Evolution of the Structural-Phase State of a Ti–Al– V–Mo Alloy During Severe Plastic Deformation and SubSequent Annealing

2016 ◽  
Vol 59 (1) ◽  
pp. 109-115 ◽  
Author(s):  
G. P. Grabovetskaya ◽  
I. V. Ratochka ◽  
I. P. Mishin ◽  
O. V. Zabudchenko ◽  
O. N. Lykova
Keyword(s):  
Plastic Deformation ◽  
Severe Plastic Deformation ◽  
Phase State ◽  
Structural Phase ◽  
Subsequent Annealing ◽  
Structural Phase State

Influence of composition on the structural-phase state, electrophysical and magnetotransport properties of alloy thin films based on Co and Cu

Vacuum ◽  
2021 ◽  
Vol 187 ◽  
pp. 110141
Author(s):  
I.O. Shpetnyi ◽  
I.Yu Protsenko ◽  
S.I. Vorobiov ◽  
V.I. Grebinaha ◽  
L. Satrapinskyy ◽  
...  
Keyword(s):  
Thin Films ◽  
Phase State ◽  
Structural Phase ◽  
Structural Phase State

Influence of ball milling duration on the morphology, features of the structural-phase state and microhardness of 3Ni-Al powder mixture

2021 ◽  
Author(s):  
Ivan A. Ditenberg ◽  
Denis A. Osipov ◽  
Michail A. Korchagin ◽  
Ivan V. Smirnov ◽  
Konstantin V. Grinyaev ◽  
...  
Keyword(s):  
Ball Milling ◽  
Powder Mixture ◽  
Phase State ◽  
Structural Phase ◽  
Structural Phase State ◽  
Milling Duration ◽  
Al Powder

Effect of Alloying Elements on the Structural Phase State of Hadfield Steel

2021 ◽  
Vol 33 (11) ◽  
pp. 04021324
Author(s):  
Almira Zhilkashinova ◽  
Mazhyn Skakov ◽  
Madi Abilev ◽  
Dossym Yerbolatuly
Keyword(s):  
Phase State ◽  
Structural Phase ◽  
Alloying Elements ◽  
Hadfield Steel ◽  
Structural Phase State ◽  
Effect Of Alloying

scholarly journals Influence of electrolytic plasma nitriding mode on structural phase state of pearlitic steel

2018 ◽  
Vol 143 ◽  
pp. 03004
Author(s):  
Natalya Popova ◽  
Lyudmila Erygina ◽  
Elena Nikonenko ◽  
Mazhin Skakov
Keyword(s):  
Phase State ◽  
Plasma Nitriding ◽  
Water Solution ◽  
Lath Martensite ◽  
Structural Phase ◽  
Pearlitic Steel ◽  
Parallel Plates ◽  
Structural Phase State ◽  
Original State ◽  
Α Phase

The paper describes results of studies of phase transitions in structural phase state occurring in the type 0.34C-1Cr-1Ni-1Mo-Fe steel under electrolytic plasma nitriding in nitrogen-containing water solution. The nitriding voltages considered in the given study were 550 and 600 V. The research was conducted by means of X-ray diffraction electron microscopy. The specimens were studied in two states : 1) before modification (original state) and 2) after nitriding in the surface layer of the specimen. The study was conducted on thin foils. It was found that nitriding lead to significant changes in the structure of steel, namely in its phase composition and in the number of existing phases. In the original state the structure of steel was given as lamellar pearlite, ferritic carbide mix and fragmented ferrite. After 550 V nitriding it was lath martensite, plates of α-phase, with colonies of thin parallel plates of γ-phase and coarse grains of α-phase, containing γ-phase grains which were different in size and shape and were various-directional. Increase in nitriding voltage up to 600 V lead to change in the structure given as a lamellar non-fragmented pearlite and fragmented ferrite. The original state was marked by presence of particles of M3C cementite, after nitriding irrespective of the voltage it had the particles of M3C alloyed cementite, Fe3Mo3N nitride and Cr2C0.61N0.39 carbonitride. The sizes, volume fractions and locations of particles were dependent on nitriding voltage.

The structural-phase state and magnetoresistive properties of thin film alloys obtained by co-evaporated Cu and Co

2019 ◽  
Vol 474 ◽  
pp. 624-631 ◽  
Author(s):  
I.O. Shpetnyi ◽  
D.M. Kondrakhova ◽  
S.I. Vorobiov ◽  
B. Scheibe ◽  
V.I. Grebinaha ◽  
...  
Keyword(s):  
Thin Film ◽  
Phase State ◽  
Structural Phase ◽  
Structural Phase State

Effect of mechanical-thermal treatment on structural-phase state and mechanical properties of near β titanium alloy

2018 ◽  
Author(s):  
I. P. Mishin ◽  
E. V. Naydenkin ◽  
I. V. Ratochka ◽  
O. N. Lykova ◽  
V. A. Vinokurov
Keyword(s):  
Mechanical Properties ◽  
Titanium Alloy ◽  
Thermal Treatment ◽  
Phase State ◽  
Structural Phase ◽  
Structural Phase State

scholarly journals Structural-Phase State, Mechanical Properties, Acoustic and Magnetic Characteristics in the Sustainable Deformation Localization Zones of Power Equipment Made of Structural and Heat Resistant Steels

Metals ◽  
2021 ◽  
Vol 11 (10) ◽  
pp. 1638
Author(s):  
Nikolay Ababkov ◽  
Alexandr Smirnov ◽  
Vladimir Danilov ◽  
Lev Zuev ◽  
Natalya Popova ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Phase State ◽  
Structural Phase ◽  
Magnetic Characteristics ◽  
Internal Stresses ◽  
Power Equipment ◽  
Deformation Localization ◽  
Structural Phase State ◽  
Heat Resistant ◽  
Heat Resistant Steels

The paper presents the results of the analysis of the microstructure, mechanical properties, acoustic and magnetic characteristics of the metal of pipelines that are part of heat and power equipment, after long-term operation, made of structural and heat-resistant steels in the zones of localization of plastic deformation. Samples of 0.2 С steel and 0.12С-1Сr-1Mo-1V steel were studied in the initial state, as well as after operation for 219 and 360 thousand hours, respectively. As a result of the studies carried out for each sample, the phase composition was determined (qualitatively and quantitatively), and the following parameters of the fine structure were calculated: volume fractions of structural components of steel (pearlite and ferrite), scalar and excess ± dislocation density, curvature-torsion of the crystal lattice χ, amplitude of internal stresses (shear stress and long-range stresses). All quantitative parameters of the structure are determined both in each structural component of steel, and in general for each sample. The structure of the metal of all specimens after deformation before the formation of zones of stable localization of deformations consists of a ferrite-pearlite mixture, and for specimens after operation before fracture only of unfragmented and fragmented ferrite. Ferrite, which occupies the bulk of the material, is present both unfragmented and fragmented. For all samples, the ratios ≥ , χ = χpl, σL ≥ σd were calculated, which indicate whether there is a danger of the initiation of microcracks in metal samples. For specimens without operation and after operation without damage in zones of stable localization of deformations, these conditions are met, and for specimens after operation until destruction, they are not met. It was found that the structural-phase state in the zones of localization of deformations has a direct effect on the characteristics of non-destructive tests. Thus, for all investigated samples, the values of such parameters as the delay time of the surface acoustic wave, the attenuation coefficient, the amplitude of the received signal, and the intensity of magnetic noise in the zones of deformation localization were established.

Sign in / Sign up

Export Citation Format

Share Document