Computer Simulation of Hydrodynamic Interactions in Fiber Suspensions

Author(s):  
R. Shanker ◽  
J. W. Gillespie ◽  
S. I. Güçeri
Author(s):  
Dongdong Zhang ◽  
Douglas E. Smith ◽  
David A. Jack ◽  
Stephen Montgomery-Smith

This paper studies the rheological properties of a semi-dilute fiber suspension for short fiber reinforced composite materials processing. For industrial applications, the volume fraction of short fibers could be large for semi-dilute and concentrated fiber suspensions. Therefore, fiber-fiber interactions consisting of hydrodynamic interactions and direct mechanical contacts could affect fiber orientations and thus the rate of fiber alignment in the manufacturing processing. In this paper, we study the semi-dilute fiber suspensions, i.e. the gap between fibers becomes closer, and hydrodynamic interactions becomes stronger, but the physical/mechanical contacts are still rare. We develop a three-dimensional finite element approach for simulating the motions of multiple fibers in low-Reynolds-number flows typical of polymer melt flow. We extend our earlier single fiber model to consider hydrodynamic interactions between fibers. This approach computes the hydrodynamic forces and torques on fibers by solving governing equations of motion in fluid. The hydrodynamic forces and torques result from two scenarios: gross fluid motion and hydrodynamic interactions from other fibers. Our approach seeks fibers’ velocities that zero the hydrodynamic torques and forces acting on the fibers by the surrounding fluid. Fiber motions are then computed using a Runge-Kutta approach to update fiber positions and orientations as a function of time. This method is quite general and allows for solving multiple fiber suspensions in complex fluids. Examples with fibers having various starting positions and orientations are considered and compared with Jeffery’s single fiber solution (1922). Meanwhile, we study the effect of the presence of a bounded wall on fiber motions, which is ignored in Jeffery’s original work. The possible reasons why fiber motions observed in experiments align slower than those predicted by Jeffery’s theory are discussed in this paper.


Author(s):  
Kiyomichi Nakai ◽  
Yusuke Isobe ◽  
Chiken Kinoshita ◽  
Kazutoshi Shinohara

Induced spinodal decomposition under electron irradiation in a Ni-Au alloy has been investigated with respect to its basic mechanism and confirmed to be caused by the relaxation of coherent strain associated with modulated structure. Modulation of white-dots on structure images of modulated structure due to high-resolution electron microscopy is reduced with irradiation. In this paper the atom arrangement of the modulated structure is confirmed with computer simulation on the structure images, and the relaxation of the coherent strain is concluded to be due to the reduction of phase-modulation.Structure images of three-dimensional modulated structure along <100> were taken with the JEM-4000EX high-resolution electron microscope at the HVEM Laboratory, Kyushu University. The transmitted beam and four 200 reflections with their satellites from the modulated structure in an fee Ni-30.0at%Au alloy under illumination of 400keV electrons were used for the structure images under a condition of the spherical aberration constant of the objective lens, Cs = 1mm, the divergence of the beam, α = 3 × 10-4 rad, underfocus, Δf ≃ -50nm and specimen thickness, t ≃ 15nm. The CIHRTEM code was used for the simulation of the structure image.


2019 ◽  
Vol 3 (6) ◽  
pp. 723-729
Author(s):  
Roslyn Gleadow ◽  
Jim Hanan ◽  
Alan Dorin

Food security and the sustainability of native ecosystems depends on plant-insect interactions in countless ways. Recently reported rapid and immense declines in insect numbers due to climate change, the use of pesticides and herbicides, the introduction of agricultural monocultures, and the destruction of insect native habitat, are all potential contributors to this grave situation. Some researchers are working towards a future where natural insect pollinators might be replaced with free-flying robotic bees, an ecologically problematic proposal. We argue instead that creating environments that are friendly to bees and exploring the use of other species for pollination and bio-control, particularly in non-European countries, are more ecologically sound approaches. The computer simulation of insect-plant interactions is a far more measured application of technology that may assist in managing, or averting, ‘Insect Armageddon' from both practical and ethical viewpoints.


1978 ◽  
Vol 23 (9) ◽  
pp. 649-650
Author(s):  
ARTHUR M. FARLEY
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document