Rapid biomass estimation using optical stem density of willow (Salix spp.) grown in short rotation

2009 ◽  
Vol 33 (2) ◽  
pp. 174-179 ◽  
Author(s):  
J.A. Ens ◽  
R.E. Farrell ◽  
N. Bélanger
Atmosphere ◽  
2021 ◽  
Vol 12 (11) ◽  
pp. 1427
Author(s):  
Tomas Karlsson ◽  
Leif Klemedtsson ◽  
Riikka Rinnan ◽  
Thomas Holst

In Europe, willow (Salix spp.) trees have been used commercially since the 1980s at a large scale to produce renewable energy. While reducing fossil fuel needs, growing short rotation coppices (SRCs), such as poplar or willow, may have a high impact on local air quality as these species are known to produce high amounts of isoprene, which can lead to the production of tropospheric ozone (O3). Here, we present a long-term leaf-scale study of biogenic volatile organic compound (BVOC) emissions from a Swedish managed willow site with the aim of providing information on the seasonal variability in BVOC emissions during two growing seasons, 2015–2016. Total BVOC emissions during these two seasons were dominated by isoprene (>96% by mass) and the monoterpene (MT) ocimene. The average standardized (STD, temperature of 30 °C and photosynthetically active radiation of 1000 µmol m−2 s−1) emission rate for isoprene was 45.2 (±42.9, standard deviation (SD)) μg gdw−1 h−1. Isoprene varied through the season, mainly depending on the prevailing temperature and light, where the measured emissions peaked in July 2015 and August 2016. The average STD emission for MTs was 0.301 (±0.201) μg gdw−1 h−1 and the MT emissions decreased from spring to autumn. The average STD emission for sesquiterpenes (SQTs) was 0.103 (±0.249) μg gdw−1 h−1, where caryophyllene was the most abundant SQT. The measured emissions of SQTs peaked in August both in 2015 and 2016. Non-terpenoid compounds were grouped as other VOCs (0.751 ± 0.159 μg gdw−1 h−1), containing alkanes, aldehydes, ketones, and other compounds. Emissions from all the BVOC groups decreased towards the end of the growing season. The more sun-adapted leaves in the upper part of the plantation canopy emitted higher rates of isoprene, MTs, and SQTs compared with more shade-adapted leaves in the lower canopy. On the other hand, emissions of other VOCs were lower from the upper part of the canopy compared with the lower part. Light response curves showed that ocimene and α-farnesene increased with light but only for the sun-adapted leaves, since the shade-adapted leaves did not emit ocimene and α-farnesene. An infestation with Melampsora spp. likely induced high emissions of, e.g., hexanal and nonanal in August 2015. The results from this study imply that upscaling BVOC emissions with model approaches should account for seasonality and also include the canopy position of leaves as a parameter to allow for better estimates for the regional and global budgets of ecosystem emissions.


Mycorrhiza ◽  
2012 ◽  
Vol 22 (8) ◽  
pp. 603-613 ◽  
Author(s):  
Katarzyna Hrynkiewicz ◽  
Ylva K. Toljander ◽  
Christel Baum ◽  
Petra M. A. Fransson ◽  
Andy F. S. Taylor ◽  
...  

2020 ◽  
Vol 27 (2) ◽  
pp. 39-48
Author(s):  
K.R Butt ◽  
S.M Quigg

Hallside steelworks, South Lanarkshire, Scotland, employed thousands of people and constructed rails and ships for over a century, before this successful industry closed in the 1970s. The site,south-east of Glasgow, was then reclaimed from dereliction during the 1990s to produce biomass through Short Rotation Coppice (SRC) of willow trees (Salix spp.). On site, the contaminated soil was removed, and a rudimentary substrate created with a mixture of sewage sludge and colliery spoil, the latter moved from nearby tips to release land for housing. Trees were planted and earthworms (Annelida) added to potentially assist growth. Initially recognised as a flagship for reclamation, the site was then abandoned. In 2018, information was gathered on the development of soils and on earthworm communities. This was achieved by sampling across the 35 ha site below willow, other planted tree species and grassland. The results showed that reclaimed soils were very stony, compacted, resistant to water infiltration but relatively uncontaminated. Willow had grown, but coppicing had not occurred. Earthworm introduction was initially unsuccessful, but colonisation took place from adjacent unadulterated areas and 16 species from three ecological groups were recorded. Mean community density was 208 ± 18.1 earthworms m-2 with a mean mass of 71 ± 6.1 g m-2. Type of vegetation cover had a significant (P <0.05) effect on community density and biomass. The site is now used for recreation and is an effective greenspace close to Glasgow.


2013 ◽  
Vol 7 (1) ◽  
pp. 460-460 ◽  
Author(s):  
Jesse Caputo ◽  
Stephen B. Balogh ◽  
Timothy A. Volk ◽  
Leonard Johnson ◽  
Maureen Puettmann ◽  
...  

2017 ◽  
Vol 9 (2) ◽  
pp. 28-35
Author(s):  
H.B. Thapa

Biomass study of Acacia auriculiformis, Acacia catechu, Dalbergia sissoo, Eucalyptus camaldulensis and Eucalyptus tereticornis was conducted on a five and half years old 'Fuelwood Species Trial under Short Rotation' through destructive sampling at Tarahara, Sunsari District of Nepal. The lowest Furnival Index (FI) was the main criteria for selecting a model. Among the six models tested, the transformed model Ln W= a + b Ln DBH from a power equation W = a DBHb (W = weights of stem or branch or above-ground wood in kg, DBH= Diameter at breast height in cm) was selected. Selected prediction models of tree components and above-ground wood (green as well as oven dry), and their coefficient of determination (R2) values, regression constant and coefficient, correction factor, precision and bias percent of five species are presented. With the exclusion of branchwood models, R2 is higher in a range of 88.7% for oven dry stemwood of Acacia catechu to 99.3% for above-ground wood model of Dalbergia sissoo. However, R2 is less than 80% in branchwood (green and oven dry) of Acacia auriculiformis, Eucalyptus camaldulensis, and Eucalyptus tereticornis showing moderate relationship between branchwood and DBH. In the case of E. tereticornis, precision is more than 49% which leads to low reliability in biomass estimation resulting in true biomass deviation in a range of about 49.51% to 56.74%, so biomass model's could not be used for estimation of tree components and above-ground wood. Despite it, generally, precision percent of the selected models has been found less than 15%. Bias percent was found quite large for allometric branchwood model comparatively to stemwood and above-ground wood models. D. sissoo had less than 10 % bias. Bias percent was the highest (23.11%) for green branchwood of Acacia auriculiformis. Others had in a range of 0.5% for green aboveground wood model of D. sissoo to 18.4% for green and oven dry branchwood models of E. tereticornis.


2017 ◽  
Vol 391 ◽  
pp. 194-206 ◽  
Author(s):  
Nerea Oliveira ◽  
Roque Rodríguez-Soalleiro ◽  
María José Hernández ◽  
Isabel Cañellas ◽  
Hortensia Sixto ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document