Shear strength assessment of reinforced recycled aggregate concrete member

2022 ◽  
pp. 323-347
Author(s):  
Oladimeji B. Olalusi ◽  
John Temitope Kolawole
Keyword(s):  
Shear Strength ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Concrete Member ◽  
Aggregate Concrete ◽  
Strength Assessment

scholarly journals Study on the Strength Performance of Recycled Aggregate Concrete with Different Ages under Direct Shearing

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2312
Author(s):  
Xin Liang ◽  
Fang Yan ◽  
Yuliang Chen ◽  
Huiqin Wu ◽  
Peihuan Ye ◽  
...  
Keyword(s):  
Shear Strength ◽  
Shear Force ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Displacement Curve ◽  
Direct Shear ◽  
Replacement Ratio ◽  
Aggregate Concrete ◽  
Concrete Failure ◽  
Load Displacement

In order to study the mechanical properties of recycled aggregate concrete (RAC) at different ages, 264 standard cubes were designed to test its direct shear strength and cube compressive strength while considering the parameters of age and recycled aggregate replacement ratio. The failure pattern and load–displacement curve of specimens at direct shearing were obtained; the direct shear strength and residual shear strength were extracted from the load–displacement curves. Experimental results indicate that the influence of the replacement ratio for the front and side cracks of RAC is insignificant, with the former being straight and the latter relatively convoluted. At the age of three days, the damaged interface between aggregate and mortar is almost completely responsible for concrete failure; in addition to the damage of coarse aggregates, aggregate failure is also an important factor in concrete failure at other ages. The load–displacement curve of RAC at direct shearing can be divided into elasticity, elastoplasticity, plasticity, and stabilization stages. The brittleness of concrete decreases with its age, which is reflected in the gradual shortening of the elastoplastic stage. At 28 days of age, the peak direct shear force increases with the replacement ratio, while the trend is opposite at ages of 3 days, 7 days, and 14 days, respectively. The residual strength of RAC decreases inversely to the replacement ratio, with the rate of decline growing over time. A two-parameter RAC direct shear strength calculation formula was established based on the analysis of age and replacement rate to peak shear force of RAC. The relationship between cube compressive strength and direct shear strength of recycled concrete at various ages was investigated.

Study on the Basic Mechanical Properties of Recycled Concrete Hollow Block Masonry

2013 ◽  
Vol 438-439 ◽  
pp. 749-755 ◽  
Author(s):  
Tong Hao ◽  
Dong Li
Keyword(s):  
Mechanical Properties ◽  
Shear Strength ◽  
Shear Behavior ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Test Results ◽  
Aggregate Concrete ◽  
Mortar Strength ◽  
Hollow Block

By the experimental studying on the basic mechanical properties of recycled concrete hollow block masonry, the compressive and shear behavior of recycled aggregate concrete hollow block masonry under different mortar strength were analyzed. Research indicated that the compressive and shear behavior of recycled aggregate concrete hollow block masonry was similar to that of ordinary concrete hollow block masonry. The normal formula was recommended to calculate the compressive strength of the masonry. The shear strength of the masonry was affected by the mortar strength. The shear strength calculation formula of recycled concrete hollow block masonry was proposed according to the formula of masonry design code. The calculating results were in good agreement with the test results.

Shear strength of interfaces in natural and in recycled aggregate concrete

2017 ◽  
Vol 44 (3) ◽  
pp. 212-222
Author(s):  
Shakeel Ahmad Waseem ◽  
Bhupinder Singh
Keyword(s):  
Shear Strength ◽  
Shear Plane ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Failure Envelope ◽  
Interface Shear ◽  
Aggregate Concrete ◽  
Normal Strength ◽  
Strength Models

Shear strength of interfaces in natural aggregate concrete and in recycled aggregate concrete has been investigated using initially uncracked push-off specimens by varying the following parameters: replacement level of the recycled aggregates (0%, 50%, and 100%), concrete grade (normal-strength and medium-strength), and clamping force on the shear plane. Development of truss action for resisting interface shear was indicated by the observed crack patterns in the tested specimens and a truss-based analysis recommended in the literature in combination with a simplified failure envelope for concrete subjected to biaxial stresses has been used for shear strength predictions of the tested specimens. The proposed methodology, which is considered to be more rational than the empirical shear strength models available in the literature was calibrated for both the concrete types and gave conservative and reasonably accurate shear strength predictions for selected experiments taken from the literature.

Shear strength of reinforced concrete beams with recycled aggregates

2019 ◽  
Vol 22 (8) ◽  
pp. 1938-1951 ◽  
Author(s):  
George Wardeh ◽  
Elhem Ghorbel
Keyword(s):  
Tensile Strength ◽  
Shear Strength ◽  
Strain Softening ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Opening Displacement ◽  
Aggregate Concrete ◽  
Natural Aggregate ◽  
Hinge Model

This article presents an experimental program on the shear behavior of beams without transversal reinforcement manufactured with natural aggregate concrete and 100% recycled aggregate concrete. The beams were tested under four-point bending for a shear span-to-depth ratio ( a/ d) equal to 1.5 and 3.0. The mechanical properties of two mixes were characterized in terms of compressive strength, splitting tensile strength, and elastic modulus. Three-point bending tests were performed on plain pre-notched samples in order to determine the fracture properties by an inverse analysis of experimental force–crack mouth opening displacement curves using the analytical nonlinear hinge model and a power law strain-softening relationship. The strain-softening law is described by two parameters being, respectively, the power n and the critical crack opening displacement wc. The experimental results show that, for the same class of compressive strength, tensile strength, fracture energy, and the shear strength of recycled aggregate concrete are lower than natural aggregate concrete. The decrease in the fracture energy and the shear strength is consistent with the decrease in the splitting tensile strength of the recycled aggregate concrete mixes compared to the natural aggregate concrete. Critical shear crack theory was adopted to model the shear behavior of beams tested with a/ d = 3.0. For an accurate evaluation of the deformation capacity of tested beams, the nonlinear hinge model for recycled concrete members was extended to recycled concrete sections. For deep beams ( a/ d = 1.5), the strut-and-tie model was used. Finally, comparisons of prediction models to a wide range of experimental data are presented.

scholarly journals SHEAR STRENGTH OF REINFORCED RECYCLED AGGREGATE CONCRETE BEAMS WITHOUT SHEAR REINFORCEMENTS

2016 ◽  
Vol 23 (1) ◽  
pp. 76-84 ◽  
Author(s):  
Hyun-Do YUN ◽  
Won-Chang CHOI
Keyword(s):  
Shear Strength ◽  
Concrete Beams ◽  
Construction Materials ◽  
American Concrete Institute ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Sustainable Construction ◽  
Shear Behaviour ◽  
Aggregate Concrete ◽  
Current Code

As the demand for sustainable construction materials has risen over recent years, researchers have conducted several studies to expand the practical application of recycled construction materials, such as recycled aggregate. The author’s previous research shows the potential application of recycled aggregate over a broad range of structural mem­ber types. This paper continues the earlier work and investigates the shear behaviour of reinforced recycled aggregate concrete beams without shear reinforcement using findings from the author’s previous research. The variables in the test program are replacement rate (0%, 30%, 60%, and 100%) of recycled aggregate and shear span-to-depth ratio (2.0, 2.5, 3.0, 4.0, and 5.0). This work compares the experimental results with results obtained using current code equations found in American Concrete Institute (ACI) 318 (2014) and equations proposed in the literature. This research has found that the current code equations can adequately predict the shear strength of recycled coarse aggregate concrete beams and possibly can be applied for the use of recycled aggregate in structural elements.

Sign in / Sign up

Export Citation Format

Share Document