Investigating municipal solid waste generation and management in Ilorin for possible integrated waste-management system

Author(s):  
Rotimi Adedayo Ibikunle
2015 ◽  
Vol 1 (1) ◽  
pp. 114-120 ◽  
Author(s):  
Md Anwarul Abedin ◽  
M Jahiruddin

This paper focuses on the status of solid waste generation, waste management system and waste management problems in Bangladesh. Solid waste generation is in increasing trend with the growth of urban population. The country is generating about 8000 tons of solid waste each day from the six major cities (Dhaka, Chittagong, Khulna, Rajshahi, Barisal and Sylhet), of which Dhaka city alone is contributing about 70%. Waste management system is not well organized. Efforts are underway to improve the system of waste collection, transportation, recycling, incineration and land filling. Lack of regulations/standard for waste disposal, landfill & use, lack of awareness, improper choice of technology and inadequate financial support are the major constraints for waste management in Bangladesh.Asian J. Med. Biol. Res. June 2015, 1(1): 114-120


2014 ◽  
Vol 32 (1) ◽  
pp. 17-28 ◽  
Author(s):  
Dace Āriņa ◽  
Kaspars Kļavenieks ◽  
Juris Burlakovs

Abstract Production of refuse derived fuel from municipal solid waste in future shall play a strategic role in an integrated waste management system. The amount of landfilled biodegradable materials thus will be diminished according to provisions of the 1999 Waste Landfill Directive. The aim of this article is to evaluate cost effectiveness based on cost evaluation of the different complication of the waste pre-treatment equipment complectation and based on regenerable waste quantities in Latvia. The comparison of cost estimates is done in 3 scenarios considering potential waste quantities in Latvia: Scenario I - planned annual waste quantity is 20 kT; Scenario II - 40 kT and Scenario III - 160 kT. An increase in amount of waste and processing capacity means the decrease in costs of mechanical pre-treatment of 1 ton of waste. Thus, costs of mechanical sorting line under different scenarios with capacities of 10 t h-1, 20 t h-1 and 80 t h-1 are EUR 32 per t, EUR 24 per t and EUR 15 per t, respectively. Most feasible cost for a set of mechanical pre-treatment equipment for the capacity of 10 t h-1 is EUR 32 per t by using rotating drum screener with the following manual sorting. Mechanical pre-treatment equipment of unsorted municipal waste is economically nonbeneficial, when the use of fine (biologically degradable) fraction is not possible. As the sorting of biodegradable kitchen waste is not developed under the current waste management system in Latvia, the lines for mechanical pre-treatment of household waste would be better to install in landfills.


2020 ◽  
Vol 3 (11) ◽  
pp. 4-8
Author(s):  
A. M. GUBERNATOROV ◽  

The article deals with the management of municipal solid waste in accordance with the reform. It is proved that the waste processing industry needs fundamental changes. It is proved that the effectiveness of the reform of the municipal solid waste management system can be assessed using an optimal financing model based on a scenario approach.


2020 ◽  
Vol 16 (6) ◽  
pp. 917-948
Author(s):  
Kapil Dev Sharma ◽  
Siddharth Jain

Purpose Due to the increasing population and prosperity, the generation rate of municipal solid waste (MSW) has increased significantly, resulting in serious problems on public health and the environment. Every single person in the world is affected by the municipal solid waste management (MSWM) issue. MSWM is reaching a critical level in almost all areas of the world and seeking the development of MSW strategies for a sustainable environment. This paper aims to present the existing global status of MSW generation, composition, management and related problems. Design/methodology/approach A total of 59 developed and developing countries have been grouped based on their gross national income to compare the status of various MSWM technologies among them. A total of 19 selection criteria have been discussed to select appropriate MSWM technology(s) for a city/town, which affects their applicability, operational suitability and performance. All risks and challenges arising during the life cycle of the waste to energy (WtE) project have also been discussed. This paper also gives a comparative overview of different globally accepted MSWM technologies and the present market growth of all WtE technologies. Findings It was found that most developed countries have effectively implemented the solid waste management (SWM) hierarchy and are now focusing heavily on reducing, reusing and recycling of MSW. On the other hand, SWM has become very serious in low-income and low-middle-income countries because most of the MSW openly dumps and most countries are dependent on inadequate waste infrastructure and the informal sector. There are also some other major challenges related to effective waste policies, availability of funds, appropriate technology selection and adequacy of trained people. This study clears the picture of MSW generation, composition, management strategies and policies at the worldwide context. This manuscript could be valuable for all nations around the world where effective MSWM has not yet been implemented. Originality/value This study clears the picture of solid waste generation, composition, management strategies and policies at the worldwide context. This manuscript could be valuable for all nations around the world where effective MSWM has not yet been implemented. In this study, no data was generated. All supporting data were obtained from previously published papers in journals, the outcomes of the international conferences and published reports by government organizations.


Sign in / Sign up

Export Citation Format

Share Document