Influence of the type of calcium sulfate on the strength and hydration of portland cement under an initial steam-curing condition

1996 ◽  
Vol 26 (10) ◽  
pp. 1505-1511 ◽  
Author(s):  
Hong Zhang ◽  
Zhongsou Lin ◽  
Damao Tong
2009 ◽  
Vol 23 (1) ◽  
pp. 340-346 ◽  
Author(s):  
Brian O’Rourke ◽  
Ciaran McNally ◽  
Mark G. Richardson

1980 ◽  
Vol 7 (2) ◽  
pp. 256-263 ◽  
Author(s):  
M. A. Ward ◽  
S. M. Khalil ◽  
B. W. Langan

As the cost of energy and hence the cost of producing Portland cement increase, the question arises as to whether we are obtaining optimum performance from the admixtures we use. As an example, data are presented indicating that a significant improvement in strength and shrinkage can be achieved by optimizing the sulfate content of the cement for given cement–admixture combinations. It is shown that the optimum SO3 is clearly a function of the initial temperature of the concrete, particularly during the first 24 h after casting, a characteristic of considerable importance in hot weather concreting and steam curing of concrete products. It is recommended that more attention be directed towards optimizing the effectiveness of chemical admixtures in both the ready-mixed concrete and precast concrete industries.


2006 ◽  
Vol 530-531 ◽  
pp. 478-484 ◽  
Author(s):  
Carolina A. Pinto ◽  
Francisco Rolando Valenzuela-Díaz ◽  
John J. Sansalone ◽  
Jo Dweck ◽  
Frank K. Cartledge ◽  
...  

The leather industry creates a large quantity of organic and inorganic waste containing chromium. This research examines stabilization of particulate tannery waste in type II Portland cement. Several clays, Brazilian polycationic smectite modified in laboratory and commercial clays were used as additives with the aim of optimizing chromium adsorption. Tannery waste was added in quantities of 10, 15 and 20% relative to cement mass. The solidification components were analyzed separately and in combination in the solidified mixes using X ray diffraction. The analysis showed that reactions between the waste and the cement occurred, and that the tannery waste modified the final compounds of the system. Calcium sulfate present in the waste increased ettringite formation. Chromium also reacted with cement, since compounds with chromium and calcium were identified. Substitution of aluminum and silicon by chromium was also observed.


2014 ◽  
Vol 803 ◽  
pp. 194-200 ◽  
Author(s):  
Ahmad Ruslan Mohd Ridzuan ◽  
Mohd Mustafa Al Bakri Abdullah ◽  
Mohd Fadzil Arshad ◽  
Muhammad Faheem Mohd Tahir ◽  
A.A. Khairulniza

Concrete is widely used as a material construction. Globally, the consumption of concrete was estimated to be more than 8 billion tons per year. Nowadays, many problems arise related to concrete manufacturing occur especially on environmental issues. A key concern for environmentalists has always been climate change. One of the ways to mitigate the impact activities on the climate is to reduce carbon footprint. Portland cement are commonly been used in concrete is responsible for about 5% of all CO2emission. It is reported by Davidovit that the production of one ton of Portland cement emits approximately one ton of CO2into the atmosphere. There are several ways to reduce environmental pollution that cause by production and utilization of Portland cement, one of it is Geopolymer concrete. Subsequently Geopolymer concrete incorporating with recycle concrete aggregate (RCA) is one of the alternative to further reduce carbon footprint and as well as can reduce waste. Geopolymer concrete is a concrete that use no cement and produced by the combination of alkaline activator and supplementary cementitious material (SCM) such as fly ash, boiler ash, waste paper sludge ash (WPSA), ground granulated blast-furnace slag (GGBS), and so on in order to reduce carbon emission. In this study the Waste Paper Sludge Ash (WPSA) were used as a SCM and the combination of sodium hydroxide (NaOH) and sodium silicate (Na2SiO3) as a binder. Two (2) series of geopolymer concrete specimens comprising two (2) different molar of sodium hydroxide (NaOH) which are 8M and 14M were adopted. The effect variable alkaline molarity on the compressive strength and shrinkage of the geopolymer concrete specimens is tested at the age of 3, 7, 14 and 28 days. The mixture of geopolymer concete with 8M of sodium hydroxide (NaOH) concentration then was categorized into three (3) groups. Each group were been cured at different curing condition which are in ambient condition, oven, and external condition. The size of specimens prepared were 100mm x 100mm x100mm. The result shows that the molarities of sodium hydroxide (NaOH) influenced the strength of Waste Paper Sludge Ash (WPSA) based geopolymer concrete produced incorporating with increasing of recycle concrete aggregate (RCA). The result also show that the geopolymer concrete undergoes very low shrinkage. Curing condition will also effect the strength of geopolymer concrete produced.


Sign in / Sign up

Export Citation Format

Share Document