New waste heat district heating system with combined heat and power based on absorption heat exchange cycle in China

2012 ◽  
Vol 37 ◽  
pp. 136-144 ◽  
Author(s):  
Fangtian Sun ◽  
Lin Fu ◽  
Shigang Zhang ◽  
Jian Sun
Author(s):  
Fangtian Sun ◽  
Lin Fu ◽  
Shigang Zhang

Space heating area of district heating system of combined heat and power (CHP) accounts for approximately one third of total space heating area in Chinese northern cities. In the extraction condensing turbine combined heat and power system based on district heating network, there are a large number of low-grade waste heat in the condenser, and exergy loss in the steam-water heat exchanger and water-water heat exchanger. Based on absorption heat pump technology, a new high-temperature district heating technology (DHSAHP) was presented to improve the current district heating system of CHP. Absorption heat pumps are used to recycle low-temperature waste heat in condenser. Absorption heat pump type heat exchanger is used to reduce temperature of return water in primary heat network, and decrease irreversible loss. Where, DHSAHP was analyzed by thermodynamics and economics method, and evaluated by exergetic efficiency, exergetic output cost, exergetic cost difference and exergoeconomic factor. Compared with current district heating system of CHP, DHSAHP can decrease about 31.3% steam consumption, increase about 75% transmission and distribution capacity of the primary heating network. The evaluation results show that the exergetic efficiency of new district heating system of CHP based on the absorption cycle technology is higher 10.41% than that of current district heating system of CHP, whereas its exergetic cost is lower 36.6¥/GJ than that of the conventional district heating system. With the increase of annual heating time, economy efficiency of new district heating system of CHP becomes better. The DHSAHP has higher energy utilization efficiency and better economic benefits and provides a kind of better technological method to solve the main problems of cuurent district heating with CHP in China.


2007 ◽  
Vol 27 (7) ◽  
pp. 1158-1164 ◽  
Author(s):  
Augustine N. Ajah ◽  
Anish C. Patil ◽  
Paulien M. Herder ◽  
Johan Grievink

2015 ◽  
Vol 70 ◽  
pp. 560-567 ◽  
Author(s):  
Mehmet Elci ◽  
Axel Oliva ◽  
Sebastian Herkel ◽  
Konstantin Klein ◽  
Alexander Ripka

2021 ◽  
Vol 246 ◽  
pp. 09003
Author(s):  
Haoran Li ◽  
Juan Hou ◽  
Yuemin Ding ◽  
Natasa Nord

Peak load has significant impacts on the economic and environmental performance of district heating systems. Future sustainable district heating systems will integrate thermal storages and renewables to shave their peak heat demand from traditional heat sources. This article analysed the techno-economic potential of implementing thermal storage for peak load shaving, especially for the district heating systems with waste heat recovery. A campus district heating system in Norway was chosen as the case study. The system takes advantage of the waste heat from the campus data centre. Currently, about 20% of the heating bill is paid for the peak load, and a mismatch between the available waste heat and heat demand was detected. The results showed that introducing water tank thermal storage brought significant effects on peak load shaving and waste heat recovery. Those effects saved up to 112 000 EUR heating bills annually, and the heating bill paid for the peak load could be reduced by 15%. Meanwhile, with the optimal sizing and operation, the payback period of the water tank could be decreased to 13 years. Findings from this study might help the heat users to evaluate the economic feasibility of introducing thermal storage.


Sign in / Sign up

Export Citation Format

Share Document