Determination of the spatial length scale of the magnetic field distribution in YBa2Cu3O7 ceramics and Bi2Sr2CaCu2O8 crystal

1991 ◽  
Vol 185-189 ◽  
pp. 1809-1810 ◽  
Author(s):  
N. Bontemps ◽  
P.Y. Bertin ◽  
D. Davidov ◽  
P. Monod ◽  
C. Lacour ◽  
...  
2003 ◽  
Vol 13 (12) ◽  
pp. 3783-3789 ◽  
Author(s):  
F. E. SMITH ◽  
P. LANGLEY ◽  
L. TRAHMS ◽  
U. STEINHOFF ◽  
J. P. BOURKE ◽  
...  

Multichannel magnetocardiography measures the magnetic field distribution of the human heart noninvasively from many sites over the body surface. Multichannel magnetocardiogram (MCG) analysis enables regional temporal differences in the distribution of cardiac magnetic field strength during depolarization and repolarization to be identified, allowing estimation of the global and local inhomogeneity of the cardiac activation process. The aim of this study was to compare the spatial distribution of cardiac magnetic field strength during ventricular depolarization and repolarization in both normal subjects and patients with cardiac abnormalities, obtaining amplitude measurements by magnetocardiography. MCGs were recorded at 49 sites over the heart from three normal subjects and two patients with inverted T-wave conditions. The magnetic field intensity during depolarization and repolarization was measured automatically for each channel and displayed spatially as contour maps. A Pearson correlation was used to determine the spatial relationship between the variables. For normal subjects, magnetic field strength maps during depolarization (R-wave) showed two asymmetric regions of magnetic field strength with a high positive value in the lower half of the chest and a high negative value above this. The regions of high R-wave amplitude corresponded spatially to concentrated asymmetric regions of high magnetic field strength during repolarization (T-wave). Pearson-r correlation coefficients of 0.7 (p<0.01), 0.8 (p<0.01) and 0.9 (p<0.01) were obtained from this analysis for the three normal subjects. A negative correlation coefficient of -0.7 (p<0.01) was obtained for one of the subjects with inverted T-wave abnormalities, suggesting similar but inverted magnetic field and current distributions to normal subjects. Even with the high correlation values in these four subjects, the MCG was able to identify differences in the distribution of magnetic field strength, with a shift in the T-wave relative to the R-wave. The measurement of cardiac magnetic field distribution during depolarization and repolarization of normal subjects and patients with clinical abnormalities should enable the improvement of theoretical models for the explanation of the cardiac depolarization and repolarization processes.


2009 ◽  
Vol 115 (6) ◽  
pp. 1125-1127 ◽  
Author(s):  
O. Liebfried ◽  
M. Schneider ◽  
M.J. Loeffler ◽  
S. Balevičius ◽  
N. Žurauskienė ◽  
...  

2018 ◽  
Vol 168 ◽  
pp. 02004
Author(s):  
Richard Lenhard ◽  
Milan Malcho ◽  
Katarína Kaduchová

In the paper is shown the connection of two toolboxes in an Ansys Workbench solution for induction heating. In Ansys Workbench, Maxwell electromagnetism programs and Fluent have been linked. In Maxwell, a simulation of electromagnetic induction was performed, where data on the magnetic field distribution in the heated material was obtained and then transformed into the Fluent program in which the induction heating simulation was performed.


2020 ◽  
Vol 22 (1-2) ◽  
pp. 58-64
Author(s):  
Teodora Gavrilov ◽  
◽  
Karolina Kasaš-Lažetić ◽  
Kristian Haška ◽  
Miroslav Prša

In this paper, the analysis of magnetic field distribution of overhead mixed power line (20 kV/0.4 kV) supported by reinforced concrete towers, named MNL-12 is presented. The impact of ferromagnetic, conductive parts of the pylons (reinforcing bars, billets and cross arm beams) on magnetic field distribution is investigated. The numerical calculations were performed in COMSOL Multiphysics program package on simplified 2D model. The main goal of the calculations was to examine the impact of currents induced in ferromagnetic conductive parts on magnetic field produced by currents in the power system’s conductors. The calculation results are presented graphically, as the diagrams of the magnetic flux density magnitude distribution in the tower plan, normal to the system’s axe. The calculation results demonstrated that the magnetic field of induced currents decreases the magnetic field produced by the currents of overhead power system.


2021 ◽  
Vol 1018 ◽  
pp. 111-116
Author(s):  
Yan Hua Zou ◽  
Hui Jun Xie

The traditional magnetic abrasive finishing (MAF) process, the magnetic flux density at the bottom of the magnetic pole is unevenly distributed, resulting in poor uniformity of the finished surface. Therefore, it is proposed to improve the surface quality by attaching a magnetic plate at the bottom of the workpiece to improve the magnetic field distribution. It is confirmed by simulation that the magnetic field distribution at the bottom of the magnetic pole is effectively improved after the magnetic plate is attached. It is proved through experiments that the magnetic plate-assisted MAF process can obtain a smoother surface. The experimental results show that the surface roughness of the glass lens improves from 246 nm Ra to 3 nm Ra through the magnetic plate-assisted MAF process within 45min.


2016 ◽  
Vol 66 (2) ◽  
pp. 231-234
Author(s):  
Sunghoon JEON ◽  
Shant ARAKELYAN ◽  
Yeonsub LEE ◽  
Yongjae KIM ◽  
Hyeji HAN ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document