Hydrogen Formation via Steam Reforming of Ethanol Over Cu/ZnO Catalyst Modified with Nickel, Cobalt and Manganese

2008 ◽  
Vol 128 (3-4) ◽  
pp. 443-448 ◽  
Author(s):  
W. Grzegorczyk ◽  
A. Denis ◽  
W. Gac ◽  
T. Ioannides ◽  
A. Machocki
Keyword(s):  
Steam Reforming ◽  
Hydrogen Formation ◽  
Nickel Cobalt ◽  
Steam Reforming Of Ethanol

scholarly journals Copper Tricomponent Catalysts Application for Hydrogen Production from Ethanol

Catalysts ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 575
Author(s):  
Łukasz Hamryszak ◽  
Maria Kulawska ◽  
Maria Madej-Lachowska ◽  
Michał Śliwa ◽  
Katarzyna Samson ◽  
...  
Keyword(s):  
Steam Reforming ◽  
Continuous Flow ◽  
Fixed Bed ◽  
Fixed Bed Reactor ◽  
Molar Ratio ◽  
Pure Hydrogen ◽  
Hydrogen Yield ◽  
Nickel Cobalt ◽  
Steam Reforming Of Ethanol ◽  
The One

The application of copper-based catalysts in the production of pure hydrogen in the steam reforming of ethanol was performed. The tricomponent Cu/Zr catalysts with about 4 mass% addition of nickel, cobalt, or cerium have been prepared in our laboratory. The properties of obtained catalysts were compared with bimetallic Cu/Zr catalyst prepared and tested according to the same procedure. Catalytic tests were carried out in the continuous flow fixed–bed reactor in the wide temperature range of 433–593 K for initial molar ratio of ethanol to water equal to 1:3. Catalysts were characterized by XRD, TPR, CO2–TPD, and TPO methods. Cu/Zr/Ce catalyst proved to be the best; hydrogen yield reached the value of 400 L/(kgcat.∙h), selectivity towards carbon monoxide was below 0.5% and the one towards methane wasnot detected. Additions of Ni or Co did not bring significant improvement in activity.

Hydrogen production by steam reforming of ethanol over Ni/Al 2 O 3 -La 2 O 3 xerogel catalysts

2017 ◽  
Vol 434 ◽  
pp. 123-133 ◽  
Author(s):  
Ji Hwan Song ◽  
Sangbeom Yoo ◽  
Jaekyeong Yoo ◽  
Seungwon Park ◽  
Min Yeong Gim ◽  
...  
Keyword(s):  
Hydrogen Production ◽  
Steam Reforming ◽  
Steam Reforming Of Ethanol

Physical-Chemical and Thermodynamic Analyses of Ethanol Steam Reforming for Hydrogen Production

2006 ◽  
Vol 3 (3) ◽  
pp. 346-350 ◽  
Author(s):  
Antonio Carlos Caetano de Souza ◽  
José Luz-Silveira ◽  
Maria Isabel Sosa
Keyword(s):  
Hydrogen Production ◽  
Steam Reforming ◽  
Production Efficiency ◽  
Physical Chemical ◽  
Steam Reforming Of Ethanol ◽  
Thermodynamic Conditions ◽  
High Production ◽  
Exergetic Analysis ◽  
Global Reaction ◽  
Technical Features

Steam reforming is the most usual method of hydrogen production due to its high production efficiency and technological maturity. The use of ethanol for this purpose is an interesting option because it is a renewable and environmentally friendly fuel. The objective of this article is to present the physical-chemical, thermodynamic, and exergetic analysis of a steam reformer of ethanol, in order to produce 0.7Nm3∕h of hydrogen as feedstock of a 1kW PEMFC. The global reaction of ethanol is considered. Superheated ethanol reacts with steam at high temperatures producing hydrogen and carbon dioxide, depending strongly on the thermodynamic conditions of reforming, as well as on the technical features of the reformer system and catalysts. The thermodynamic analysis shows the feasibility of this reaction in temperatures about 206°C. Below this temperature, the reaction trends to the reactants. The advance degree increases with temperature and decreases with pressure. Optimal temperatures range between 600 and 700°C. However, when the temperature attains 700°C, the reaction stability occurs, that is, the hydrogen production attains the limit. For temperatures above 700°C, the heat use is very high, involving high costs of production due to the higher volume of fuel or electricity used. The optimal pressure is 1atm., e.g., at atmospheric pressure. The exergetic analysis shows that the lower irreversibility is attained for lower pressures. However, the temperature changes do not affect significantly the irreversibilities. This analysis shows that the best thermodynamic conditions for steam reforming of ethanol are the same conditions suggested in the physical-chemical analysis.

Catalytic properties of Ag promoted ZnO/Al2O3 catalysts for hydrogen production by steam reforming of ethanol

2011 ◽  
Vol 36 (13) ◽  
pp. 7516-7522 ◽  
Author(s):  
Meng-Nan Chen ◽  
Dong-Yun Zhang ◽  
Levi T. Thompson ◽  
Zi-Feng Ma
Keyword(s):  
Hydrogen Production ◽  
Steam Reforming ◽  
Catalytic Properties ◽  
Steam Reforming Of Ethanol

scholarly journals Steam reforming of ethanol for hydrogen production: influence of catalyst composition (Ni/Al2O3, Ni/Al2O3–CeO2, Ni/Al2O3–ZnO) and process conditions

2021 ◽  
Vol 132 (2) ◽  
pp. 907-919
Author(s):  
O. Shtyka ◽  
Z. Dimitrova ◽  
R. Ciesielski ◽  
A. Kedziora ◽  
G. Mitukiewicz ◽  
...  
Keyword(s):  
Hydrogen Production ◽  
Steam Reforming ◽  
Catalyst Stability ◽  
Feed Ratio ◽  
Ethanol Conversion ◽  
Process Conditions ◽  
Catalyst Activation ◽  
Catalyst Composition ◽  
Activity Measurements ◽  
Steam Reforming Of Ethanol

AbstractEthanol steam reforming was studied over Ni supported catalysts. The effects of support (Al2O3, Al2O3–ZnO, and Al2O3–CeO2), metal loading, catalyst activation method, and steam-to-ethanol molar feed ratio were investigated. The properties of catalysts were studied by N2 physisorption, TPD-CO2, X-ray diffraction, and temperature programmed reduction. After activity tests, the catalysts were analyzed by TOC analysis. The catalytic activity measurements showed that the addition either of ZnO SSor CeO2 to alumina enhances both ethanol conversion and promotes selectivity towards hydrogen formation. The same effects were observed for catalysts with higher metal loadings. High process temperature and high water-to-ethanol ratio were found to be beneficial for hydrogen production. An extended catalyst stability tests showed no loss of activity over 50 h on reaction stream. The TOC analysis of spent catalysts revealed only insignificant amounts of carbon deposit.

Ultrasonic-assisted fabrication of LaNiOx composite oxide nanotubes and application to the steam reforming of ethanol

2011 ◽  
Vol 164 (1) ◽  
pp. 246-250 ◽  
Author(s):  
Siao-Wun Liu ◽  
Jyong-Yue Liu ◽  
Ying-Huei Liu ◽  
Yu-Hsung Huang ◽  
Chuin-Tih Yeh ◽  
...  
Keyword(s):  
Steam Reforming ◽  
Composite Oxide ◽  
Steam Reforming Of Ethanol ◽  
Ultrasonic Assisted
Sign in / Sign up

Export Citation Format

Share Document