On the rise: using reentrants to extract magma ascent rates in the Bandelier Tuff caldera complex, New Mexico, USA

2021 ◽  
Vol 84 (1) ◽  
Author(s):  
Megan A. Saalfeld ◽  
M. L. Myers ◽  
R. deGraffenried ◽  
T. Shea ◽  
C. M. Waelkens
1972 ◽  
Vol 2 (4) ◽  
pp. 554-578 ◽  
Author(s):  
Glen A. Izett ◽  
Ray E. Wilcox ◽  
Glenn A. Borchardt

A rhyolitic volcanic ash bed about 0.3 m thick is exposed in a roadcut along Texas Highway 193 near Mount Blanco in the upper part of a sequence of Pleistocene sedimentary deposits at the type locality of the Blanco Formation, about 59 km northeast of Lubbock, Texas. This ash, here named informally the Guaje ash bed, has chemical and petrographic characteristics closely resembling those of the rhyolitic air-fall tephra (Guaje Pumice Bed) that directly underlies ash flows of Pleistocene age in the Jemez Mountains of northern New Mexico. The Guaje Pumice Bed and the ash flows belong to the Otowi Member of the Bandelier Tuff. Properties common to the Guaje ash bed and the Guaje Pumice Bed include: refractive index of glass, 1.497–1.498; microphenocrysts of quartz, sanidine (Or42–44), ferrohedenbergite (Fe51Ca42Mg7), chevkinite, allanite, zircon, and magnetite. Chemical composition of the glass of the Guaje ash bed matches that of the Guaje Pumice Bed for all major elements except K and Na and for trace elements determined by standard chemical analyses, atomic absorption, and neutron activation. Paleomagnetic measurements indicate that the ash has reverse depositional remanent magnetization. Glass shards of the ash have a fission-track age of about 1.4 ± 0.2 m. y. Sanidine from the Guaje Pumice Bed and its genetically related ash-flow sheet in the Jemez Mountains was K-Ar dated at about 1.4 m. y. by R. R. Doell and his colleagues in 1968. Correlation of the Guaje ash bed with the radiometrically dated Guaje Pumice Bed establishes a minimum age of about 1.4 m. y. for the Blanco Formation.


Geophysics ◽  
1997 ◽  
Vol 62 (2) ◽  
pp. 451-465 ◽  
Author(s):  
Philip E. Wannamaker

An extensive tensor controlled‐source audiomagnetotelluric (CSAMT) survey has been carried out over the Sulphur Springs geothermal area, Valles Caldera, New Mexico. Forty‐five sites were acquired using two crossed transmitter bipoles placed approximately 13 km south of the center of the survey. The soundings in the Sulphur Springs area were arranged in four profiles to cross major structural features. To curtail spatial aliasing, the electric bipoles along each profile were deployed contiguously. The frequency range of acquisition was 4096 Hz down to 1 Hz for the central line, but only down to 4 Hz for most sites of the other lines. CSAMT and magnetotelluric (MT) data taken outside Valles Caldera were constrained by drill logs and imply resistive Bandelier Tuff, underlain by conductive Paleozoic sediments, and further underlain by resistive, primarily Precambrian crystalline rocks. Model cross‐sections within the caldera were derived using 2-D parameterized inversion constrained by drilling, with layered‐earth inversion for starting models. Southeast of the Sulphur Creek fault, the upper 200 m of the section are of relatively low resistivity and correspond to unconsolidated land‐slide and debris flows. The Bandelier Tuff below exhibits higher but variable resistivities because of alteration controlled by local faulting. Beneath the Bandelier Tuff, the Paleozoic sedimentary layer is only moderately less resistive than it is outside the caldera, with the lowest values occuring northwest of Sulphur Creek. Its low resistivity per se does not necessarily represent a hydrothermal aquifer. The Sulphur Creek fault appears to be a locus of substantial change in structural relief; up‐throw of stratigraphy and basement to its west appears to be about 400–500 m. A major normal fault down to the southeast is located under the topographic expression of Freelove Canyon, which is up to 1 km farther southeast than suggested by previous geologic sections. High resistivities possibly corresponding to a vapor zone in the upper 500 m near VC-2B and VC-2A are not consistent with the CSAMT data.


2010 ◽  
Vol 32 (6) ◽  
pp. 766-780 ◽  
Author(s):  
Paul R. Riley ◽  
Laurel B. Goodwin ◽  
Claudia J. Lewis

2018 ◽  
Vol 91 (2) ◽  
pp. 813-828 ◽  
Author(s):  
John A. Westgate ◽  
Giday WoldeGabriel ◽  
Henry C. Halls ◽  
Colin J. Bray ◽  
René W. Barendregt ◽  
...  

AbstractA fine-grained, up to 3-m-thick tephra bed in southwestern Saskatchewan, herein named Duncairn tephra (Dt), is derived from an early Pleistocene eruption in the Jemez Mountains volcanic field of New Mexico, requiring a trajectory of northward tephra dispersal of ~1500 km. An unusually low CaO content in its glass shards denies a source in the closer Yellowstone and Heise volcanic fields, whereas a Pleistocene tephra bed (LSMt) in the La Sal Mountains of Utah has a very similar glass chemistry to that of the Dt, supporting a more southerly source. Comprehensive characterization of these two distal tephra beds along with samples collected near the Valles caldera in New Mexico, including grain size, mineral assemblage, major- and trace-element composition of glass and minerals, paleomagnetism, and fission-track dating, justify this correlation. Two glass populations each exist in the Dt and LSMt. The proximal correlative of Dt1 is the plinian Tsankawi Pumice and co-ignimbritic ash of the first ignimbrite (Qbt1g) of the 1.24 Ma Tshirege Member of the Bandelier Tuff. The correlative of Dt2 and LSMt is the co-ignimbritic ash of Qbt2. Mixing of Dt1 and Dt2 probably occurred during northward transport in a jet stream.


Sign in / Sign up

Export Citation Format

Share Document