An efficient solar-aided waste heat recovery system based on steam ejector and WTA pre-drying in solar/lignite hybrid power plants

Energy ◽  
2020 ◽  
Vol 208 ◽  
pp. 118372 ◽  
Author(s):  
Yu Han ◽  
Yingying Sun ◽  
Junjie Wu
Author(s):  
Ruiqiang Sun ◽  
Kaixuang Yang ◽  
Ming Liu ◽  
Junjie Yan

Abstract The temperature of SCO2 fed to the boiler in SCO2 coal-fired power plants is relatively high, ∼500 °C. It leads to high boiler exhaust temperature, which is ∼120 °C according to previous studies. Waste heat recovery from low temperature fluegas in SCO2 coal-fired power plants is a key issue to be addressed to enhance power plant efficiency and electrostatic precipitator performance. Therefore, systems of waste heat recovery from low-temperature fluegas were proposed in this study. To evaluate the economic performances of the proposed systems and obtain the best system configurations, economic and thermodynamic models were developed. Moreover, multi-parameter optimization model based on Genetic Algorithm was developed. The waste heat recovery system is proposed and optimized by considering coupling and matching of the air preheating process, heat regenerative process and fluegas cooling process. With a 1000MW SCO2 coal-fired power plant as the reference case, thermodynamic and economic analyses were carried out. Results show that when the low temperature economizer is integrated together with the main compressor intercooling and flue bypass ahead the air-preheater, the temperature of exhaust fluegas can be decreased to ∼95 °C and the power plant efficiency can be enhanced by 1.39%-pts compared with basic system. Through the economic model analysis, the system levelized cost of electricity is 0.04158 $ kW−1 h−1.


2014 ◽  
Vol 67 (1-2) ◽  
pp. 240-249 ◽  
Author(s):  
Gang Xu ◽  
Cheng Xu ◽  
Yongping Yang ◽  
Yaxiong Fang ◽  
Yuanyuan Li ◽  
...  

2019 ◽  
Vol 14 (1) ◽  
Author(s):  
Gunabal S

Waste heat recovery systems are used to recover the waste heat in all possible ways. It saves the energy and reduces the man power and materials. Heat pipes have the ability to improve the effectiveness of waste heat recovery system. The present investigation focuses to recover the heat from Heating, Ventilation, and Air Condition system (HVAC) with two different working fluids refrigerant(R410a) and nano refrigerant (R410a+Al2O3). Design of experiment was employed, to fix the number of trials. Fresh air temperature, flow rate of air, filling ratio and volume of nano particles are considered as factors. The effectiveness is considered as response. The results were analyzed using Response Surface Methodology


2021 ◽  
Vol 234 ◽  
pp. 113947
Author(s):  
Alexandre Persuhn Morawski ◽  
Leonardo Rodrigues de Araújo ◽  
Manuel Salazar Schiaffino ◽  
Renan Cristofori de Oliveira ◽  
André Chun ◽  
...  

2012 ◽  
Vol 204-208 ◽  
pp. 4229-4233 ◽  
Author(s):  
Fang Tian Sun ◽  
Na Wang ◽  
Yun Ze Fan ◽  
De Ying Li

Drain water at 35°C was directly discharged into sewer in most of barbershop with Electric water heater. Heat utilization efficiency is lower, and energy grade match between input and output is not appropriate in most of barbershops. Two waste heat recovery systems were presented according to the heat utilization characteristics of barbershops and principle of cascade utilization of energy. One was the waste heat recovery system by water-to-water heat exchanger (WHR-HE), and the other is the waste heat recovery system by water-to-water heat exchanger and high-temperature heat pump (WHR-CHEHP). The two heat recovery systems were analyzed by the first and second Laws of thermodynamic. The analyzed results show that the energy consumption can be reduced about 75% for HR-HE, and about 98% for WHR-CHEHP. Both WHR-HE and WHR-CHEHP are with better energy-saving effect and economic benefits.


Author(s):  
Salman Abdu ◽  
Song Zhou ◽  
Malachy Orji

Highly increased fuel prices and the need for greenhouse emissions reduction from diesel engines used in marine engines in compliance with International Maritime Organization (IMO) on the strict regulations and guidelines for the Energy Efficiency Design Index (EEDI) make diesel engine exhaust gas heat recovery technologies attractive. The recovery and utilization of waste heat not only conserves fuel, but also reduces the amount of waste heat and greenhouse gases dumped to the environment .The present paper deals with the use of exergy as an efficient tool to measure the quantity and quality of energy extracted from waste heat exhaust gases in a marine diesel engine. This analysis is utilized to identify the sources of losses in useful energy within the components of the system for three different configurations of waste heat recovery system considered. The second law efficiency and the exergy destroyed of the components are investigated to show the performance of the system in order to select the most efficient waste heat recovery system. The effects of ambient temperature are also investigated in order to see how the system performance changes with the change of ambient temperature. The results of the analysis show that in all of the three different cases the boiler is the main source of exergy destruction and the site of dominant irreversibility in the whole system it accounts alone for (31-52%) of losses in the system followed by steam turbine and gas turbine each accounting for 13.5-27.5% and 5.5-15% respectively. Case 1 waste heat recovery system has the highest exergetic efficiency and case 3 has the least exergetic efficiency.


Sign in / Sign up

Export Citation Format

Share Document