The impact of the addition of Bi2Te3 nanoparticles on the structural and the magnetic properties of the Bi-2223 high-Tc superconductor

Author(s):  
M.S. Shalaby ◽  
Mai Hussein Hamed ◽  
N.M. Yousif ◽  
H.M. Hashem
1987 ◽  
Vol 64 (5) ◽  
pp. 707-710 ◽  
Author(s):  
X. Obradors ◽  
A. Labarta ◽  
J. Tejada ◽  
F. García-Alvarado ◽  
E. Morán ◽  
...  

1987 ◽  
Vol 63 (12) ◽  
pp. 1129-1133 ◽  
Author(s):  
Chin Lin ◽  
Guo Lu ◽  
Zun-Xiao Liu ◽  
Yun-Xi Sun ◽  
Jian Lan ◽  
...  

1987 ◽  
Vol 124 (8) ◽  
pp. 460-462 ◽  
Author(s):  
P. Przysu̵pski ◽  
M. Baran ◽  
J. Igalson ◽  
W. Dobrowolski ◽  
T. Skośkiewicz ◽  
...  

1993 ◽  
Vol 195 ◽  
pp. 619-622 ◽  
Author(s):  
S. Matas ◽  
V. Bunda ◽  
M. Cernik ◽  
A. Zentko ◽  
P. Diko ◽  
...  

Author(s):  
H.-J. Ou ◽  
J. M. Cowley

Using the dedicate VG-HB5 STEM microscope, the crystal structure of high Tc superconductor of YBa2Cu3O7-x has been studied via high resolution STEM (HRSTEM) imaging and nanobeam (∽3A) diffraction patterns. Figure 1(a) and 2(a) illustrate the HRSTEM image taken at 10' times magnification along [001] direction and [100] direction, respectively. In figure 1(a), a grain boundary with strong field contrast is seen between two crystal regions A and B. The grain boundary appears to be parallel to a (110) plane, although it is not possible to determine [100] and [001] axes as it is in other regions which contain twin planes [3]. Following the horizontal lattice lines, from left to right across the grain boundary, a lattice bending of ∽4° is noticed. Three extra lattice planes, indicated by arrows, were found to terminate at the grain boundary and form dislocations. It is believed that due to different chemical composition, such structure defects occur during crystal growth. No bending is observed along the vertical lattice lines.


Author(s):  
R. B. Marinenko

Internally oxidized Ag-Mg alloys are used as sheaths for high Tc superconductor wires because of their superior mechanical properties. The preparation and characteristics of these materials have been reported. Performance of the sheaths depends on the concentration of the magnesium which generally is less than 0.5 wt. percent. The purpose of this work was to determine whether electron probe microanalysis using energy dispersive spectrometry (EDS) could be used to quantitate three different Ag-Mg alloys. Quantitative EDS analysis can be difficult because the AgL escape peak occurs at the same energy (1.25 keV) as the Mg Kα peak. An EDS spectrum of a Ag-Mg alloy wire is compared to a pure Ag spectrum in Fig. 1.


1987 ◽  
Vol 48 (10) ◽  
pp. 1623-1625 ◽  
Author(s):  
B. Farnoux ◽  
R. Kahn ◽  
A. Brulet ◽  
G. Collin ◽  
J.P. Pouget

2017 ◽  
Vol 83 (10) ◽  
pp. 31-35
Author(s):  
V. V. Gubernatorov ◽  
◽  
T. S. Sycheva ◽  
S. A. Ol’kov ◽  
◽  
...  

2006 ◽  
Author(s):  
In-Gann Chen ◽  
Maw-Kuen Wu ◽  
Shih-Yun Chen

Sign in / Sign up

Export Citation Format

Share Document