expected for low blockage ratios. Wake blockage limits wake growth in the GSW configuration at 7.75 and 15 diameters downstream of the cylinder for blockages of 17% and 8%, respectively. This adverse effect can be rectified by streamlining the walls, with the resulting wake width development matching that expected for low blockage ratios. Wake vortex shedding frequency and shear layer instability frequency increase in the GSW and ASW configurations with increasing blockage ratio. The observed invariance of the near wake width with wall configuration suggests that the frequency increase is caused by the increased velocity due to solid blockage effects. For all the blockage ratios investigated, this increase is rectified in the SLW configuration, with the resulting Strouhal numbers of about 0.19 matching that expected for low blockage ratios at the corresponding Reynolds number. Blockage effects on the shear layer instability frequency are also successfully mitigated by streamlining the walls.


2015 ◽  
Vol 27 (11) ◽  
pp. 112103 ◽  
Author(s):  
Matthieu A. André ◽  
Philippe M. Bardet

2004 ◽  
Vol 2004 (0) ◽  
pp. 209
Author(s):  
Masataka INOUE ◽  
Kazuhiro ITOH ◽  
Hiroshige KUMAMARU ◽  
Yutaka KUKITA

1986 ◽  
Vol 163 ◽  
pp. 149-169 ◽  
Author(s):  
Yasuharu Nakamura ◽  
Masamichi Nakashima

This is an experimental investigation of vortex excitation of prisms with elongated rectangular, H- and [vdash ]-shaped cross-sections, where the depth parallel to the flow is much greater than the height perpendicular to the flow. Measurements are made of free oscillations in a wind tunnel and flow visualizations in a water tank. The flow around elongated bluff prisms is dominated by the impinging-shear- layer instability where the separated shear layers become unstable in the presence of different kinds of shape of the rear part of the cross-section, which may include sharp trailing edges. The two unstable shear layers interact with each other when they meet together downstream of the prism, thereby forming Kármán vortices with the same frequency of oscillation. The former impinging-shear-layer instability is largely responsible for vortex excitation of elongated bluff prisms.


Author(s):  
Michael Bishop ◽  
Serhiy Yarusevych

The effect of wall streamlining on flow development over a circular cylinder was investigated experimentally in an adaptive-wall wind tunnel. Experiments were carried out for a Reynolds number of 57,000 and three blockage ratios of 5%, 8%, and 17%. Three test section wall configurations were investigated, namely, geometrically straight walls (GSW), aerodynamically straight walls (ASW), and streamlined walls (SLW). The results show that solid blockage effects are clearly evident in cylinder surface pressure distributions for the GSW and ASW configurations, manifested by an increased peak suction and base suction. Upon streamlining the walls, pressure distributions for each blockage ratio investigated closely match distributions expected for low blockage ratios. Wake blockage limits wake growth in the GSW configuration at 7.75 and 15 diameters downstream of the cylinder for blockages of 17% and 8%, respectively. This adverse effect can be rectified by streamlining the walls, with the resulting wake width development matching that expected for low blockage ratios. Wake vortex shedding frequency and shear layer instability frequency increase in the GSW and ASW configurations with increasing blockage ratio. The observed invariance of the near wake width with wall configuration suggests that the frequency increase is caused by the increased velocity due to solid blockage effects. For all the blockage ratios investigated, this increase is rectified in the SLW configuration, with the resulting Strouhal numbers of about 0.19 matching that expected for low blockage ratios at the corresponding Reynolds number. Blockage effects on the shear layer instability frequency are also successfully mitigated by streamlining the walls.


Sign in / Sign up

Export Citation Format

Share Document