Effect of Temperature on the Release of Transparent Exopolymer Particles (TEP) and Aggregation by Marine Diatoms (Thalassiosira weissflogii and Skeletonema marinoi)

Author(s):  
Jie Chen ◽  
Kangli Guo ◽  
Daniel C. O. Thornton ◽  
Yi Wu
1985 ◽  
Vol 42 (7) ◽  
pp. 1272-1277 ◽  
Author(s):  
N. J. Antia ◽  
P. J. Harrison ◽  
D. S. Sullivan ◽  
T. Bisalputra

Diflubenzuron (Dimilin) was tested, in the concentration range 0.1–5000 μg∙L−1, for possible injurious effects on the growth and photosynthesis of three chitin-producing (Thalassiosira weissflogii, T. norden-skioldii, Cyclotella cryptica) and one nonchitinaceous (Skeletonema costatum) diatoms. For comparison, the effects of the pesticide were also examined on adult survival and juvenile development of the harpacticoid copepod Tigriopus californicus. While the development of the copepod was hindered at concentrations of the order of 1–10 μg∙L−1, the diatoms were barely affected by Dimilin even at the highest concentration tested (5 mg∙L−1). We conclude that Dimilin acts specifically on insects and crustaceans as a larvicide by interfering with chitin deposition into cuticles during juvenile development through ecdysis. The lack of effect from Dimilin on the chitin-producing diatoms has suggested that the insecticide may not inhibit chitin biosynthesis per se as was previously believed, but that it presumably deregulates one or more of the larval postsynthetic processes responsible for chitin integration into cuticles.


Chemosphere ◽  
2017 ◽  
Vol 175 ◽  
pp. 200-209 ◽  
Author(s):  
Mst Ruhina Margia Khanam ◽  
Yohei Shimasaki ◽  
Md Zahangir Hosain ◽  
Koki Mukai ◽  
Michito Tsuyama ◽  
...  

2015 ◽  
Vol 60 (3) ◽  
pp. 901-919 ◽  
Author(s):  
J. Taucher ◽  
J. Jones ◽  
A. James ◽  
M. A. Brzezinski ◽  
C. A. Carlson ◽  
...  

Author(s):  
P. R. Swann ◽  
W. R. Duff ◽  
R. M. Fisher

Recently we have investigated the phase equilibria and antiphase domain structures of Fe-Al alloys containing from 18 to 50 at.% Al by transmission electron microscopy and Mössbauer techniques. This study has revealed that none of the published phase diagrams are correct, although the one proposed by Rimlinger agrees most closely with our results to be published separately. In this paper observations by transmission electron microscopy relating to the nucleation of disorder in Fe-24% Al will be described. Figure 1 shows the structure after heating this alloy to 776.6°C and quenching. The white areas are B2 micro-domains corresponding to regions of disorder which form at the annealing temperature and re-order during the quench. By examining specimens heated in a temperature gradient of 2°C/cm it is possible to determine the effect of temperature on the disordering reaction very precisely. It was found that disorder begins at existing antiphase domain boundaries but that at a slightly higher temperature (1°C) it also occurs by homogeneous nucleation within the domains. A small (∼ .01°C) further increase in temperature caused these micro-domains to completely fill the specimen.


Author(s):  
T. Geipel ◽  
W. Mader ◽  
P. Pirouz

Temperature affects both elastic and inelastic scattering of electrons in a crystal. The Debye-Waller factor, B, describes the influence of temperature on the elastic scattering of electrons, whereas the imaginary part of the (complex) atomic form factor, fc = fr + ifi, describes the influence of temperature on the inelastic scattering of electrons (i.e. absorption). In HRTEM simulations, two possible ways to include absorption are: (i) an approximate method in which absorption is described by a phenomenological constant, μ, i.e. fi; - μfr, with the real part of the atomic form factor, fr, obtained from Hartree-Fock calculations, (ii) a more accurate method in which the absorptive components, fi of the atomic form factor are explicitly calculated. In this contribution, the inclusion of both the Debye-Waller factor and absorption on HRTEM images of a (Oll)-oriented GaAs crystal are presented (using the EMS software.Fig. 1 shows the the amplitudes and phases of the dominant 111 beams as a function of the specimen thickness, t, for the cases when μ = 0 (i.e. no absorption, solid line) and μ = 0.1 (with absorption, dashed line).


1990 ◽  
Vol 80 (3) ◽  
pp. 431-436 ◽  
Author(s):  
Isabelle Delvallee ◽  
Annie Paffen ◽  
Geert-Jan De Klerk

Sign in / Sign up

Export Citation Format

Share Document