Investigation of the monochromatic emissivity of liquid copper

2000 ◽  
Vol 38 (3) ◽  
pp. 400-404 ◽  
Author(s):  
V. E. Peletskii
1965 ◽  
Vol 162 (989) ◽  
pp. 555-566 ◽  

Growth in the presence of inhibitory concentrations of copper enhances the tendency of yeast to flocculate. Many yeasts will not flocculate unless calcium is included in the growth medium and Guinness strain 522 used in the present work required a relatively large amount. Single cell cultures may undergo variation during subculture, resulting in the production of a large number of variants (Chester 1963). The cells of these variants differ considerably in their ability to adhere together. Flocculation variants of strain 522 differed among themselves in the amount of calcium necessary for flocculation, the most flocculent variants requiring least calcium. Washed cells of the more flocculent yeasts removed more calcium from a calcium chloride solution than did those with lesser powers of adhesion. In a copper medium con­taining calcium the more flocculent variants replaced the less flocculent. Calcium protected cells from copper and the more flocculent variants enjoyed most protection. All variants acquired resistance to copper during growth in the copper medium. Despite the selection of the more flocculent yeasts during growth in liquid medium, their copper resistance was less than that of the less flocculent yeasts. When calcium was added to the liquid copper medium, cultures developed less resistance. It is concluded that the less flocculent cells, having less protection by calcium, were exposed to what was effectively a greater concentration of copper and therefore became more resistant. This greater resistance did not enable these cells to compete with the flocculent cells in liquid cultures.


1978 ◽  
Vol 9 (2) ◽  
pp. 21-24 ◽  
Author(s):  
Shinya Otsuka ◽  
Masami Matsuyama ◽  
Zensaku Kozuka

2009 ◽  
Vol 41 (2) ◽  
pp. 250-256 ◽  
Author(s):  
Dominika Jendrzejczyk-Handzlik ◽  
Wojciech Gierlotka ◽  
Krzysztof Fitzner

2007 ◽  
Vol 534-536 ◽  
pp. 517-520
Author(s):  
Youn Che Kim ◽  
Myung Jin Suk

Dilatometric curves of iron-copper compact made from elemental or pre-alloyed powder were compared in order to study its expansion mechanism. The compacts from a mixture of elemental iron and copper powders showed the maximum expansion at the copper powder content of 7.44mass% and at the sintering temperatures above the copper melting-point. In the case of the compacts from a mixture of iron pre-alloyed powder of (Fe- 3.44mass%Cu) and copper powder, the maximum expansion which is lower than the former case was obtained at the additive copper powder content of 4.00mass%. But the compact from a mixture of iron pre-alloyed powder of (Fe-7.18mass%Cu) and copper powder showed only shrinkages at any additive copper powder content. The penetration of liquid copper into the interstices between solid grains was observed in all sintered compacts. The iron-copper compacts containing the same content of copper powder showed a very different expansion behavior depending on the amount of copper content in the starting iron raw powder.


Sign in / Sign up

Export Citation Format

Share Document