Design Improvement of Blade-Less Wind Generator

2021 ◽  
pp. 805-813
Author(s):  
D. Tejas ◽  
Shefali Jagwani
2019 ◽  
Vol 2 (1) ◽  
pp. 8-16 ◽  
Author(s):  
P. A. Khlyupin ◽  
G. N. Ispulaeva

Introduction: The co-authors provide an overview of the main types of wind turbines and power generators installed into wind energy devices, as well as advanced technological solutions. The co-authors have identified the principal strengths and weaknesses of existing wind power generators, if applied as alternative energy sources. The co-authors have proven the need to develop an algorithm for the selection of a wind generator-based autonomous power supply system in the course of designing windmill farms in Russia. Methods: The co-authors have analyzed several types of wind turbines and power generators. Results and discussions: The algorithm for the selection of a wind generator-based autonomous power supply system is presented as a first approximation. Conclusion: The emerging algorithm enables designers to develop an effective wind generator-based autonomous power supply system.


Author(s):  
D.Yu. Serikov ◽  
◽  
V.Yu. Bliznyukov ◽  
Yu.N. Pilnik ◽  

Author(s):  
K.S. Klen ◽  
◽  
M.K. Yaremenko ◽  
V.Ya. Zhuykov ◽  
◽  
...  

The article analyzes the influence of wind speed prediction error on the size of the controlled operation zone of the storage. The equation for calculating the power at the output of the wind generator according to the known values of wind speed is given. It is shown that when the wind speed prediction error reaches a value of 20%, the controlled operation zone of the storage disappears. The necessity of comparing prediction methods with different data discreteness to ensure the minimum possible prediction error and determining the influence of data discreteness on the error is substantiated. The equations of the "predictor-corrector" scheme for the Adams, Heming, and Milne methods are given. Newton's second interpolation formula for interpolation/extrapolation is given at the end of the data table. The average relative error of MARE was used to assess the accuracy of the prediction. It is shown that the prediction error is smaller when using data with less discreteness. It is shown that when using the Adams method with a prediction horizon of up to 30 min, within ± 34% of the average energy value, the drive can be controlled or discharged in a controlled manner. References 13, figures 2, tables 3.


Author(s):  
Ivan Kabardin ◽  
Igor Naumov ◽  
R Mikelson ◽  
K Velte
Keyword(s):  

2005 ◽  
Vol 1 (03) ◽  
pp. 453-457
Author(s):  
S. Martín ◽  
◽  
M.P. Comech ◽  
S. Borroy ◽  
M. García-Gracia

2020 ◽  
Vol 4 (4) ◽  
pp. 56-63
Author(s):  
Victor N. ANTIPOV ◽  
◽  
Andrey D. GROZOV ◽  
Anna V. IVANOVA ◽  
◽  
...  

Author(s):  
Stefany Kariny dos Santos de Souza Queiroz ◽  
Pedro Celestino Neto ◽  
Isac Barbosa de Almeida ◽  
Clayton Antonio de Oliveira ◽  
Idalmir de Souza Queiroz Júnior

Author(s):  
Marie-Pascale Chagny ◽  
John A. Naoum

Abstract Over the years, failures induced by an electrostatic discharge (ESD) have become a major concern for semiconductor manufacturers and electronic equipment makers. The ESD events that cause destructive failures have been studied extensively [1, 2]. However, not all ESD events cause permanent damage. Some events lead to recoverable failures that disrupt system functionality only temporarily (e.g. reboot, lockup, and loss of data). These recoverable failures are not as well understood as the ones causing permanent damage and tend to be ignored in the ESD literature [3, 4]. This paper analyzes and characterizes how these recoverable failures affect computer systems. An experimental methodology is developed to characterize the sensitivity of motherboards to ESD by simulating the systemlevel ESD events induced by computer users. The manuscript presents a case study where this methodology was used to evaluate the robustness of desktop computers to ESD. The method helped isolate several weak nets contributing to the failures and identified a design improvement. The result was that the robustness of the systems improved by a factor of 2.


Sign in / Sign up

Export Citation Format

Share Document