Pore Network Modeling from Multi-scale Imaging Using Multiple-Point Statistics

2017 ◽  
pp. 475-485
Author(s):  
T. Chugunova ◽  
H. Berthet
Keyword(s):  
Network Modeling ◽  
Pore Network ◽  
Multiple Point ◽  
Pore Network Modeling ◽  
Multiple Point Statistics ◽  
Multi Scale

Pore Network Modeling of a Polymer Flooding Microscopic Seepage Mechanism

2011 ◽  
Vol 29 (17) ◽  
pp. 1803-1810 ◽  
Author(s):  
C. Z. Sun ◽  
H. Q. Jiang ◽  
J. J. Li ◽  
S. J. Ye
Keyword(s):  
Network Modeling ◽  
Pore Network ◽  
Polymer Flooding ◽  
Pore Network Modeling

Relationship between Residual Saturations and Wettability using Pore-Network Modeling

2021 ◽  
Author(s):  
Prakash Purswani ◽  
Russell T. Johns ◽  
Zuleima T. Karpyn
Keyword(s):  
Contact Angle ◽  
Oil Recovery ◽  
Network Modeling ◽  
Pore Network ◽  
Residual Oil ◽  
Residual Saturation ◽  
Oil Saturation ◽  
Pore Network Modeling ◽  
Residual Oil Saturation ◽  
Eor Processes

Abstract The relationship between residual saturation and wettability is critical for modeling enhanced oil recovery (EOR) processes. The wetting state of a core is often quantified through Amott indices, which are estimated from the ratio of the saturation fraction that flows spontaneously to the total saturation change that occurs due to spontaneous flow and forced injection. Coreflooding experiments have shown that residual oil saturation trends against wettability indices typically show a minimum around mixed-wet conditions. Amott indices, however, provides an average measure of wettability (contact angle), which are intrinsically dependent on a variety of factors such as the initial oil saturation, aging conditions, etc. Thus, the use of Amott indices could potentially cloud the observed trends of residual saturation with wettability. Using pore network modeling (PNM), we show that residual oil saturation varies monotonically with the contact angle, which is a direct measure of wettability. That is, for fixed initial oil saturation, the residual oil saturation decreases monotonically as the reservoir becomes more water-wet (decreasing contact angle). Further, calculation of Amott indices for the PNM data sets show that a plot of the residual oil saturation versus Amott indices also shows this monotonic trend, but only if the initial oil saturation is kept fixed. Thus, for the cases presented here, we show that there is no minimum residual saturation at mixed-wet conditions as wettability changes. This can have important implications for low salinity waterflooding or other EOR processes where wettability is altered.

scholarly journals Pore-network modeling and determination of rock and two-phase fluid flow properties

2021 ◽  
Vol 143 (3) ◽  
pp. 106-114
Author(s):  
Zh.K. Akasheva ◽  
◽  
D.A. Bolysbek ◽  
B.K. Assilbekov ◽  
A.K. Yergesh ◽  
...  
Keyword(s):  
Fluid Flow ◽  
Network Modeling ◽  
Pore Network ◽  
Flow Properties ◽  
Two Phase ◽  
Pore Network Modeling ◽  
Phase Fluid

scholarly journals Droplet Imbibition into Paper Coating Layer: Pore-Network Modeling Simulation

2018 ◽  
Vol 125 (2) ◽  
pp. 239-258 ◽  
Author(s):  
X. Yin ◽  
H. Aslannejad ◽  
E. T. de Vries ◽  
A. Raoof ◽  
S. M. Hassanizadeh
Keyword(s):  
Coating Layer ◽  
Network Modeling ◽  
Pore Network ◽  
Paper Coating ◽  
Pore Network Modeling ◽  
Modeling Simulation
Sign in / Sign up

Export Citation Format

Share Document