Universal mean velocity profile in the jet part of the turbulent boundary layer

1974 ◽  
Vol 27 (1) ◽  
pp. 867-870 ◽  
Author(s):  
A. N. Boiko ◽  
L. N. Dymant ◽  
V. M. Eroshenko
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Mean Velocity

A Model for Velocity Profile in Turbulent Boundary Layer with Drag Reducing Surfactants

2005 ◽  
Vol 15 (3) ◽  
pp. 152-159 ◽  
Author(s):  
A. Krope ◽  
J. Krope ◽  
L.C. Lipus
Keyword(s):  
Numerical Simulation ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
General Problem ◽  
Frictional Resistance ◽  
Mixing Length ◽  
Mean Velocity ◽  
Pipe Section ◽  
Turbulent Water

Abstract A new model for mean velocity profile of turbulent water flow with added drag-reducing surfactants is presented in this paper. The general problem of drag due to frictional resistance is reviewed and drag reduction by the addition of polymers or surfactants is introduced. The model bases on modified Prandtl's mixing length hypothesis and includes three parameters, which depend on additives and can be evaluated by numerical simulation from experimental datasets. The advantage of the model in comparison with previously reported models is that it gives uniform curve for whole pipe section and can be determined for a new surfactant with less necessary measurements. The use of the model is demonstrated for surfactant Habon-G as an example.

The Effects of Surface Roughness on the Mean Velocity Profile in a Turbulent Boundary Layer

2002 ◽  
Vol 124 (3) ◽  
pp. 664-670 ◽  
Author(s):  
Donald J. Bergstrom ◽  
Nathan A. Kotey ◽  
Mark F. Tachie
Keyword(s):  
Boundary Layer ◽  
Surface Roughness ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Friction Velocity ◽  
Outer Region ◽  
Stream Velocity ◽  
Mean Velocity ◽  
Outer Flow ◽  
The Mean

Experimental measurements of the mean velocity profile in a canonical turbulent boundary layer are obtained for four different surface roughness conditions, as well as a smooth wall, at moderate Reynolds numbers in a wind tunnel. The mean streamwise velocity component is fitted to a correlation which allows both the strength of the wake, Π, and friction velocity, Uτ, to vary. The results show that the type of surface roughness affects the mean defect profile in the outer region of the turbulent boundary layer, as well as determining the value of the skin friction. The defect profiles normalized by the friction velocity were approximately independent of Reynolds number, while those normalized using the free stream velocity were not. The fact that the outer flow is significantly affected by the specific roughness characteristics at the wall implies that rough wall boundary layers are more complex than the wall similarity hypothesis would allow.

scholarly journals On the generation of the mean velocity profile for turbulent boundary layers with pressure gradient under equilibrium conditions

2012 ◽  
Vol 116 (1180) ◽  
pp. 569-598 ◽  
Author(s):  
A. Rona ◽  
M. Monti ◽  
C. Airiau
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Pressure Gradient ◽  
Fluid Dynamic ◽  
Predictive Ability ◽  
Adverse Pressure Gradient ◽  
Computational Domain ◽  
Mean Velocity ◽  
Number Range

AbstractThe generation of a fully turbulent boundary layer profile is investigated using analytical and numerical methods over the Reynolds number range 422 ≤ Reθ≤ 31,000. The numerical method uses a new mixing length blending function. The predictions are validated against reference wind tunnel measurements under zero streamwise pressure gradient. The methods are then tested for low and moderate adverse pressure gradients. Comparison against experiment and DNS data show a good predictive ability under zero pressure gradient and moderate adverse pressure gradient, with both methods providing a complete velocity profile through the viscous sub-layer down to the wall. These methods are useful computational fluid dynamic tools for generating an equilibrium thick turbulent boundary layer at the computational domain inflow.

scholarly journals The law of the wake in the turbulent boundary layer

1956 ◽  
Vol 1 (2) ◽  
pp. 191-226 ◽  
Author(s):  
Donald Coles
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Three Dimensional ◽  
Shearing Stress ◽  
Universal Functions ◽  
Mean Velocity ◽  
Law Of The Wall ◽  
The Mean ◽  
The Law

After an extensive survey of mean-velocity profile measurements in various two-dimensional incompressible turbulent boundary-layer flows, it is proposed to represent the profile by a linear combination of two universal functions. One is the well-known law of the wall. The other, called the law of the wake, is characterized by the profile at a point of separation or reattachment. These functions are considered to be established empirically, by a study of the mean-velocity profile, without reference to any hypothetical mechanism of turbulence. Using the resulting complete analytic representation for the mean-velocity field, the shearing-stress field for several flows is computed from the boundary-layer equations and compared with experimental data.The development of a turbulent boundary layer is ultimately interpreted in terms of an equivalent wake profile, which supposedly represents the large-eddy structure and is a consequence of the constraint provided by inertia. This equivalent wake profile is modified by the presence of a wall, at which a further constraint is provided by viscosity. The wall constraint, although it penetrates the entire boundary layer, is manifested chiefly in the sublayer flow and in the logarithmic profile near the wall.Finally, it is suggested that yawed or three-dimensional flows may be usefully represented by the same two universal functions, considered as vector rather than scalar quantities. If the wall component is defined to be in the direction of the surface shearing stress, then the wake component, at least in the few cases studied, is found to be very nearly parallel to the gradient of the pressure.

Debate Concerning the Mean-Velocity Profile of a Turbulent Boundary Layer

AIAA Journal ◽  
2003 ◽  
Vol 41 (4) ◽  
pp. 565-572 ◽  
Author(s):  
Matthias H. Buschmann ◽  
Mohamed Gad-El-Hak
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Mean Velocity ◽  
The Mean

Universal Mean Velocity Profile in Turbulent Boundary Layer

2020 ◽  
Vol 2020.69 (0) ◽  
pp. 516
Author(s):  
Yoshiyuki TSUJI ◽  
Atsushi IDO ◽  
Michio NISHIOKA
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Mean Velocity
Sign in / Sign up

Export Citation Format

Share Document